查询词典 coating

A slightness pipe inner surface TiN coating system has been designed and equipped, with this system, coating experiment on the inner surface of 2000mm long 86mm diameter stainless steel pipe had been done with well experiment results, with these experiments, a technique of TiN coating has been achieved.

和国际先进水平相比，采用辅助真空室设计方法使镀膜装置极为简单。

The method which is composed of pre-impregnating in soaker, painting coating on the surface of carbon/carbon composite, and solidifying the coating, was first used for the preparation of a good anti-oxidation coating on the composite.

摘 要：采用在C/C复合材料基体表面预先浸涂浸渍剂，再涂刷涂层并进行涂层固化处理的工艺方法，可制备出抗氧化性能良好的涂层。

ESCA results show that silica is coated on surface of the polymeric microspheres. SEM analysis reveals that when water was used as a solvent, uniform silica coating on the surface of organic microsphere can be obtained, and when the reactive time is 10 minutes, an uniform coating layer can be prepared. But when tetrachloroethylene was used as a reactive solvent, an inhomogeneous silica coating is found on the organic microspheres.

由化学分析电子光谱仪纵深分析可以得到，矽的前驱物是藉由披覆方式附著在有机微球表面；SEM分析发现以水为溶剂所合成出之披覆有二氧化矽的有机微球表面呈现均匀披覆效果，并且当反应时间为10min时表面均匀披覆效果最好；而以四氯乙烯为溶剂的系统所合成之微球则呈现不均匀披覆。

Han Sen Bangde Beijing Co., Ltd. was established in 1997, is the major domestic production, research and sales thermoset powder coating as one of the enterprises, an international field of powder coating the most advanced production technology and techniques, first-class modern production equipment, complete Complete testing tools and excellent management personnel, the annual capacity of excellent quality powder coating over 5,000 tons.

北京汉森邦德有限公司成立1997年，是国内主要集生产、研究和销售热固性粉末涂料为一体的企业之一，拥有国际粉末涂料领域最先进的生产工艺和技术，一流的现代化生产设备、完整齐备的检测手段和优秀的管理人才，每年可生产品质优异的粉末涂料5000多吨。

Coating thickness of the coating determined using point-3:00 measured the thickness of the coating thickness gauge general, the living

涂装漆膜厚度的测定，用触点式漆膜测厚仪一般测定3点厚度，取其平均值。

The result indicate that: the electrodeposition of zinc on nickel and tungsten substrates involves instantaneous three-dimensional nucleation. The coating is the best when the current density is 4mA/cm2 and the temperature is 80 ℃. The coating by the method of the impulse electrodeposition is better than the direct current electrodeposition. Especially when f is 100Hz, ton/toff is 2/8 and J is 8mA/cm2, the coating is clean and uniformity. The crystal size is nearly 0.3μ m .

结果表明：阴极反应为准可逆反应，锌离子在镍电极和钨电极上形核是三维瞬时形核半球形扩散长大过程，直流电流密度为4mA/cm2，温度为80 ℃时，镀层质量最好；脉冲电沉积得到的镀层要优于直流电沉积得到的镀层，尤其在脉冲宽度为2ms，脉冲间隔为8ms，电流密度为8mA/cm2时，得到的镀层光滑而均匀，颗粒大小接近0.3μm。

The cast coated sheet comprises a substrate and a brushed coating layer comprising a pigment, a functionally effective amount of latex such that a dried unbrushed layer of the coating will not adhere sufficiently to the casting surface to allow the unbrushed layer to be cast, and a functionally effective amount of brushing agent such that damage to the coating layer surface during brushing is minimized.

该铸塑涂布平张纸含有一个基片和一层涂刷过的涂层，该涂层包括涂料，含量为功能有效量的乳胶液，使得该干燥的未刷涂层不与铸塑涂布面充分粘接到足以对该未刷涂层进行铸塑涂布的程度，和含量为功能有效量的涂刷剂，使得在涂刷过程中对该涂层的损伤减到最小。

The test shows that all performance index of LT coating have reached or exceeded GB 18445-2001 standard.Comparisons on waterproofness with overseas typical products of the same kind Penetron 401 coating indicate that the waterproofness of LT coating is not lower than that of Penet...

经测试LT涂料的各项性能指标，均已达到或超过了GB18445—2001标准要求，并与国外具有代表性的同类产品Penetron401涂料进行了防水性能对比，表明LT涂料的防水性能不低于Penetron401产品，完全可以取代同类进口产品。

By diffusion of heavy metal ion into zinc oxide crystal,ACR-1 white antistatic thermal control coating is developed with acrylic resin.The space environment effects on the solar absorbtance of the coating and comparison with silicon white thermal control coating are investigated.

通过在氧化锌晶格中掺入重金属离子，得到具有防静电功能的白色颜料，再以丙烯酸树脂为粘合剂制备出空间飞行器外表面用的 ACR-1防静电白色热控涂层；研究了空间环境效应(包括紫外辐照，电子和质子辐照)对该热控涂层太阳吸收率的影响并与有机硅白色热控涂层进行了比较。

An AlTiN ceramic coating was deposited on the surface of biomedical Ti6Al4V alloy by High Ionic Pulse technology. The properties of biofriction and wear of AlTiN coating in simulated serum lubrication at 37℃ were investigated and compared with that of non-coating Ti6Al4V alloy.

采用高度离子化脉冲工艺在医用钛合金Ti6Al4V表面制备AlTiN涂层；在摩擦磨损试验机上测试了涂层在37℃的模拟人体生理血清液润滑条件下的摩擦磨损性能，并与之和未经涂层的Ti6Al4V合金作比较。

Finally, according to market conditions and market products this article paper analyzes the trends in the development of camera technology, and designs a color night vision camera.

最后根据市场情况和市面上产品的情况分析了摄像机技术的发展趋势，并设计了一款彩色夜视摄像机。

Only person height weeds and the fierce looks stone idles were there.

只有半人深的荒草和龇牙咧嘴的神像。