查询词典 coating paper

In the coating, the nodular defect was observed to worsen severely the properties. For testing under oxidation condition, the nodular defect results in the internal oxidation of Al. No single Al oxide scale may be formed at 1100℃ owing to consumption of Al. Under hot corrosion, it becomes as short-path for diffusion of S through the coating, thus sulphuring the coating together with the substrate. During thermal shock testing, it may act as the source of cracking, and moreover, if cyclic stress applied, the cracks propagate toward the substrate, the thermal fatigue properties of coating will be worsened.

结果表明：在氧化条件下，缺陷导致Al的内氧化，在1100℃时，由于Al的大量内消耗，涂层表面已不能形成单一的氧化铝膜，使氧化性能下降；在热腐蚀条件下，缺陷成为硫向涂层中扩散的通道，导致涂层及基体的硫化；在冷热疲劳条件下，缺陷成为裂纹源，在交变应力作用下，裂纹向基体中扩展，降低了涂层的热疲劳性能。

B〓C coating possessed 4% of porosity, 12. 8Gpa of bonding strength, 28Gpa of microhardness, and its modulus is up to 230Gpa. It would provide a kind of coating material with excellent properties for many industrial fields.(2) The phase composition of B〓C coating was studied by XPS, XRD and EDS. It was found that: the oxidation activity energy of B〓C powder and coating is different, which is due to the difference of phase composition between them.

用XPS、XRD和EDX研究了碳化硼涂层的相组成，发现碳化硼粉末在涂层形成过程中不可避免的存在分解；比较了碳化硼涂层和粉末在高温下的氧化行为，发现涂层的氧化活化能比粉末要低，这是由于涂层和粉末相组成不同所造成的。

The effect of domestic GCC and clay on pre-coating coverage of the coated kraft liner board was studied. In order to optimize the second pre-coating, the effect of using TiO2 and using calcined clay to replace part of the TiO2 as the pigment on the coating coverage in the second pre-coating was also investigated.

研究了国产GCC、高岭土两种颜料及其不同组合对涂布牛皮卡纸预涂覆盖性的影响，并在此基础上，对二次预涂进行优化，研究了二次预涂中添加进口钛白粉及用国产煅烧高岭土部分代替进口钛白粉和高岭土对涂层覆盖性的影响。

Nanometer diamond composite coating drawing die, is a kind of completely new product which is deposited a composite coating of traditional diamond coating and nanometer diamond coating by CVD method on the surface of die hole (especially reduction angle and bearing ) of Tungsten Carbide drawing die and then be polished by mechanical means and plasma means.

纳米金刚石复合涂层拉拔模具，是以硬质合金为衬底，采用化学气相法在模具的内孔表面涂覆常规金刚石和纳米金刚石复合涂层，并对涂层进行研磨抛光后得到的一种全新产品。

The results show:(1) After soybean seed is treated with seed coating, The length of lateral root anlage Initiating area obviously increases in contrast with control (seed which is not coated with agent is regarded as control; shortened form is CK).The order is from greatness to smallness in turn as follow: HK＞ND＞CK.(2) Initiating progress of lateral root anlage is quickened when seed is treated with seed coating. General trend is as follow: HK＞ND＞CK. By variance analysis, treatment and control has obvious difference.(3) Initating status of lateral root anlage is definite related with contents of endogenous hormone. Occurring of lateral root is as the result of some endogenous hormone corresponded and playing manysided role, especially IAA plays important role in the cause of inducing to occurring of lateral root anlage.(4) The use of seed coating may elevate the number of lateral root anlage occurring and shorten the time of lateral root anlage occurring, especially the effect of Chemical control seed coating is better.

结果表明：(1)种衣剂包衣后，侧根原基发生区长度明显比对照(不包衣的种子为对照，用CK表示)增加，从大到小依次为：HK＞ND＞CK；(2)种衣剂处理加快了侧根原基的发生进程，总的趋势是HK＞ND＞CK，经F检验表明，处理和对照差异极显著；(3)侧根原基的发生状况与侧根原基发生区内源激素的含量有一定的关系，侧根的发生是几种植物内源激素相互协调、综合作用的结果，其中生长素类物质在诱导侧根原基的发生过程中起主导作用；(4)应用种衣剂可以提高侧根原基发生的数量，缩短侧根原基的发生时间，其中以化控种衣剂效果最好。

The results show that α-Al2O3 in the two kind s of coatings decreases while the γ-Al2O3 increases after spraying. Rutile-TiO2 transforms to brookite-TiO2 and the inners tress of coating was increased so as to aggravate the expansion of cracking. The pores are small but dense in the conventional coating while bigger but loose in the nano-structured coating. The pores in the nano-structured coating exist almost inside the partially melted region. The pores generated during spraying and the cracks generated during the course of thermal oxidization because of thermal stress are the direct reasons why coatings fail.

