查询词典 combined with

Methods 63 cases of coxa arthropathy associated with AS were divided into two groups,experimental group and control group.Both groups received a basal treatment of taking sulfasalazine and nabumetone.In EG intra-articular injection of sodium hyaluronate and was carried out once a week in 33 patients with coxa arthropathy associated with AS.Each case received 5 injections in all,only in first injection combined with compound betamethasone.

63例强直性脊柱炎伴髋关节病变患者随机分为两组，均在给予柳氮磺吡啶1.0g，每日2次及萘丁美酮1.0g，每日1次的基础治疗上，试验组患者进行玻璃酸钠和复方倍他米松髋关节腔内注射，每周1次，第1周同时注射两种药物，后第2～5周，仅注射玻璃酸钠，而对照组仅于疗程第1天给予复方倍他米松肌肉注射1次，连续5周为1个疗程。

Considering complicated conditions of the coastal dynamic environment, sediment dynamics, and together with the immature sediment itself, the predicted results will be somewhat limited if only with numerical model. So, in order to obtain microcosmic quantitative assessment and macroscopically understanding, numerical model is combined with field observations in the thesis. Firstly, the tidal current, SSC distribution, benthal deposited materials were basically analyzed by field observations. Then, the tidal current, SSC distribution, and the erosion and accumulation of the seabed were simulated with the numerical model of ECOMSED.

但由于海岸动力环境多变，泥沙运动复杂，加之泥沙问题本身的复杂性，如仅用数学模型，其预测结果将受到一定的限制，故本文采用实测调查与数学模型计算相结合的方法，宏观把握，微观量化，在掌握岚山港西突堤工程所在海域潮流、悬沙量分布、表层底质沉积物类型及特点基本态势的基础上，紧扣开发工程可能引起潮流场变化，分析工程后悬沙量、海底冲淤变化及其空间分布，进而建立潮流作用下的泥沙输运数学模型，首先比较好地模拟目前岚山港西突堤工程附近海域的潮流场和悬沙场，然后预测海湾沿岸可能引起的冲淤强度变化和冲淤区域的空间分布。

For those slurry pump with expeller seal combined with packing or packing seal, the shaft together with impeller should be able to be rotated along pump rotation direction by hand. Otherwise the impeller clearance should be adjusted (For those slurry pump with mechanical seal, adjust the impeller gap first, then mechanical seal).

对于填料加付叶轮组合式密封或填料密封式渣浆泵，用手按泵转动方向转动轴，轴应能带动叶轮转动，不应有摩擦，否则应调整叶轮间隙(对于机械密封式渣浆泵，应先调整叶轮间隙，再调整机械密封)。

For those slurry pump with expeller seal combined with packing or packing seal, the shaft together with impeller should be able to be rotated along pump rotation direction by hand. Otherwise the impeller clearance should be adjusted (For those slurry pump with mechanical seal, adjust the impellergap first, then mechanical seal).

对于填料加付叶轮组合式密封或填料密封式渣浆泵，用手按泵转动方向转动轴，轴应能带动叶轮转动，不应有摩擦，否则应调整叶轮间隙（对于机械密封式渣浆泵，应先调整叶轮间隙，再调整机械密封）。

They were randomly assigned to three arms, 21 were treated with 0.25 % atropine eye drop every night, 20 were treated with 0.5 % atropine eyedrop every night, and 23 were treated with 0.25 % atropine eye drop every night combined with auricular acupressure three times a day for at least 6 months.

以随机方式分配为三组，其中单独点用0.25 %阿托品眼药水组为第一组有21人，单独点用0.5 %阿托品眼药水组为第二组有20人，合并点用0.25 %阿托品眼药水加上耳穴贴压组为第三组有23人。

Due to its linear chain structure, polyacrylamide, combined with DDA, tends to form the high molecular collector with more surface activities. In addition, with the high molecular weight, polyacrylamides (with the exception of hydroxamic acid polyacrylamide) can strongly flocculate kaolinite, which can increase the adsorptive density of collector and activate the kaolinite flotation.

由于分子的直链结构，聚丙烯酰胺药剂易与捕收剂十二胺形成表面活性更高的高分子捕收剂，同时由于聚丙烯酰胺具有较高的分子量，对高岭石显示很好的絮凝作用，增加了捕收剂的吸附密度，活化了高岭石的浮选。

According to the studied results at present, the studied objects are mainly thin plate and beam about sound radiation mode, a method computed sound radiation mode of complex structure is presented in this dissertation, according to the results of the previous two chapter, a theoretical method to solve acoustical radiation mode and acoustical radiation efficiency of complex structure by boundary element method and acoustical radiation theory is posed, the acoustical radiation power is expressed as a Hermitian quadratic form, while the radiation modes is determined by general eigenvalue decomposing, and then the radiation efficiency is computed via the orthodoxy of radiation modes with regard to impedance matrix and average velocity matrix; lastly, the validity of the method is proved by pulsating sphere and radiating cube with analytical results. According to results of the form three chapter, the structure sound radiation sensitivity is studied in detail, the sound radiation power of structure can be expressed as positive Hermitian quadratic form, the sound radiation sensitivity can be expressed as two parts by partial differential with respect to design variable, which are sensitivity of boundary velocity and impedance matrix, combined with the theory of FEM and BEM, the structure sound radiation can be translated to the analysis of structure dynamic sensitivity and impedance matrix sensitivity. The theory posted in this dissertation is tested by the FEM software ANSYS and the software AAS programmed by author.

