查询词典 combustor

15 MWt circulating fluidized bed combustor and the characteristics of heavy metals in the ash samples were analyzed.

在0.15MWt循环流化床燃烧试验台上进行了城市垃圾与煤混烧试验，对焚烧后的灰渣中重金属的特性进行了研究。

Some common applied technologies of reducing NO and N2O emissions in coal-fired combustor were also introduced.

在此基础上，对常见的抑制NO和N2O排放的工艺从机理角度进行了归纳总结。

Results from this thesis conclude that numerical simulation was applied to study combusting flow in the combustor.

本文针对燃气轮机燃烧室燃烧流场的数值模拟问题进行了研究。

A curve coordinate system was used to simulate cold flow in a typical geometry combustor.

采用曲线坐标，对一个典型的燃气轮机燃烧室的冷态流动进行了数值计算，得到的结果定性合理。

Pulsating heat transfer phenomenon is applied to produce a kind of pulsating combustor with high efficiency and low pollution.

详细脉动传热问题在近几十年得到了国内外广泛的关注。

The results indicate that the heat transfer coefficient increase about fourteen percent between the bed and the wall and the one between the gas and horizontal tube increase about twenty two percent, it means pulsating promote heat transfer, Desulfurizing Characters Experimental Research on Pulsating Fluidized Bed With different initial SO_2 density, mean diametric of the calcium oxide and combustion temperature, the experimental results of desulfurization with pulsating or not indicate that the desulfurizing characters of the Rijke type self-exciting pulsating fluidized bed are the same with the conventional fluidized bed combustor, it is that the utilization ratio of the calcium oxide increasing with the initial SO_2 density, the desulfurizing combustion temperature has the best value and the utilization ratio of the calcium oxide reducing with the mean diametric of the calcium oxide.

脉动流化床脱硫特性实验研究对不同初始SO_2浓度、不同初始脱硫剂颗粒平均直径、不同燃烧区温度条件下脉动与非脉动状态下流化床内的脱硫实验研究表明，Rijke型自激式脉动流化床具有类似于常规流化床燃烧器的脱硫特性：固硫剂的CaO利用率随初始SO_2浓度的增加而增加，脱硫燃烧温度存在最佳值，以及CaO利用率随脱硫剂颗粒平均直径的增加而减小。

First of all, some structure parameters, such as the dimension scale of cavity walls, thelocation of primary flow injection holes, the entrance angle of main flow, and so on, havebeen studied, focusing on their influence to the cavity flow field, the forming of vortexes,and the pressure drop in the combustor.

首先研究了模型燃烧器中凹腔长度与前后壁面高度比例、腔内燃料与空气的入射位置、以及主流入射角度等结构参数对腔内流场变化、驻涡形成、以及燃烧器压损等方面性能的影响。

A combustion simulation adopting the Reynolds stress model and the Laminar Flamelet model was performed to determine the effect of humidity in the combustion air on temperature, velocity and NO distributions of methane/air diffusion combustion in a swirl combustor.

采用湍流雷诺应力微分模型和层流小火焰模型，对湿空气透平带旋流器的燃烧室内甲烷扩散燃烧过进行了数值模拟。

Based on measured temperatures and analysis, it is believed that sub-millimeter plane cell combustor can overcome difficulties of the ignition and flameout due to increasing heat loss, and achieve stable combustion.

结果表明，在一定条件下，亚毫米平板式微燃烧室能克服壁面能量损失激增而带来的着火困难和火焰淬熄等问题，能够实现稳定燃烧。

To analysis combustor structure's contribution to fluxion and combustion explicitly, it is necessary to study the impaction of wave system and fire temperature on chemical reaction and heat release's procedure.

为了细致分析燃烧室结构和流动进口参数对超燃的作用关系，必须细化研究超音速流场的波系结构和燃气温度对化学反应放热过程的影响。

So that more consumers can enjoy more delicious quality, technology is even better than wine.

让更多的消费者可以品尝到品质更为鲜美，工艺更为精湛的葡萄酒。

Open it in your favorite text editor .

在你最喜爱的文本编辑器中将它打开。