查询词典 complete circuit

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state, then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module%26rsquo;s software and hardware which is based on CAN bus of signal lamp%26rsquo;s stimulant state, then the hardware%26rsquo;s circuit of the entire system%26rsquo;s censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

After this text introduced and will imitate the audio frequency signal processing as numerical signal after red shoot outside, the numerical signal that will receive again solution adjust after the audio frequency power enlarger enlarge restore in order to imitate the speech signal, shot the electric circuit outside analyzed to design the audio frequency signal before collecting the electric circuit, signal placed the big electric circuit, frequency to make the electric circuit, red, red circumscribed to accept the electric circuit,, frequency the solution adjusted the electric circuit and audio frequencies to enlarge the electric circuit etc.

本文介绍了将模拟音频信号处理为数字信号后经红外发射，再将接收到的数字信号解调后经音频功率放大器放大后还原为模拟语音信号，在分析设计了音频信号采集电路、信号前置放大电路、频率调制电路、红外发射电路、红外接收电路、、频率解调电路以及音频放大电路等各组成部分。

Armour rods (to be installed in suspension clamps) Parallel clamps Sub-Total, items 4.1-4.7 OTHER HARDWARE Counterweights for jumper or suspension insulator strings, including necessary device for attachement 50 kg 100 kg Sub-total, item 5.1 – 5.3 SPARES Insulator Units Type U160 Type U210BS Hardware for Conductor ACSR-BISON Complete set of hardware and fittings for suspension string Complete set of hardware and fittings for tension string Complete set of hardware and fittings for jumper string Complete set of hardware and fittings for transposition string Extra suspension clamps Extra tension clamps Extra tension joints Extra repair sleeves Extra vibration dampers Extra armour rods Extra spacers: for span for jumper alternatively spacer dampers Hardware for Earthwire 7 No. 6 AWG Complete suspension set Complete tension set Vibration dampers, Stockbridge type Extra tension clamps Extra tension joints Extra vibration dampers Extra parallel clamps Extra armour rods Hardware for Earthwire 7 No. 6 AWG Complete suspension set Complete tension set Vibration dampers, Stockbridge type Extra tension clamps Extra tension joints Extra vibration dampers Extra parallel clamps Extra armour rods Sub-Total, items 6.1-6.4 Sub-total, Items 1.4, 2.7, 3.8, 4.8, 5.4 and 6.5 Transfer to Summary, Schedule AS-1

装甲棒 平行夹具小计，项目4月1号至4月7号其他硬件重物跳线或中止绝缘子串，包括必要的设备attachement 50公斤 100公斤小计，项目5月1号至5月3号备件绝缘子单位型U160 类型U210BS 硬件导体钢芯铝绞线，拜森一套完整的硬件和配件的暂停字符串一套完整的硬件和配件的紧张字符串一套完整的硬件和配件的跳投字符串一套完整的硬件和配件的转字符串额外的悬浮夹额外的紧张局势夹额外的紧张关节额外的修理袖子额外的振动阻尼器额外的装甲棒额外的间隔：为跨度跳线或者间隔减震器硬件Earthwire 7特设工作组第6号完整的悬挂设定一套完整的紧张局势振动阻尼器，斯托克型额外的紧张局势夹额外的紧张关节额外的振动阻尼器额外的平行夹具额外的装甲棒硬件Earthwire 7特设工作组第6号完整的悬挂设定一套完整的紧张局势振动阻尼器，斯托克型额外的紧张局势夹额外的紧张关节额外的振动阻尼器额外的平行夹具额外的装甲棒小计，项目6月1号至6月4号小计，项目1.4 ， 2.7 ， 3.8 ， 4.8 ， 5.4和6.5 （换乘摘要，附表1 仅供参考

It simulates the circuit breaker with a zero impedance branch, and adopts the linear network characteristic and theory, variable structure and variable parameter analyses to transfer the short-circuit current flow in the bus-bar equality into each side of circuit breaker, and deduces the sequence component model and algorithm for calculating the short-circuit current of circuit breaker when the short-circuit fault occu...

