查询词典 coffin-joint

The subjective aspect of joint crime is an important criterion of cognizing joint crime,and also the subjective foundation of joint criminalist take on the criminal duty.

共同犯罪的主观要件是认定共同犯罪的重要标准，更是共同犯罪人承担刑事责任的主观基础。

Rash, pustular psoriasis may also have changed. X ray showed that some patients with rheumatoid arthritis joint changes and the same may have a partial decalcification bone, joint cavity narrow, there are varying degrees of joint erosion and soft tissue swelling.

皮疹也可有脓疱型牛皮癣的改变。X线显示，部分病人关节的变化和类风湿型关节炎相同，骨质可有局部的脱钙，关节腔狭窄，有不同程度的关节侵蚀与软组织肿胀。

Bonded joint was obtained by diffusion bonding at constant temperature and pressure, phase transformation superplastic diffusion bonding and diffusion bonding under pulsatile pressure. The strength of welding joint was tested and metallography of welding joint was observed.

采用恒温恒压扩散焊、相变超塑性扩散焊和脉冲加压扩散焊实现了钛合金和不锈钢的焊接，测试了焊接接头的强度，并对接头进行了金相观察。

The properties of mini-finger joint in corner, dowel joint.tenon and mortise joint were compared and studied through experiment.

通过试验，对微型指榫角部接合与圆榫及直角榫接合性能进行了比较和研究。

Bonnet joint varies from flat face gasket-joint to ring-type bonnet joint, depending on class.

阀盖连接方式从平面垫圈连接到环形阀盖连接，压力等级不同，连接方式也有所不同。

This study first analyzes boundary condition of single column member and adopts relative joint bending stiffness ratio of AISC to find the effective length factor. For that a structural joint or connection is neither full rigid nor full hinge in practice, this study uses this concept to establish the semi-rigid joint model. This study then discusses the structural behaviors of tapered members results with those from and compares these previous studies.

本文先对於单一柱构件之边界条件进行分析，采用AISC规范求取有效长度系数之G值控制梁柱相对劲度，同时考虑一般实务上结构接合并非完全刚性或完全铰接，模拟介於两者间之半刚性接合，藉由模拟结果进一步探讨非均匀构架之结构行为，并与前人之研究相关成果比较。

Whether the Danishside does have the company to put up a factory (the joint capital waywith my storehouse joint capital in Siping: The Danish side buy stockby the equipment and the technology or invests part of funds buy stockagain, my storehouse puts up a factory with and the floating capitalbuy stock) establishes the standard the joint-stock company.

丹麦方是否有公司与我库合资在四平市建厂（合资的方式：丹麦方以设备和技术入股或再投入一部分资金入股，我库以建厂用地和流动资金入股）成立规范的股份公司。

Joint distribution system is the Nerve network of the chain enterprise. As the basic operation establishment, distribution center that is the nerve hinge of joint distribution plays an important role in joint distribution.

共同配送体系是连锁经营的"神经脉络"，配送中心作为共同配送运作基础设施，构成共同配送活动的神经枢纽，对实施共同配送发挥着重要的作用。

Afterwards, we propose a new constant coefficients measurement method in dynamic equation of robot manipulators, this measurement method includes three groups of experiments: group one, let each joint of robot manipulator keep static to measure the constant coefficients in gravity term of dynamic equation and Coulomb frictional torque, group two: let only one joint of robot manipulator move at a constant velocity to measure the viscous frictional coefficient and constant coefficients in effective inertia of dynamic equation, group three: let only one joint of robot manipulator move at constant acceleration at a time to measure constant coefficients in Coriolis and centrifugal term and coupling inertia of dynamic equation.

让操作器单个关节恒速运动，在对驱动系统中传动机构，减速装置和电感系数综合考虑的基础上，这组实验对粘滞摩擦系数及有效惯量中常数系数进行测量。这种测量方法只要求旋转关节的驱动电机施加恒定电压，回转关节驱动电机施加正弦波电压。3。让操作器单个关节恒加速运动，这组实验测量动力学方程中哥氏力、离心力项和耦合惯量项中的常数系数，这种测量方法只要求单个关节匀加速运动，而其它各关节保持静止，这种测量方法虽然要求关节匀加速运动，但不必进行关节角加速度检测，而只需进行关节角位移和角速度检测即可，输入量直接给定为输入电压。

The experimental conclusion determined that if the knee joint angle can be kept at 140-150 in the buffer jump at various liftoff heights, and the coax joint as well as the knee joint can be larger than 170 at the instant liftoff, an optimal jump can then be achieved.

以上实验结果予以讨论后获得以下结论：苏翊伦选手在不同跳跃高度之起跳动作，若缓冲期间起跳脚膝关节角度能维持在140度？

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。