查询词典 coating material

In order to research the influence of polyaniline on acrylic anticorrosive coating, the polyaniline/acrylic anticorrosive coating that the mass rate of emeraldine base form of polyaniline in coating was 0%, 1.5%, 3%, 5%, 10% were prepared, and theirs anticorrosive performance in 3.5% NaCl solution was studied by Tafel and EIS.

为了研究本征态聚苯胺对丙烯酸涂层防腐性能的影响，制备了本征态聚苯胺质量分数分别为0%，1%，3%，5%及10%的聚苯胺／丙烯酸防腐涂层，应用Tafel极化曲线和电化学阻抗谱方法对比了其在3.5% NaCl溶液中的防腐性能。

The results show that, there is a white zonal area between the AZ61 and Al-alloyed coating, which indicates that a good metallurgical bonding is obtained. The coating shows typical hypoeutectic structure. Due to lots of Mg17Al12 phases in Al-alloyed coating, the corrosion resistance of AZ61 magnesium alloy is increased obviously.

结果表明，涂层与基体形成了扩散白亮带，实现了较好的冶金结合；涂层具有亚共晶组织的特点；大量的Mg17Al12相存在于涂层表面是耐腐蚀性能提高的主要原因。

The results show that the composite coating is metallurgically bonded to the substrate and the microstructure is fine and uniform. The hardness of the composite coating is up to 400 HV, which is 2.5 times that of the substrate. Under room temperature and oil lubrication condition, the sliding wear tests indicate the friction coefficient and weight loss of the composite coating are smaller than those of substrate. The worn surface of the composite coatings is much smoother than that of the substrate, without grooves and crater.

结果表明，复合材料涂层与基体形成良好的冶金结合，微观组织细小、均匀；复合材料涂层硬度达400HV，约为基体的2.5倍；在室温油润滑条件下，滑动磨损试验表明复合材料涂层摩擦系数和失重均小于基体，磨损表面划痕较浅且平滑，无明显的犁沟、粘着、剥落现象；激光表面合金化显著提高了材料的耐磨性。

Alumina sols of different content were prepared by using Al3 as precusor, water as solvent, nitric acid as peptizer, ethylacetoacetate and polyvinylpyrrolidone as modified menstruum. We used dip-coating method and spin-coating method prepared of alumina films on the plane glass and used dip-coating method and rising liquid method inside the wall of the fiber.

以仲丁醇铝为前驱物、水为溶剂、硝酸为胶溶剂、同时加入乙酰乙酸乙酯和聚乙烯吡咯烷酮作为改性剂制备了不同浓度的氧化铝溶胶用提拉法和旋覆法在平板玻璃上镀膜，同时用提拉法和液面上升法在石英毛细管内壁上镀膜。

In the deep processing of agricultural and food products, there are some key technological problems of system design on the domestic traditional reelable vacuum aluminium coating system, including mass process parameters, bad process duplication, unstable production quality caused by complex operation, and high equipment failure rate. A newly developed reelable vacuum aluminium coating system with 1500 mm-wide thin plastic films was designed with high vacuum technology in order to satisfy the vacuum aluminum coating of more than 1500 mm-wide, such as polyethylene terephthalate, oriented polypropylene, polypropylene cast film, polyvinyl chloride.

为满足农产品及食品深加工中1500 mm幅宽以上的聚脂薄膜、定向聚丙烯薄膜、聚丙烯流涎薄膜、聚乙烯薄膜的真空镀铝，针对国内卷绕蒸发式真空镀膜机设备存在的工艺参数多、工艺重复性差、操作复杂、产品质量不稳定、设备故障率高等问题，采用高真空技术研制了宽幅卷绕蒸发式高真空镀膜机。

Because of having surplus weld reinforcement height and irregular seam form as well as the influences of polyethylene raw materials and coating process, the quality problems of ununiformity in thickness of 3PE coating and coating thickness reduction on helical seam occur.

