查询词典 complex surface

This model was finely fitted by theexperimental results and was used to calculate the activation area,which was 0.127 〓/mol with little dependence of subphasetemperature. The positive activation area indicate that there is anincrease in area when the activated complex is formed, increasingthe surface pressure should decrease the rate constant and that theactivated complex is unimolecular in nature.

在一系列实验曲线的基础上，我们提出测量的面积变化应该由聚合中分子结构变化引起的急剧的瞬时面积变化与随后的与此面积变化相反的弛豫过程两部分组成，并据此提出一种反应动力学模型，此模型与实验结果相当吻合，此模型用于处理聚合速率的紫外光强依赖性，得到聚合速率常数近似与光强成二次幂指数关系；此模型也被用于计算活化面积，发现活化面积为〓，几乎与温度无关。

In this paper, a complex mapping function is devised to transform the contour surface of an arc crack to a unit circle on the auxiliary plane. By substituting the mapping function into it governing boundary equation, the complex stress functions can be obtained as

本文之研究方法乃是首先设计一复变函数，将原有弧形裂纹之几何形状映像至辅助平面成为一单位圆，然后再以此映像函数代入相关之边界方程式中。

We conclude that the urinary bladder ECM but not the small intestine- or lier-deried ECM contains a surface with composition and morphology consistent with that of an intact basement membrane complex, that the basement membrane complex can surie processing, and that the basement membrane structure can modulate in itro cell growth patterns.

我们得到的结论是，膀胱来源的ECM含有一层组成和形貌都与完整基底膜复合物一致的表面结构，而小肠和肝来源的ECM没有这层结构；基底膜复合物结构能够在ECM整个加工过程中保证完整而且能调节体外细胞生长模式。文献摘要申领

Traditional field seismic data acquisition designing method is not suitable for complex mountainous surface and complex underground structural areas.

传统的野外地震数据采集设计方法已无法适应复杂山地地表和复杂地下构造地区。

Results of analysis show that Generalized Paris Law can consider the complex crack propagation in the material of the pavement structure. The fatigue life of the pavement increases with increasing thickness of surface layer in a power function. Use of a thicker surface layer may extend the service life of the asphalt pavement. The fatigue life increases with decreasing modulus of surface layer in a power function with a negative exponent. However, since reduced modulus would scarify the structural strength and might cause rutting-related distress, caution should be taken when using low modulus materials for improving fatigue performance of asphalt pavements. The fatigue life increases with increasing modulus of base material in a power function. However, the fatigue life can not infinitely increases with increasing modulus of the base.

计算与分析表明：广义Paris公式可以考虑沥青路面结构内材料复杂的裂缝扩展：沥青面层的疲劳寿命随着面层厚度的增加以幂函数的形式增加，适当增加沥青面层厚度可以提高路面的使用寿命；沥青面层的疲劳寿命随着面层材料模量的降低以负指数的幂函数形式增加；由于材料模量的降低将牺牲路面的整体强度并可能引起路面车辙类损坏，以此提高疲劳寿命的方法应慎重对待；沥青面层的疲劳寿命随着基层材料模量的增加呈幂函数的形式增加，但由疲劳方程可以看出，寿命并不是随基层材料模量的增加而无限的增加，疲劳曲线在经过一个上升段后，逐渐趋于一个常数值，这说明，这时基层模量对寿命已不作关键性贡献；随着底基层厚度的增加，面层的疲劳寿命近似地呈线性函数增加，但效果并不很明显。

The thickness of the ice cover on the wall surface heat transfer is greater than the thickness of it on the air heat transfer form. The thickness of the ice cover on the wall surface heat transfer along the way changes slowly, but it on the air heat transfer along the way changes significantly. Reducing the entrance velocity, lowering the wall surface or air temperature, the formation of the thickness of the ice cover will increase; in the 3D circumstances, The thickness of the ice cover was relatively uniform in the import of the U-turn model, the ice cover was gradual accumulation in the convex bank when the stream traversed the import of the U-turn model, the thickness of the ice cover in the convex bank was significantly bigger than the thickness in the concave bank. The temperature field under the ice cover tends to be complex because of the existence of the secondary flows. The temperature in the convex bank is greater than it in the concave bank. Compared with the data from experiments, the laws in the numerical simulation are similar with them in the experiments