在前几章的基础上，通过结构声辐射的模态理论对结构的声辐射的机理进行了深入地探讨，针对目前声辐射模态的研究对象主要是简单的板和梁类结构，提出了一种计算复杂结构声辐射模态的方法，利用前两章研究所得的结论，将边界元方法与广义特征值的理论结合起来研究了复杂结构的声辐射模态与声辐射效率，先将结构的声辐射功率表示为一个正定的厄米特二(来源：ABb7C论文0909网www.abclunwen.com)次型，运用广义特征值分解求解了复杂结构的声辐射模态，然后利用声辐射模态关于阻抗矩阵与均方速度耦合矩阵的正交性，求解了复杂结构的声辐射效率，最后用具有解析解的脉动球与辐射立方体验证了该方法的有效性。

Methods The amount of heterophoria on near (33 cm) fixation was respectively determined without and with correcting spectacles, and with correcting spectacles combined with an additional +1.50 D lens in 151 students with different refractive state.

用隐斜计测定151例不同屈光度青少年在裸眼、戴矫正镜片和矫正镜片再加+1.50D球镜条件下看近的隐斜度。

In general, the design work with traditional measures is done by hand, which cannot meet the needs of the technology and manufacture. So the author has developed a CAD hydraulic design software fit for lower specific speed axial flow runner, which is easily operated by users.The main research work of this paper is as follows:1 Analyzing the main reason of axial flow power station cannot work well under littler volume of flow in some season and putting forward an improving scheme, pointing out the characters of design under abnormal factors.2 Combined with the development of the industry in our country, the abnormal hydraulic design method of propeller turbine is discussed based on present literature, data and experiment results.3 Guided by the design method of software engineering, a suit of hydraulic design software of Lower Specific Speed Axial Flow Runner is programmed by the object-oriented programming language Visual Basic and a straightforward, concise and standard Windows human-computer dialogue interface is designed for the system, which makes the operation of the system very convenient.4 ActiveX Automation technology is adopted as the interface with AutoCAD and the hydraulic drawings are edited, modified by AutoCAD until hydraulic model drawings according with the demand of engineering practice are output.5 To resolve practice problem, the author has designed a lower specific speed axial flow runner for Duowa Power Station through an example.

论文的主要内容有：1 深入分析很多轴流定桨式水电站枯水季节小流量下不能发电的主要原因，提出减容改造方案，并指出超常规条件下的改造设计特点。2 结合国情及行业发展需要，参考现有资料、文献和前人的研究成果，进行低比转速轴流式转轮叶片水力设计方法的研究，对轴流式转轮叶片的奇点分布法水力设计进行了全面的探索，结合现代计算机技术，找到了一种针对特殊条件的轴流式转轮叶片水力设计方法。3 仔细比较多种AutoCAD二次开发工具后，结合本课题的特点，选用Visual Basic语言，综合应用软件工程的设计思想，进行低比转速轴流式转轮叶片水力设计软件的编制，为系统设计了直观、简洁和标准的Windows人机对话界面，便于用户操作；编程时在考虑到设计条件特殊性的同时，尽量做到程序的通用性，使之可用于解决同一类问题；另外，大部分程序还可移植到普通轴流式转轮叶片水力设计中，具有良好的适应性。4 利用ActiveX Automation技术与AutoCAD接口，对AutoCAD进行二次开发，在AutoCAD下实现水力图的自动生成和编辑，直至输出符合实际工程要求的木模图。5 通过算例，为多哇水电站设计了一个低比转速轴流定桨式转轮，解决其在枯水期小流量下不能发电的问题。

Cases had non-isolated splenic vein occlusion, including 6 cases with interruptive thrombosis in PV-SV-SMV junction and 3 cases with stenosis or occlusion near PV trunk and SMV. 30 cases had been combined with twist vein collateral circulation and 6 cases with portal hypertension.

非孤立性脾静脉阻塞9例，其中PV—SV—SMV汇合部中断闭塞6例，近汇合部PV主干合并SMV狭窄、闭塞3例；伴有增粗扭曲的侧支循环静脉30例，合并区域性门静脉高压6例。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。