该方法将断路器作为一条阻抗为零的支路来模拟，运用线性网络特性、定理及变结构与变参数的分析方法，将母线上短路时的短路电流等值转移到断路器两侧，导出了相当于在断路器两侧分别发生短路故障时，流过断路器的短路电流的序分量模型和算法。

With this mode of working the base-emitter circuit is the input side;and the emitter through base to collector circuit the output side.although these have a common path through base and emitter, the two circuit are effectively separated by the fast that as far as polarity of the base circuit is concerned,the base and upper half of the transistor are connected as a reverse biased diode.hence there is no current flow from the base circuit into the collector circuit.

这一工作模式下，基极-发射极电路是输入端，发射极通过基极，再到集电极电路的输出端。虽然它们都有一个共同的路径通过基极和发射极，这两个电路是通过和基极电路相关的尽可能的有效快速分离开的，基极和基极以上的一半以上的晶体管作为一个反偏二极管与之相连接。

Thereinto,the measuring circuit is composed of heating circuit, voltage follower circuit, warning circuit, gas sensor failure indication circuit and power supply indication circuit;The microprocessor adopts 8051 Single - Chip computer;The LED adopts Seven LED figures display;The keyboard adopts separate type non-coding keyboard.

其中测量电路由加热电路、电压输出电路、报警电路、气敏元件损坏指示电路和电源指示电路组成；微处理器采用8051单片机；LED显示采用七段LED数码显示器；键盘采用的是独立式非编码键盘。

To solve the problems of the limescale ,the oxidation which are produced by the direct contact between a metallic conductor and water, the detecting reliability and the service life, the utility model adopts the technical proposal as below: the proposal comprises a monostable controllable trigger, a second low-pass filter, a voltage follower and a display circuit, the power circuit links with the monostable controllable trigger, the second low-pass filter, the display circuit and a timebse pulse circuit separately, the utility model is characterized in that the monostable controllable trigger, the second low-pass filter and the display circuit sequentially links, the monstable controllable trigger separately links with a water lever sensor and the timebase pulse circuit.

为了解决金属导体与水直接接触会产生水垢和氧化，影响检测可靠性和使用寿命的问题，本实用新型采用了以下技术解决方案：它包括单稳可控触发器，二阶低通滤波器，电压跟随器和显示电路，电源电路分别与单稳触发器，二阶低通滤波器，显示电路和时基脉冲电路相接，其特征在于单稳可控触发器，二阶低通滤波器，电压跟随器和显示电路依次相接，单稳可控触发器分别与水位传感器和时基脉冲电路相接。

To solve the problems of the limescale ,the oxidation which are produced by the direct contact between a metallic conductor and water, the detectingreliability and the service life, the utility model adopts the technical proposal as below: the proposal comprises a monostable controllable trigger, a second low-pass filter, a voltage follower and a display circuit, the power circuit links with the monostable controllable trigger, the second low-passfilter, the display circuit and a timebse pulse circuit separately, the utility model is characterized in that the monostable controllable trigger, the second low-pass filter and the display circuit sequentially links, the monstable controllable trigger separately links with a water lever sensor and thetimebase pulse circuit.

为了解决金属导体与水直接接触会产生水垢和氧化、影响检测可靠性和使用寿命的问题，本实用新型采用了以下技术解决方案：它包括单稳可控触发器、二阶低通滤波器、电压跟随器和显示电路，电源电路分别与单稳触发器、二阶低通滤波器、显示电路和时基脉冲电路相接，其特征在于单稳可控触发器、二阶低通滤波器、电压跟随器和显示电路依次相接，单稳可控触发器分别与水位传感器和时基脉冲电路相接。

The high-power system including main circuit, the charging and discharging circuit of synthetic circuit test system, and the principle of charging and discharging for current supply using electrolytic capacitor is presented. At the aspect of circuit breaker control, the advanced permanent magnetic actuator is used and analyzed in this paper, including the precision computation and using in synthetic circuit. The trigger circuit of voltage supply is designed, and the intelligent control is used to trigger the igniting gap. And the integraph based Rogowski coil is designed and employed the intelligent detection of breaking current.

强电系统介绍了合成回路试验系统的主电路及其充放电电路，讲述了电流源采用电解电容器的充放电原理；断路器控制方面，采用当前比较先进的永磁操动机构，并对永磁机构的原理、精度计算和在合成回路中的应用做了详细地分析；设计并制作了电压源点火回路，对球隙点火进行智能控制；在智能检测开断电流方面，设计并制作了与Rogowski线圈相配合的积分器。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。