模拟结果显示：二维情况下，运用壁面传热形成的冰盖厚度大于运用空气传热形成的冰盖厚度，壁面传热形成的冰盖厚度沿程变化缓慢，而空气传热形成的冰盖厚度沿程变化明显，减小入口流速，降低壁面或空气温度等，形成冰盖的厚度都会增大；三维情况下，弯道入口处凸、凹岸形成的冰盖厚度基本相同，进入弯道后，凸岸形成的冰盖厚度逐渐增大，而凹岸的冰盖厚度逐渐减小，受横向环流的影响，冰盖下水流的温度场趋向复杂，并且凸岸的温度小于凹岸的温度；与实验室实验所得数据相比较，数值模拟研究得到的规律基本符合实验规律。

For the complex road situation,Shanghai Municipal Engineering Institute linked the actual cases of tunnel,the common road surface concrete construction process was changed,to make road surface concrete leverl degree,rough degree and strength as well as wearproof all reached to the requirements of emergency repair,and finished 2,800m2 road surface repair work.

针对复杂路况，上海市市政工程研究所结合隧道的实际情况，改变一般路面混凝土的施工工艺，使路面混凝土的平整度、精糙度、强度及耐磨性均达到了应急抢修的要求，完成了2800平方米的路面抢修任务。

To resolve this behavior, only the surface business card printing and membership card making to set to print in ink that is not on the surface without worrying about the colour, there are three ways: the first one is a drumlike complex members'meeting, Bopp/business card printing and membership card making/PE, such a structure you need to have special line cost more per bag fee in order to achieve $ 0.10/only, the second film structure is the PE/business card printing and membership card making/PE, such a structure common packaging equipment can also be filling, but cost more, each bag shall be $/only 0.08, the third option is the-tape-PE/business card printing and membership card making/PE structure in the original film, that is, the members'meeting membrane business card printing and membership card upon completion of the making of the operation, the business card printing and membership card making surface salivate a layer of transparent with thin-film, this is our company according to actual usage of the product structure specially developed.

给彻底处置这一不隐象，只有不兵暗地制卡和会员卡制作改不败边印，油不朱不在暗地也不离供给安心掉色，办法有不一栽：第一栽是复不合奶膜布局为BOPP边/制卡和会员卡制作/PE边，这样的布局需有附带灌装摆设，不败本也较矮，每一个袋子用度给到达0.10元/只把握），第二栽膜的布局是PE/制卡和会员卡制作/PE，这样的布局别致灌装摆设也可灌装，但不败本还是较矮，每袋须0.08元/只把握，第不一栽办法是流延PE/制卡和会员卡制作/PE布局不厚膜，即在原奶膜制卡和会员卡制作完不败后，再增增一道工序，在制卡和会员卡制作背流涎一层透明的较不厚的不厚膜，这是我们公司根据客户本质搁置环境出格开不收的产物布局。

Under the influence of the sunlight and with the help of its strong oxidization capacity, the photo-catalyst can oxidize nearly all the organic matters on the surface into H 2 O and the corresponding nontoxic inorganic materials. At the same time, under the combined actions of the characteristic nanometer structure of its surface, the hydroscopic properties of the complex additives and the light-induced amphiphilic properties (hydrophilicity and lipophilicity) of Ti02 itself the surface of the glass is made superhydrophilic, so that it becomes easily washable, anti-fog and not vulnerable to recontamination to keep the glass clean and transparent. And it also has such functions as sanitization, sterilization, foreign odor elimination and air refreshing.

在阳光的作用下，光催化剂以其特有的强氧化能力，可将其表面的几乎所有有机物完全氧化为H 20及相应的无害无机物，同时在其表面特有的纳米结构、复合添加剂的吸水性和Ti02本身的光致两亲性的共同作用下使玻璃表面具有超亲水性，变得易清洗、防雾和不易被再污染而保持洁净透明，同时具有消毒、杀菌、消除异味、清新空气等功能。

For the floating body with complex bow and stern, the molded line reconstruction method is adopted to generate the section lines on the bow and on the stern which are necessary to construct the wetted surface, and it can raise efficiency greatly that the intersection lines of intersection structures are obtained by the way of combining modeling tool and NURBS technology; then the patch representation method is adopted in generating the mesh of wetted surface and interior free surface, and the velocity potentials on them are expressed separately, on basis of which the irregular frequency effect is dealt with in the calculation of hydrodynamic coefficients.

对于有复杂首尾结构的浮体，用型线重构的方式在首尾生成曲面构成所需要的截面线，将通用建模工具和NURBS曲线拟合相结合，生成相贯结构的相交线；然后，用分片法生成浮体湿表面及内自由面网格，并独立表达各自的速度势以处理不规则频率现象，进而进行水动力系数计算。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