查询词典 coatings

The RFS TiC-Fe coatings have an adhesion strength (about 16 MPa) as high as Ni45 coatings obtained by traditional oxygen-acetylene flame spray.

当选取Fe=50wt％、C/Ti=1.4、喷涂粉末粒度=200～300目、喷涂距离=170mm和乙炔压力=0.09MPa时，涂层性能最佳。

I am sure that coatings must be the answer, but certainly the better Orthos have excellent coatings too, so I am somewhat stumped for a complete explanation.

我确信这个结果肯定是因为镀膜的原因，但是一些更好的OR目镜也有优良的镀膜，我想知道更全面地解释。

Because of advantages such as fast-curing, lower energy consumption, no solvent pollution and so on, UV-curing coatings have rapid development. It has wide range of applications in painting of wood, metal, plastic, paper. In order to fit some special applications and make cured coatings have some special performance, the development of new type of resins, diluents, functional additives used in UVCC was introduced. Some new kinds of UVCC were developed and employed.

紫外光固化涂料由于具有快速固化、低能耗、无溶剂污染等优点而得到快速的发展，在木材、金属、塑料、纸张等的涂装上有广阔的应用前景，为满足一些特殊的应用场合或使固化膜具有某些特殊的性能，一些新型树脂、稀释剂和功能助剂等得到了研究和发展，开发和应用了一些新的紫外光固化涂料品种。

POR-15 anti-corrosion coatings are one of the main applications in metal, cement and wood surface of high-tech anti-corrosion coatings.

POR-15防腐涂料是一种主要应用在金属、水泥和木材表面的高科技防腐涂料。

The experimental results show that the size of large particles on coatings surface was decreased obviously by N ion beam assisting bombardment, and surface morphology was optimized. Unitary TiN phase was obtained and softer Ti2N phases were eliminated by N ion beam assisted bombard. As the energy of bombard increased, TiN (111) crystal orientation gradually reduced and (200) gradually enhanced. The micro hardness of coatings reinforced too.

结果表明：N离子束辅助轰击，能够有效地减少和降低膜层表面&大颗粒&的数量和尺寸，消除了膜层中较软Ti2N相，得到了单一的TiN相，随着轰击能量的增加，TiN相结构不发生变化，TiN（111）取向逐渐减弱，而（200）取向逐渐增强。N离子束辅助轰击能量的增加，提高了膜层的显微硬度。

Based on the displacement function solution for plane issue in elastic mechanics, the common solutions of interface stress and displacement in multilayer coatings system are deduced by Fourier transformation, so that an effective and simple algorithm to calculate interface stress of coatings is obtained.

基于弹性力学平面问题的位移函数解法，运用Fourier积分变换推导了多层涂层体系界面应力及位移分量的一般解，得到一种高效、简便的涂层界面应力计算方法。

Iron-based composite coatings were deposited on mild steel substrate by arc spraying cored wire with WC-CoNi ceramic powders. The abrasion wear properties were evaluated using a examined MLS-225 wet sand/rubber wheel tester. The microstructure, phase compositions and worn surface of the coatings were examined by means of optical, scanning electron microscopy and X-ray diffraction.

采用电弧喷涂含WC-CoNi金属陶瓷粉末的粉芯丝材，在低碳钢基体上制备铁基复合涂层，采用MLS-225型湿砂橡胶轮磨损试验机评价铁基复合涂层的耐磨粒磨损性能，利用光学显微镜、扫描电子显微镜和X射线衍射仪对涂层的显微组织结构、磨损表面及其相组成进行分析。

The results show that the graded thermal barrier coatings have typical lamellar structure. The coatings are compact.

结果表明：梯度涂层呈典型的层状结构，涂层较为致密，空隙均匀，同时分布有各向的微裂纹。

The operation principles of visible light, infrared and laser stealthy coatings were simply introduced. We analyzed the contraventions existed in producing multiple electro-optic stealthy coatings acting on all the 3 bands of light.

简述了可见光、激光、红外隐身涂料各自的作用机理，分析了欲制成光电复合隐身涂料所必须处理好的三者之间存在的矛盾点。

However, siloxane coatings tend to craze upon exposure to high atomic oxygen effect, and may even result in premature coatings failure.

但是有机硅涂层在高通量的原子氧暴露下表面会产生裂纹，导致涂层提早失效。

We are in a good position to meet your requirements.

我们完全可以满足你方的需求。

We are all pervade d with a sense of disaster.

我们普遍有大祸降临的感觉。