查询词典 coil out

First of all, the original current flows through the choke coil, because there is a coil-storage properties, which can filter out some of the initial high-frequency noise, and then further into the filter capacitors to clean up, even out (the peak shape into pola square wave).

原始电流首先流经扼流线圈，因为线圈有一个蓄能的特性，它可以初步过滤掉一些高频杂波，然后进入电容组进一步过滤、净化、拉平。

Such equipment is the main magnetic power, can provide a one-way communication and half-wave rectifier power magnetizing current, accessories have contact, clamp, opening and closing, and closed-type magnetizing coil and flexible cables that can carry out contact method, clamp power law and the magnetic coil method.

这类仪器主体是磁化电源，可提供交流和单向半波整流电的磁化电流、附件有触头、夹钳、开合和闭合式磁化线圈及软电缆等，能进行触头法、夹钳通电法和线圈法磁化。

Inject some high-freq AC power into the first "primary coil", and the same AC power comes out of the second "primary coil" at the far end.

注入的第一个"初级线圈"一些高频率的交流电源进，同样的交流电源出来的第二个"初级线圈的终结"在远。

Analyzed the structure characteristics of the perfume cover outer shell plastics piece, described the piece's structure and work principle which model a craft and inject a mold, its principle :adopt and certainly be apart from bolt and spring coil and carry on two cents type, use inclined lead a side outside the pillar and take out heart, type the heart crest spare parts, while entering and anticipating adoption incubate the type sprinkle into anticipate a form, while opening a mold, with the ball head pull and anticipate a pole sprinkle and note system and anticipate, then make use of and take out and push plank and release a plastics piece inside a heart,use spring coil and reset first while matching a mold, then carry on willing model a beginning next time.

摘要分析了香水盖外壳塑件的结构特点，叙述了该塑件成型工艺、注射模的结构和工作原理，其原理是：采用定距螺钉和弹簧进行二次分型，用斜导柱外侧抽芯，型芯顶出零件，进料时采用潜伏式浇口进料形式，当开模的时候，用球头拉料杆把浇注系统凝料顶出，然后利用型芯内抽推板推出塑件，合模时用弹簧先复位，然后进行下一次成型开始。

The main principle of the DCcontactor:The electromagnetism coil switches on electricity thetitle iron to match with the iron heart on,the suction of theelectromagnetism system overcomes the counterforce of the springarouses the action of the contact, the main electric circuitconnected;The electromagnetism coil cuts the power the counterforceof the spring arouses the title iron from move to open, the headcontact breaks to open the output electricity arc give or get anelectric shock in drive to arc-extinct-chamber and made longer,thestrong cooling dissociates and put out,the main electric circuitcuts off.

接触器的主要原理：电磁线圈通电，衔铁和铁心吸合，电磁系统的吸力克服弹簧的反作用力带动动触头与静触头接触，主电路接通；电磁线圈断电，弹簧的反作用力带动衔铁和动触头弹开，触头断开产生的电弧在灭弧室中受到磁吹灭弧和电动力驱动被拉长，并强烈冷却去游离而熄灭，主电路切断。

After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

The opened magnetic circuit is composed as tow NdFeB permanent magnets and a top plate without U-yoke. After take analyzed deeply for the opened magnet circuit with FEMM (Finite Element Method Magnetics) we find out the field distributing that is separated into three sections . One is the main area what we called as positive field section. Beside the main field there are tow areas that are called the inverted field sections. Loudspeaker arise a very serious distortion when the voice coil moving into inverted field areas. The direction of induced current in the coil part of entered inverted field area is same with the current driving into loudspeaker so that total currents increas largely and heat increase rapidly. With more coils moving into inverted area the voice coil will take on negative inductance properties. It is the main reason that voice coil is burned by heating with increasing current due to arise negative inductance. So opened magnetic circuit is not suitable for the woofers in which the voice coil have wider displacement range. When using this kind magnetic circuit design, the voice coil moving range should be less than the range of positive field to avoid loudspeaker arise serious distortion and heating. Even though voice coil moving range is in the positive area, loudspeaker will still arise more distortion because the field distribution is very cliffy at tow sides of the positive area and full range of magnetic field distribution is not parallel that will arise distortion. Base on above reasons, opened magnetic circuit is not an ideal magnetic circuit for low-frequency loudspeakers. But it can be used in mid-range or high-frequency productions.

开式磁路是由2片钕铁硼磁铁和主导磁板和导磁垫片组成，我们在实践过程中发现这种磁路结构不适合于低频扬声器的使用，我们通过使用FEMM（Finite Element Method Magnetics）软件包对该磁路进行了分析，该磁路的磁场范围被分成3个区域，其中在主导磁板附近形成一个正向磁场，在正向磁场的两边存在反向的磁场，音圈在工作时有很大一部分进入了反向磁场中，在反向磁场内线圈的感应电流方向与驱动电流方向相同，使得音圈呈现出负感抗特性，由于音圈的负感抗特性引起电流的增加导致音圈发热甚至烧毁，因此在扬声器中使用开式磁路时，音圈的运动范围应控制在正向磁场范围之内，否则音圈运动到反向磁场区域时将会产生很大的失真和发热，即使在设计时已经将音圈的运动范围控制在正向磁场范围之内，由于正向磁场的2个边缘磁场强度衰减太快，同时开式磁路中磁场的分布不是平行的，而是自由发散的分布，这样肯定会导致扬声器的非线性失真，因此我们得到的结论是：开式磁路并不是一个理想的磁路，它不适合于低频扬声器的使用，但它还可以应用于中高频扬声器。

"Recoiler is consists of auxiliary recoiler (pushing out hydraulically, clamping auxiliary recoiler), coil discharging car and coil storage position."

卷取机：带助卷器卸卷小车和存卷鞍座。

Of key parameters standard design. It predigests the design and improves the design veracity.(2) Base on the in-depth research of asteroida! magneto, points out the compute of lamp coil design is the key of magneto design; and points out the type and structure of permanent magnet.

2在深入研究星形磁电机的基础上，提出照明绕组设计计算是磁电机设计的关键；并提出磁电机用铁氧体永磁材料以选用径向磁定向和削角瓦形的结构为宜。

Large air separation plant 40000m3/h, This plant adopts molecular sieve system to adsorb CO2, C2H2, moisture and CnHm in air to pre-purify air, by use of air booster compressor, to pressurize some of purified feed air by two sections, pressurized air to warm up high pressure liquid oxygen in high pressure coil heat exchanger to ambient temperature and delivere out off cold box to coal gasification, some pressurizrd air by first section is drawn from middle part of coil heat exchanger and expanded in medium pressure expander then led into lower column, other part of pressurized air by second section is drawn from cold end of coil heat exchanger and led into lower column after throttling, un-pressurized feed air is cooled by return gas in plate fin heat exchanger and led into lower column.

产品描述：采用常温分子筛空气预净化系统吸附空气中的CO2、C2H2、水份和一些碳氢化合物，使用单独的空气增压压缩机将部分净化后的原料空气分为两段增压，增压后的空气在高压绕管式换热器中将经液氧泵加压的高压液氧汽化并复热至常温送出冷箱直接供煤气化工序使用，第一段增压后的空气，部分从绕管式换热器中部抽出经电机制动的中压透平膨胀机膨胀后送入下塔，另一部分经第二段增压后从绕管换热器的冷端抽出节流后送入下塔，未经增压的原料空气在板翅式换热器中被低压返流气体冷却后进入下塔。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。