查询词典 complex experiment

In this work, the interaction between umbelliferone and bovine serum albumin was studied by performing two different kinds of titration modes. The two spectroscopic data matrices were augmented, and then the information of experiment data was increased. The augmented experiment data matrix was analyzed by the MCR-ALS method. This procedure allowed the recovery of the concentration profiles for each species and the calculation of the ∶ ratio in the complex and the apparent equilibrium constant.

采用两种不同的试剂滴加模式对伞形花内酯与BSA的相互作用进行研究，对经典的荧光光谱数据矩阵加以扩展，增加了实验数据的信息量；进而应用MCR-ALS对该扩展的荧光光谱矩阵进行迭代计算，较好地分辨出作用过程中浓度变化趋势图，并计算出伞形花内酯与BSA的表观结合常数和结合比。

I think that cause the phenomena is complex conditions and factors of experiment more than pot experiment.

在苗期其适宜含水率为（55～65％）θ〓，现蕾期的灌水量则制约作物的生长，其适宜含水率为（65～75％）θ〓。

In this article,the analysis of the complex principle and the experiment that has been done are described,The influence of complex on noise elimination has been confirmed by the examples.

研究了复合结构的原理及实验，通过实例说明复合结构对消声的影响。

The thesis also draw several conclusions as follows:(1) Orthogonal experiment design method can be viewed as a special case of genetic algorithm, i. e. a genetic algorithm with a fixed initial population, an oriented-mutation operator and one evolution epoch.(2) In terms of running steps, genetic algorithm is more complex than orthogonal experiment design method.

论文首次对正交试验设计法和遗传算法这两种独立发展起来的方法进行比较研究，提出(1)正交试验设计法是遗传算法的一种特例，即是一种初始种群固定的、只使用定向变异算子的、只进化一代的遗传算法；(2)遗传算法产生的优化解优于正交试验设计法产生的优化解，且遗传算法处理交互作用项的效率高于正交试验设计法；(3)遗传算法的步骤比正交试验设计法复杂，所需的试验次数也要多。

This article that focuses on the systematic and in-depth research in the current primal problem about abnormal burst pressure reservoir depress burst pressure has procured following main fruits:1 It forms the method which could obtain massive vertical static state mechanics parameters.2 In a foundation of acquisition of rock mechanics parameters,apply bent lamella that as mechanical model along with characteristic of actual geologic characteristics to analysis curvature for anticlinal strcture, get homologous tectonic stress value throug relation between the curvature and stress and different principal curvature in anticlinal structure,consequently set up laminational stress model for anticline reservoir. The block lamination for existed fracturing date has formed method of setting up mechanical model of lamination terrestrial stress by abtaining the block tectonic stress coefficients which are got by complex utilization test, laboratory test and fracturing date playback.3 Analysesing the main reason which lead to high burst pressure by considering the characteristic of reservoir geology,reservoir,and rock mechanics and reservoir damage,etc.Establishing burst pressure quantitative prediction model which provide gist for depressing construction risk and optimizing construction craft under the condition of open hole completion ,gun-perforated completion and damaged reservoir.4 Provding theoretical basis for interpreting acidification pretreatment which could depress busrt pressure by finding the relation between the influencing factors and rock machanics parameters and analysing the factors that have effect on rock mechanics parameters. Expounding the mechanism of reaction of mixed monomineral and acid from the angle of microcosmic element, evaluating quantitatively acid sensilility of different kinds of mineral effectively, and determing the first-order reaction dynamical equation of each mineral.5 Revealing rock mechanics property chage as a result of acid flooding in different condition by sandstone traumata experiment in different temperatures which combined with rock mechanics triaxial stress experiment.6 Associating damage mechanics with sandstone acidizing, established sandstone damage mechanics model in the foundation of the recognition on the rock mechanics parametric variation which is caused by acid-rock reaction in both macroscopic view and microscopic view ,also demonstrated those processes and quantitative estimated the acid busrt pressure to direct the site operation.

