查询词典 complementarity

The algorithm has following properties: Although the merit function has the form of least squares of a system of overdetermined equations, in the Newton equation of our algorithm, only the coefficient matrix of the system of overdetermined equations is used instead of its product as in Guass-Newton method for solving the least squares problems. That is, our Newton method is more like that for the system of nonlinear equations rather than that for LSPs. The global convergence is obtained for VLCP with vertical block P_0 + R_0 matrix; The local quadratic convergence rate is proved under the condition that the solution is BD-regular; Although there is only a Newton equation in our algorithm, the finite convergence property can be shown if matrix is vertical block P— matrix (without the hypotheses of strict complementarity).

该算法具有下列特点：所构造的价值函数虽然具有超定方程组的最小二乘问题的形式，但在基此建立的Newton算法中，其Newton方程的形式更象非线性方程组的Newton法中的Newton方程，仅利用了超定方程组的系数矩阵本身的信息，避免了一般最小二乘问题的Guass-Newton法中必须计算系数矩阵的乘积的工作量；对竖块P_0+R_0矩阵的垂直线性互补问题，算法具有全局收敛性；在解是BD-正则条件下，证明了算法的局部二次收敛性；虽然算法只含一个Newton方程，但对竖块P-矩阵垂直线性互补问题，算法具有有限步收敛性。

The discretized frictional contact problems can be reduced as a linear complementarity problem using parametric variational principle and parametric quadratic programming method. Then we can apply the algorithms proposed in this thesis to the solution of the contact problems.

利用参变量变分原理和参数二次规划法，离散后的接触问题可化为线性互补问题，之后，将第二、三章提出的互补问题算法应用到接触问题的数值求解中。

In Chapter 5, we study three dimensional elasto-plastic frictional contact problems with orthotropic friction law. Parametric variational principle and parametric quadratic programming method are applied to analyze this class of complicated mechanics problems. A linear complementarity problem formulation is derived.

在第五章，我们采用正交各向异性摩擦定律模型对三维弹塑性摩擦接触问题进行分析，将正交各向异性的摩擦定律线性化后，将参变量变分原理和参数二次规划法应用到这一复杂的力学问题中来，最终将问题化为线性互补问题模型。

In this experiment, we screen the major protective antigen gene-SOD gene of M. paratuberculosisin order to study the sensitive, specific diagnostic reagent and prophylaxis preparation, especially theDNA vaccine. The SOD gene was amplified from Mycobacterium paratuberculosis C-2 chromosomalDNA by using the PCR technique and cloned into pMD18-T Vector System. We gained a SOD gene of624bp.The recombinant clone was identified byα-complementarity, enzyme digestion and PCRidentification. The result indicated that the recombinant plasmid pMD18-T-SOD was successfullyconstructed. Moreover, through sequential determination and DNASTAR analysis between the clonedSOD gene of M. paratuberculosis C-2 and that of the M.paratuberculosis K-10 strain, the sequentialhomogeneity reached 99%, and the amino acid homogeneity reached 99.5%. The preceding analysisindicated that the SOD gene was very conservative in M. paratuberculosis.

为了研制副结核病敏感、特异的诊断试剂和新型、高效的预防制剂，尤其是DNA疫苗，本研究筛选了M.paratuberculosis主要保护性抗原SOD基因，以M.paratuberculosis C-2染色体DNA为模板，以SOD基因的特异性引物进行PCR扩增，获得了624bp的SOD基因，通过T-A克隆技术，将PCR产物克隆至pMD18-T Vector中，以质粒大小、酶切分析、PCR扩增及序列分析鉴定重组克隆，成功地构建出克隆质粒pMD18-T-SOD，序列测定及DNASTAR分析表明，所获得的M.paratuberculosis C-2 SOD基因与Gen Bank中M.paratuberculosis K-10 SOD基因的大小完全一致，两者核苷酸序列的同源性为99％，氨基酸序列的同源性为99.5％，表明该基因在副结核分枝杆菌中是高度保守的。

Then the paper redefines hotel customer delivered value and hotel employee value according to the particularness of hospitality industry, adopts the hotel enterprises" value chain put forward by Zang Dexia in her "hotel enterprises" competitive advantages research based on value chain", and makes some complementarity according to this research.

第二章介绍了本文所依托的相关理论，包括顾客让渡价值理论、企业价值链理论、员工价值理论，并且结合饭店业的特点对饭店顾客让渡价值和员工价值进行了重新界定，沿用了臧德霞在其"基于价值链的饭店企业竞争优势研究"中所分析和采用的饭店企业价值链，并结合本文的研究给与适当的补充。

It is different from the traditional security measures, it is not passiveness but initiative. It is complementarity and technical improvement, too.

该技术有别于传统的安全防护措施，相对于传统的安全保护，入侵检测不再是处于被动激发，而是主动的检测，对防火墙等传统的安全保护技术既是有力的补充又是技术的进步。

We prove that the solution of a nonlinear complementarity problem is exactly the equilibrium point of differential equation system, and prove the asymptotical stability and global convergence.

在一定的条件下我们证明了非线性互补问题的解是该微分方程系统的平衡点，并且证明了该微分方程系统的稳定性和全局收敛性。

In chapter 2, the generalized nonlinear complementarity problem defined on a polyhedral cone is reformulated as a system of nonlinear equations.

第二章主要是将求解定义在闭凸多面锥上的广义互补问题转化为一个非线性方程组问题。

The proposed algorithm does not base on the primal quadratic programming problem of SVM,but a complementarity problem.

该算法不是基于支持向量机最优化问题本身，而是一个与之等价的互补问题。

We estab-lish,under some mild assumptions,a locally quadratic convergence theoremfor Method I and prove a semi-local convergence theorem for Method II.Applications of the two methods to complementarity,variational inequalityand optimization problems are investigated as well.

在某些适当的假设下，我们证明了方法I的局部二次收敛性和方法II的半局部收敛性；还研究了两个方法在求解互补问题，变分不等式问题及约束优化问题中的应用。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