由于螺旋埋弧焊管存在焊缝余高超高和焊缝形貌不规整等现象，加之聚乙烯原材料及涂敷工艺等因素的影响，会使三层PE防腐涂层出现涂层厚度不均、焊缝处涂层减薄等质量问题。

The paper machine comprises a headbox (100), a gap former (200), a press section (300) which comprises at least one extended nip press, a pre-dryer section (400) in which a web is dried applying at least cylinder drying (R1-R7), a pre-calender (500) in which the web is pre-calendered, at least one portion which is formed of a coating station (600) and an after-dryer section (700) and in which the web is coated on both sides applying a film coating method or a non-contact coating method and dried applying at least contact-free drying (710), an end calender (800) in which the web is calendered, and a reel-up (900) in which the web is reeled.

所述纸机包括流浆箱(100)；夹网成形器(200)；包括至少一个延展压区的压榨部(300)；至少采用烘缸(R1-R7)对纸幅进行干燥的预干燥部(400)；对纸幅进行预压光的预压光机(500)；由涂布站(600)和后干燥部(700)形成的至少一部分――其中，纸幅的两面都用薄膜涂布法或非接触涂布法对进行涂布，且至少采用无接触干燥(710)对纸幅进行干燥；对纸幅进行压光的端部压光机(800)；以及卷取纸幅的卷取部(900)。

Another line of four special coating equipment: all types of PA, PU waterproof paper velvet anti-flu flu candlelight wax coating, and another air breathable, coating weight of gold and silver, YPU, anti-UV, heat-resistant fire retardant, as well as the excellent Laguna plastic, DuPont Teflon, PVC and other calendered after the whole deal.

另有特种涂层设备线四条：各类PA，PU防绒防水纸感蜡感烛光涂层，另有透气透湿，克重涂金银，YPU，抗UV，防火阻燃耐热，以及优丽胶，杜邦特氟隆，PVC压延等后整处理。

They are FF testing methods, surface treatment technique, evaluation of the properties of surface modification layer, coating induced embrittlement, selection of coating materials, effects of SP and other surface modification on fretting fatigue resistance . A new coating technology combined with shot peening is proved in improving FFR of titanium alloy. The relation between fretting wear and fretting fatigue mechanism of titanium alloy are discussed on the basis of the experimental results. The main contributions are as follows:(1) Shot peening is the most efficient way in improving fretting fatigue resistance of titanium alloys. Working hardening, roughening and compressive residual stress are involved in the shot peened surface.

本文针对上述问题，从影响FF行为的关键环节：FF实验方法、表面处理工艺技术及表层性能评价、镀层引起的钛合金脆化行为、脆化机制及镀层材料的选择、喷丸强化因数和表面涂层对钛合金FF抗力的影响、FF与微动磨损的联系等，深入系统地研究影响钛合金FF抗力的控制因数，探讨FF机理，并通过喷丸形变强化与新型表面镀或渗层合理复合，达到进一步提高钛合金FF抗力的目的。

The coated article includes a glass substrate, a coating of an antimony doped tin oxide deposited on and adhering to the glass substrate and a coating of fluorine doped tin oxide deposited on and adhering to the surface of the coating of antimony doped tin oxide.

该涂敷制品包括玻璃底板、沉积和附着于该玻璃底板的锑掺杂的氧化锡涂层和沉积和附着于该锑掺杂的氧化锡涂层表面上的氟掺杂的氧化锡涂层。

According to my definition, the Manchurian Candidate is an experimentally created dissociative identity disorder that meets the following four criteria

根据我的定义，满州候选人是一个创造分离身份混乱的实验，它符合下述的4条标准

I'd be chuffed to play at a World Cup, but I have many years ahead of me in the game so I hope to have more opportunities.

我会chuffed发挥在世界杯，但我有很多年的比赛在我前面，所以我希望有更多的机会。