查询词典 coarsen

The present method has not only solved the field distribution computation of irregular domain, but also overcomed limitations of mesh dividing of the multigrid method when"coarsen"meshes.

本文将一种高效、快速求解Laplacc边值问题的数值计算方法——多重网格法引入到求解电子光学旋转对称场分布问题。

Thermal exposured at 175 ℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S′(Al2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175 ℃热暴露500 h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S′(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

With raising temperature and prolonging time of aging treatment, the TiC films coarsen gradually into block so that the notch sensitivity vanished from the alloy.

合金的缺口敏感性与薄膜状TiC沿晶界析出有着密切的关系，随着时效温度的提高和时效时间的延长，晶界薄膜状TiC逐渐变为块状，因而缺口敏感得以消除。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

Thermal exposured at 175℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S'(AI2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175℃热暴露500h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S'(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

After the vanadium content in PD3 steel was more than 0.33%, vanadium carbides would precipitate a lot, and make the lamellar gap sizes of pearlite abnormally coarsen, it was beneficial to toughness of material.

当PD3钢中钒含量增加到0.33%时，碳化钒将大量析出，并使珠光体片间距反常粗化，对韧性不利。

Most of non-equilibrium microstructures in the original microstructure dissolve into the α-Mg matrix due to the diffusion of the solute and then the remainder is melted firstly. The more the increasing of cooling rate or pre-deformation, the more the secondary dendrite arms are easy to coarsen.

原始组织中的非平衡共晶组织在加热过程中大部分扩散溶解而溶入基体中，剩余部分在加热过程中首先熔化；冷却速率越大或预变形处理以后的试样在熔化过程中更容易发生二次枝晶臂之间的合并。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失