查询词典 coagulum

It had no traces of humanity and I didn't believe those black signs made by the coagulum.

没有人的痕迹，那些从色带磨擦出来的黑疙瘩使我不相信。

However, in actual use, its performance and air tightness due to the extension of time, dust and ink residues in the mouth to reduce the increase in coagulum.

但在实际使用中，它的性能及气密性会因时间的延长、灰尘及墨水在此嘴的残留凝固物增加而降低。

Studies on the evolution of semen coagulum proteins have revealed that most of them carry an exon that displays a rapid and unusual evolution.

对于精液凝结蛋白进化的研究显示大多数蛋白的一个外显子发生迅速和非常规的进化水平。

The effective PE model could be established by injection of blood coagulum into right atria.

注入血块的数量及速度的不同，可分别模拟出PE临床急性肺心病型和猝死型。

As its coagulum, knowledge of technology is a productive element of commodity, playing a vital role in creation of value; meanwhile, knowledge of technology itself is also a commodity, having its own special user value and value.

作为其凝结物的知识技术既是商品的非实体性、生产要素，在价值创造中发挥着极其重要的作用；同时它本身又是商品，具有特殊的使用价值和价值。

Conventional thermodynamic calculation always can not achieve convergence for coagulum. In this article, this problem is well resolved through thermodynamic calculation including coagulum.

凝相物质相变过程用传统热力计算方法计算常常不收敛，本文研究了计及凝相相变过程的固体火箭发动机热力计算理论和方法，较好地解决了这一问题。

And VTMS is added in late stage of polymerization, in this situation the system has the lowest coagulum. When the hydroxyl value of such polymer increases, the coagulum decreases; and solid content of such polymer increases, the coagulum increases greatly, so it is difficult to get higher solid content emulsion.

采用正交实验方法，通过对有机硅改性丙烯酸乳液聚合过程中凝聚物含量、乳液粘度影响的研究，确定的最佳的反应条件是：以SLS/OP为乳化剂、比例为4/6、用量为2％、丙烯酸单体的用量1.5％、反应温度为75℃、改性剂VTMS用量是1.5％、改性剂后加入方式下聚合反应过程中有最低的凝聚物含量。

Transmission Electron Microscope and other properties testing results show that the complex emulsifier system is the crucial influence factor of the polymerization process and the properties of products. It may influence the coagulum content and reaction rate of the polymerization process, the performance, particle diameter,viscosity, electrolyte stability and storage stability of the emulsion products and the contact angle of the film.The initiator mainly influences the coagulum content and reaction rate.The acrylic monomers mainly influence the solid content, Minimum Film Formation Temperature of the emulsion and the Glass Transition Temperature of the film.The organic silicone monomer mainly influences the water absorption of the film.The reaction temperature mainly influences the reaction rate and conversion.The stirring intensity mainly influences the coagulum content of the polymerization process.

透射电镜等性能测试结果显示：复合乳化剂体系是硅丙共聚乳液的聚合过程及产品性能的主要影响因素，它可以对聚合过程的凝胶率、反应速率以及乳液的外观、粒径、粘度、耐电解质稳定性及贮存稳定性，还有乳液涂膜的接触角等造成不同程度的影响；引发剂主要影响反应速率和凝胶率；丙烯酸酯单体主要影响到乳液的固含量、最低成膜温度以及涂膜的玻璃化转变温度，有机硅单体主要影响涂膜的吸水率等；聚合反应温度主要影响乳液的反应速率和转化率等；搅拌强度主要是影响到聚合过程的凝胶率。

The comparative tests of the rheological properties between Alcalase induced soy coagulum and Magnesium Chloride/Calcium Chloride induced soy coagulum shows that the former one has higher hardness,lower strength,and 10 times higher adhesiveness of the latter one.

对Alcalase与盐类凝固剂氯化镁和氯化钙凝固豆乳的主要流变学性质比较发现，Alcalase凝固豆乳的硬度比盐类凝固剂大，凝胶强度比盐类凝固剂低，粘附性比盐类凝固剂高10倍以上，使凝胶较粘，乳清不易排出。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。