查询词典 cold rolling
- 与 cold rolling 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This paper researched effect of the reduction partition in two-time cold rolling on {111} texture of IF steel by test.
本文通过试验,研究了IF钢在两次冷轧时不同的压下率分配对{111}织构的影响。
-
This paper introduces the operation principle of laser velometer,expounds the control method in AGC system of double stand reversing cold rolling mill,analyzes each control algorithm of AGC system,and describs the composition and characteristics of each control section.
介绍了激光测速仪的工作原理,对双机架可逆冷连轧机系统控制策略进行分析,并研究了该厚度控制系统中的各种控制算法、各AGC控制环节的组成及特点。
-
The furnace body is made ф2200×1500 the outer covering main body by the 12mm steel plate, lower part the furnace body 45° the installment has the sensor, the sensor orientation silicon steel plate is made the weight 2 ton induction iron cores by Wuhan Steel Corporation Silicon steel plate Factory production top gear's W-151 the cold rolling 0.35m/m, primary is made the water cooling coil by 10×10×2 the copper pipe, and installs the stainless steel water cooling restricting, the power frequency has the core smelting furnace's metal melt fluid namely for the sensor sencondary coil, the entire electric stove is a transformer actually, the necessary 6 grades from the pair regulating transformer, shift gears by the electricity cabinet control, the voltage may from low to high, divide 6 promotions to arrive at 380V, each grade of voltages are different, the output is also different, the furnace temperature along with the files position is also different, but the height is different, adapts smelts colored or the black and so on melting point different metals, and may make the new furnace lining to smelt diamantine drying furnace fireproof.
炉体由12mm钢板制成Ф2200×1500外壳主体,炉体下部45°安装有感应器,感应器由武钢硅钢片厂生产的最高档的W-151冷轧0.35m/m取向硅钢片制成重2吨感应铁心,初级由10×10×2铜管制成水冷线圈,并安装不锈钢水冷保护套,工频有芯熔炼炉的金属熔液即为感应器的次级线圈,整个电炉实际就是一个变压器,配套一台6档的自耦调压变压器,由电柜控制换档,电压可由低到高,分6级升到380V,每档电压不同,输出功率也不同,炉温也随档位不同而高低不同,以适应熔炼有色或黑色等熔点不同的金属,并可作新炉衬耐火冶金砂烘炉之用。
-
Now there are 20TA OD finery、mid- frequency furnace、drawbench as well as hot and cold rolling mill、abrasive finishing machine etc, all of which are the guarantee to meet the customer's demand: Supply of goods timely, Large stocks.
承蒙广大用户的大力支持和信任,使公司从小到大,从大到好,总公司先拥有20TAOD精炼炉,中频炉,冷热轧钢机及冷拔机,抛光机等能为广大客户及时提供货源,库存量大,是客户需求的保障。
-
K S calculation method of grooving for cold rolling tube is introduced.
提出了设计冷轧管孔型的KS计算方法。
-
Magnetic properties of 2J4 alloy by ECAP is hetter than those by cold rolling, ECAP makes the grain of alloy fined and close to single magnetic domain.
由于ECAP方式使晶粒细化,达到或接近单畴结构,使得2J4合金的磁性能优于冷轧条件下的磁性能。
-
In order to improve product strength and malleableness which are suitable for subsequent(cold-rolling) process,based on condition of the workshop,rational range of cooling rates was established.
带钢热轧以后的冷却速度对于钢带的组织与性能有着极其重要的影响,钢种、板厚、终轧及卷取温度和轧制规程等都相同,只是冷却速度不同就能引起性能上的较大差别[1]。
-
Its work-hardening may be attributed to a change from nonequal strengthening state to strength-ratio-equal state A summarized plot for its deformation behaviour during cold-rolling is also given to understand rather easily the relative variation of the structure and properties of each phase in the whole process.
文中提出了冷轧时形变行为的综合图,能够清楚地描述双相20钢中两相组织及性能相对变化的全过程。
-
The microstructure changes of pearlitic eutectoid steel induced by cold rolling were investigated by using SEM, TEM and XRD etc.
用SEM、TEM及XRD等方法研究了共析钢中珠光体经40%—90%的冷轧变形后所产生的显微组织变化。
-
Presents the microstructure evolution in aluminum a nd copper after deformation by cold rolling in the strain range of 10 to 50%red uction using TEM and points out three types of dislocation structures are typica l and two of them are common for both materials and these two common types are f ound in non-cube grains and can be distinguished by crystallographic orientatio n of dislocation boundaries in the grains and the third type of structure is obs erved in cube grains, and concludes that grain orientation is important in deter mining the structure type but some other metallurgical parameters also have a ro le to play.
采用TEM对冷轧多晶铜与多晶铝的形变显微组织演变进行了对比研究。结果发现:多晶铜及多晶铝形变显微组织中均含有三类典型的位错结构类型,其中的两种结构特征在两种材料中是相似的,这两种类型结构存在于非立方取向晶粒,可通过晶粒中位错边界的晶体学取向加以区别,另一类型结构存在于立方取向晶粒;晶粒的晶体学取向决定了其形变显微组织类型,但其它冶金学因素对显微组织也有影响。
- 推荐网络例句
-
Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.
Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。
-
I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.
我来只是现在,'歼灭战perfuming自己与胡努特,那麼,他来到和SAT 。
-
The shamrock is the symbol of Ireland and of St.
三叶草是爱尔兰和圣特里克节的标志同时它的寓意是带来幸运。3片心形叶子围绕着一根断茎,深绿色。