查询词典 coefficient

In this model of Tu Men River quality the functional structures of the deoxygenation coefficient k1, reaeration coefficient k2 and BOD sedimentation-resuspension coefficient k3 are established and tbe parameters determined by a regression technique to suit the characteristics of a river in the mountain area of North-Eastern China.

表达式中的参数通过系统识别与参数估计方法确定，因此能较好地反映河流的地理环境特点。特别是κ_3的表达式，它以流量为自变量，用一个单一的解析函数同时描述了江中的沉淀与再悬浮现象，具有独创性。

The test results show that, the drag bar pull and efficiency coefficient is increasing with the wheel width and diameter. The draw bar pull increased with the rug height, but the efficiency coefficient reduces when the slip radio is bigger than 20%. The draw bar pull and efficiency coefficient will reduce with the rug distribution incereases when the rug distribution is more than 20%.

结果表明，当增大驱动轮宽度和直径时，其挂钩牵引力和效率系数都呈增大趋势；增大驱动轮的轮刺高度，挂钩牵引力增大；当滑转率小于20%时，效率系数随着轮刺高度的增大而增大，而当滑转率大于20%时，效率系数随着轮刺高度的增大而减小；增大驱动轮轮刺密度时，其挂钩牵引力和效率系数随之先增大后减小。

The results show that the microstructure of ventra1 scale for python was composed of micro-convex and plank structure that was periodically arranged, it was mensurable and could be described by 9 characteristic parameters. Its surface was different in their forward and backward lean angle. The frictional coefficient of the ventra1 scale had closely relationship with moving direction, it decreased with the increasing load. The value of the frictional coefficient was about 0.07. The frictional coefficient while python moved backward and laterally were equal, and that was 33% more than that moved ahead. The frictional force of the ventra1 scale surface was caused by mechanical tooth function of micro-convex, acting intermolecular force and material's elastic hysteresis. The difference of forward and behind bevel for micro-convex was the anisotropy reason of frictional force.

结果表明：腹鳞表面的微观结构由指状微突体和板结构部分周期排列而成，其结构可用9个特征参数定量描述；腹鳞表面摩擦力由分子作用力、表面微突体的犁沟力、楔形作用力以及材料弹性滞后共同引起；腹鳞表面的摩擦系数在0.07左右并与运动方向有关，摩擦系数随载荷增加而减小；后向运动及左、右侧向运动时摩擦系数基本相等，比前向运动时高33%左右；腹鳞表面微突体不同方向上倾斜角度的差异是引起摩擦各向异性的主要原因。

It is found that the overall heat transfer coefficient of elliptic cylinder with k.0 is higher than that of a circular cylinder.At k=6.0,it has the maximum which is about 1.6 times that of a circular cylinder.At the same time,the drag coefficient drops down with the increase of k.For k=2.0,the drag coefficient is about 60％ that of a circular cylinder.

当k.0时，椭圆管的平均对流换热系数高于圆管；当k=6.0时，达到最大值，大约为圆管的1.6倍，同时，其阻力系数随着k的增大而减小；当k=2.0时，阻力系数约为圆管的60％。

Above all, consider combination of 3 kinds of load and different constant load and alterable load effect to compare an effect, gave out representative ferroconcrete component is in give an environment to fall, the affirmatory principle that the reliability of different operating period analysed methodological; to put forward intended performance structure to design reliability level, namely index of reliability of component part of the construction inside intended performance cannot be under the standard; of active standard on foundation of expression of design of reliability of our country structure introduce wear to fold decrease coefficient, gave out the affirmatory method of this coefficient, assure in design phase through this coefficient and achieve target of reliability of component part of the construction inside intended performance not the standard under active standard.

首先，考虑三种荷载组合以及不同恒荷载和可变荷载效应比影响，给出了代表性钢筋混凝土构件在给定环境下、不同使用期的可靠度分析方法；提出了预期使用期结构设计可靠度水平的确定原则，即预期使用期内结构构件可靠度指标不能低于现行规范的标准；在我国结构可靠度设计表达式基础上引入耐久性折减系数，给出了该系数的确定方法，通过该系数在设计阶段保证和实现预期使用期内结构构件可靠度指标不低于现行规范的标准。

This paper discusses the broad-sense relation between solution and coefficient of some special kinds of second order variable coefficient and homogeneous linear differential equation,and have a try of giving a general form of common solution and the coefficient decision formula of special solution.

探讨了某些特殊类型二阶变系数齐次线性常微分方程的解与系数的广义关系，尝试了从理论上给出通解的一般形式和特解的系数决定式。

In virtue of Fluent of CFD software, we carry though computation of aerodynamics of an air-to-air missile in different Mach meter and different attack angle and gained movement trend of lift coefficient、drag coefficient and pitching moment coefficient with variety of Mach number and attack angle, meanwhile, we also obtain distributing trend of pressure, temperature and weather velocity.

借助于商业CFD软件FLUENT，对某型空空导弹在不同攻角、不同飞行马赫数的气动力进行了计算，得出了该型导弹升力系数、阻力系数和俯仰力矩系数随飞行马赫数和攻角的变化规律以及导弹表面的压力分布、温度分布和来流速度分布。

The current coefficientΨ of correction includes many influencing factors. And numerical value of this coefficient varies widely. So the current method was improved from one coefficient to four coefficients in this paper. Three new coefficients of correction were considered to decrease composite ratio of coefficient Ψ and put forward three coefficients to modify calculating result.

针对现行经验系数包含的影响因素太多以致其取值过于离散的问题，在现行规范法计算建筑地基沉降的基础上，对现行方法进行了改进，由原来的1个修正系数改为4个修正系数，用新增加的3个系数反映3个不同方面的影响，以减小原经验系数的综合程度。

The strength and toughness of the nanocomposites are improved because of the addition of anao-Zno. The volume resistance strength and toughness of the nanocomposites are improved because of the addition of nano-ZnO. The volume resistance coefficient is decreased 8×10 times, surface resistance coefficient is decreased 5.7×10^4 times, and the friction coefficient is decreased 29% by adding nano-ZnO. The friction, wear properties, and the antistatic property of MC Nylon 6/ZnO nanocomposite are better obviously than MC Nylon 6. The macro stress of MC Nylon 6 structure is changed by the tensile test so that the preferred orientation of crystal surface (002+202) is more obvious.

纳米ZnO的加入起到同时增强增韧的作用；使体积电阻系数降了8×10^4倍、表面电阻系数降了5.7×10^4倍、摩擦系数降低了29%，MC尼龙6/纳米ZnO复合材料摩擦磨损性能和抗静电性能明显优于MC尼龙6；经过力学拉伸试验的破坏，引起MC尼龙6结构发生宏观应力变化，造成（002+202晶面）产生明显的择优取向。

Different polynomial coefficient combination of amplitude changes is selected as the input signal to minimize the compensation error. A dynamic coefficient polynomial model is given with simplified coefficient estimation algorithm based on direct learning architecture.

动态系数多项式具有多组系数，随着输入信号幅度的变化，多项式选取不同的系数组合，从而降低非线性补偿的误差；文中讨论了动态系数多项式模型的构造方法，并且给出了基于直接学习结构的简化递归系数估计算法。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。