本文针对目前异常破裂压力储层降低破裂压力的主要问题展开较为系统和深入的研究，取得了以下主要成果：1形成了利用测井资料，结合室内岩芯测试结果，获取静动岩石力学参数的相关性特征，从而获得纵向上大量静态力学参数的方法。2在获取了岩石力学参数的此基础上，利用弯曲薄板作为力学模型，结合区块实际地质特征对背斜构造进行曲率分析，通过曲率与应力的关系，利用背斜构造不同部位的主曲率求得相应的构造应力值，从而建立起背斜储层的分层应力模型；对已有压裂资料的区块分层，形成了综合利用测试、室内实验、压裂资料反演获得该区块构造应力系数，建立起分层地应力的力学模型的方法。3综合考虑储层地质、油藏、岩石力学特性和储层伤害等因素，分析造成高破裂压力的主要原因，综合利用岩石力学、弹性力学等知识，建立了裸眼完井、射孔完井条件下以及储层受到伤害后的储层破裂压力定量预测模型，为降低施工风险和优化施工工艺提供了依据。4完成了物性、岩性影响岩石力学参数的因素分析，找出了各影响因素和岩石力学参数之间的关系，为从机理上解释酸化预处理降低破裂压力提供了理论基础；从微观元素的角度阐述了单矿物与酸反应的机理；并在此基础上，有效评价了各种矿物的酸敏感性，定量确定了岩石中各矿物的一级反应动力学方程。5完成了不同温度下的酸液类型、酸液浓度、注酸量等一系列砂岩损伤实验，结合岩石力学三轴应力实验，系统揭示了在不同条件下注酸而引起的岩石力学性质变化。6将损伤力学与砂岩酸化相结合，在宏观、微观两个方面认识酸岩反应引起岩石力学参数变化基础上，建立了砂岩损伤力学模型，并对其进行验证，在此基础上定量计算酸化后的破裂压力，有效指导现场施工

Detailed work have done at four aspects as follows: the usage of SPIV in multistage turbomachinery; the study of compressor rotor tip complex flow with SPIV; the study of compressor stator tip complex flow with Rotor/Stator interaction and the detailed analysis and comparison of the unsteady flow field respectively obtained by CFD and experiment investigation.

详细本文主要以SPIV非定常实验测量和CFD非定常数值模拟为工具，研究叶轮机端壁复杂流动的一些机理性问题，围绕四个方面开展了叶轮机端壁非定常流动方面的研究工作：适用于多级叶轮机械使用的SPIV技术；压气机转子尖区复杂流动；动静叶干扰条件下压气机静子内尖区非定常流动；以及非定常数值模拟结果与非定常实验测量结果的对比。

Methods: The inclusion complex of astaxanthin-hydroxypropyl-β-cyclodextrin was studied by Ultr-aviolet Spectroscopy in aqueous solution and prepared by trituration. The formation of the complex was confirmed by IR spectroscopy. The accelerative experiment of stability of the complex was carried out at 60℃, 5000 lux.

利用紫外光谱法研究水溶液中虾青素和羟丙基－β-环糊精的包合作用；采用研磨法制备虾青素－羟丙基－β-环糊精包合物，并用红外光谱法验证包合物的形成；于60℃，5 000 lux条件下对包合物进行了稳定性加速实验。

Due to very Complex geological structure in metallic ore areas, seismic method in base-ore metal exploration is a complicated question and this paper discusses the experiment and application effects of detecting hidden ultrabasic body and ore control structure with seismic method in deep coverage area combined with the experiment of jinchang Copper-Nickel polymetallic Deposit in Gansu province.

这里结合在甘肃金昌铜镍多金属矿区的试验研究，讨论了地震方法技术在厚覆盖区探测隐伏超基性岩体和控矿构造的试验应用效果。

Results: lResult of TLC: the granules compositions stability by TLC is stable and there is not any difference between the experiment result and stability control standard. 2Result of quantity control① Stress test make it certain that this granules ingredients have certain moisture stability, photo stability and temperature stability, this experiment also indicate that the medical using complex bag can improve the granules moisture stability.

结果：1、定性指标结果：在以上稳定性试验中，不同时间各定性鉴别指标TLC结果与0天TLC结果无差别。2、定量指标结果：①影响因素试验：该颗粒剂对湿度、光线、温度都具一定稳定性，药用复合膜包装能提高该制剂吸湿稳定性。

Though geological structures in metallic ore areas are very complex and seismic method for ore exploration is still in experiment phase, potential of the method in the future ore exploration can be found from primary experiment effects of seismic method, as the method possesses larger prospecting depth and less ambiguity as well as higher precision to distinguish underground target.

尽管金属矿区的地质构造十分复杂，金属矿勘查中的地震方法技术还处于试验应用研究阶段，但由于该方法探测深度大、多解性少、分辨地下目标物的精度高，从该方法的初步试验效果就能看出地震方法在今后金属矿勘查中的潜力。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。