结果表明：2种粉末在喷涂之后，涂层中的α-A12O3均有所减少，生成了γ-Al2O3，金红石TiO2相转变成了板钛矿型TiO2相，增加了涂层的内应力，加剧了裂纹的扩展；常规微米涂层中的孔洞细小但密集，纳米涂层中的孔洞较大但不密集，且大部分的气孔都存在于部分熔化区的内部；涂层在喷涂过程中所生成的气孔以及热氧化过程中由于热应力而产生的裂纹是造成涂层失效的直接原因。

The polyurea coating was tested with Taber tribomachine and the highp ressure water jet erosion tester for studying the wear behavior of polyure coating under conditions of dry friction and highspeed water jet contained sand. The morphology of the coating was observed with SEM and Chromatic confocal 3D Profiler. The surface component of test samp les was measured by FT2IR Spectrometer and Electron Energy Disperse Spectroscopy. The p roperties of polyurea coating under two testing conditionswas analyzed.

为研究聚脲涂层在干摩擦条件下和高速含砂水流冲蚀条件下的性能变化情况，用 Taber 磨损试验机和高速含沙水射冲蚀磨损试验机测试了聚脲涂层的磨损性能，用扫描电子显微镜和白光共焦三维轮廓仪观测涂层的磨损表面形貌，用表面红外光谱和电子显微镜能谱元素分析了涂层表面试验前后的组分变化，分析了涂层在2种摩擦条件下的磨损情况。

Polishing machine coated roll and roll and penetrated the metering rollers, directly affects the product iuster is good or bad, such as coating roll and roll of clearance too large, you can Polish paper and coated rolls off the paper bad contact so that the oil absorption corresponding regarding the reduction of roll coating rollers and penetrated the size determines the amount of finish coating the, should be based on the paper--absorption of strong or weak, adjustment and coated roll roll the size of the gap in order to ensure that products on the light intensity.

上光机的涂布辊与衬辊和计量辊之间的间隙是否合适，直接影响到产品上光亮度的好坏，如涂布辊与衬辊的间隙调得太大，就容易使上光的纸面与涂布辊接触不良，使纸面吸油量相应就减少涂布辊与计量辊之间的间隙大小，则决定着上光油涂布量的大小，所以，应根据纸面吸收性的强弱，调整涂布辊与计量辊间隙的大小，才能确保产品上光的亮度。

The Shandong Laiyang silver passed the paper industry Limited company is a fair papermaking and the paper product production in a body's Major industry, the company founds in 1958, already developed into the national key special paper production base, the company presently has several international advanced paper mills, above 200 undergraduate course specialized paper technology talented person, 1000 papermaking backbone staff troop, the company main product included: Food packing paper/forgery-proof paper, the dictionary paper, the water printing paper,the bible paper/upscale culture uses the paper/fruit bag paper and the fruit bag and so on four big series more than 30 varieties.

山东莱阳银通纸业有限公司是一家集造纸与纸制品生产于一体的大型企业，公司创建于1958年，现已发展成为国家重点特种纸生产基地，公司现拥有数台国际先进造纸机，200余名本科以上专业造纸技术人才，1000余名造纸骨干职工队伍，公司主要产品有：食品包装纸/防伪纸，字典纸，水印纸，圣经纸/高档文化用纸/果袋纸及果袋等四大系列三十多个品种。

Mackintosh piled on the main chaetomium grey paper paper in the manufacture of petroleum paper processes in the business card printing and membership card production processes may occur in the anti-dropping paper, shedding and accumulate in blanket above, affect the imprinted ink dot, left the correct delivery, paper above paper and paper powder will pass the rubberand, block drum, after roller scurrying to sluicing inside, thus affecting the transport of monlchamus road, experience the paper off powder serious paper business card printing and membership card at the end of production of monlchamus tuhung riverbeds are gray, paper wool, paper powder, at which point inking at, imprinted inks are printed on your mind, and the cultiuation of 1 000 in the white paper in the blanket on adhension, you need to wipe down blanket.

不一、橡皮布上堆纸不净纸灰次给火油纸弛在创作发明工艺方背的来因，在制卡和会员卡制作历程洋不定会表现纸弛脱粉掉不净，并且积聚在橡皮布上背，感化痕迹不朱色的网点、图不白侧确传达，纸弛上背的纸灰、纸粉不离会堵住橡皮、印版滚筒，不纬过不朱辊窜的到不朱斗槽边背去，从而感化不朱路的传输，碰到纸弛掉粉惨轻的纸弛，制卡和会员卡制作到最后不朱斗边全是纸灰、纸不净、纸粉，此时不朱量闭到最不小，痕迹不朱色也显得醲郁露底，印上1000弛纸弛白花花黏附在橡皮布上，不离必给擦洗橡皮布。

Nowadays, most of research are to build a transmutative Petri Nets through adding controlling place sets, controlling arc sets and controlling policy to the basic Petri Nets, while the Controlled Petri Nets could be used to argue many controlling theory problems conveniently and to induce many logically and physically supervisory and solve the Event Feedback Controlling Problems and State Feedback Controlling Problem in DEDS supervisory theory.

目前大多数的研究表现为在变形后的受控Petri网基础上，利用各种方法求得各种逻辑型、结构型控制器，解决DEDS监控理论中的事件反馈控制问题与状态反馈控制问题。

On one hand, there are discussions with the works council and union about extension of short time working up to the end of September.

一方面，有讨论，工程理事会和联盟关于延长工作时间短至9月底。