查询词典 co-twin

The metastability of Co fine particles with sub-micrometer and micrometer scale was investigated by cooling from high temperature and by applying external stress.

报道了亚微米以及微米尺寸的Co微粒在高温冷却以及应力作用下亚稳结构的稳定性及其结构转变特性。

The conversion of methane is more than 92%, and the selectivity for CO and H〓 is 90% at 700℃.

在常压、700℃的条件下，甲烷的转化率大于92%，H〓和CO的选择性均在90%以上。

The experiment results show that methanol is produced from absorbed CO〓 on the catalysts.

实验结果表明，甲醇是由吸附的CO〓加氢生成的。

Methanol cracking is a main source of H2 and CO.

甲醇裂解是H2和CO的主要来源。

HuiZhou Besthope MicroMotion Technology Industry Co., Ltd.

惠州市百宏微动技术工业有限公司HuiZhou Besthope MicroMotion Technology Industry Co。， Ltd。

A preparation method of nickel oxide-base cathode of fused carbonate fuel cell is to select alkali earth metal oxide, transition metal oxide and rare-earth metal oxide, mix with carbonyl nickel powder in the proportion of 0.01-15.00 mol%, add assistant and mix even into a slurry; after the slurry is formed into a biscuit by doctor-blade casting, sinter it into a multi-porous nickel plate; dissolve lithium nitrate and cobaltous nitrate with mole ratio of Li:Co-1:1 and citric acid or PVA in the distilled water to make a solution with Li of 0.00-0.5 mol/L; immerse the multi-porous nickel plate or nickel oxide plate in the solution, keep for 10-60 minutes under vacuum below 200 millibar, then dry in an oven at 75 degrees centigrade further transfer to a crucible electric furnace preheated 650 degrees centigrade for keeping the temp.

要約 熔融碳酸盐燃料电池氧化镍基阴极的制备方法属于燃料电池领域。选取碱土金属氧化物、过渡金属氧化物和稀土金属氧化物，按0.01－15.00mol％的比例与羰基镍粉混合，加入助剂，混合均匀成浆料；混合浆料流延成型为素坯后烧结为多孔金属镍板；将摩尔比为Li∶Co＝1∶1的硝酸锂和硝酸钴以及柠檬酸或聚乙烯醇溶于蒸馏水中，制成为0.005－0.5mol/L的溶液；将多孔金属镍板或氧化镍板浸入溶液中，在真空度低于200毫巴下保持10－60分钟；置于75℃的烘箱中烘干，转移至预热到650℃坩埚电炉中保温1－10小时；将此过程重复一次或多次即可。

This means that the residual strain in rolled alloy promoted the aging process. The influence of aging temperature on the room-temperature mechanical properties of 1〓, 2〓 and 6〓 alloys was tested and the results show that the 1〓 alloy without minor element additive is very sensitive to the aging temperature. Over-aging occurred easily when the aging temperature is somewhat higher, so it is difficult to control the aging treatment in production. The 6〓 alloy with combined Mg, Cr, Co additives showed less tendency of over-aging, the alloy can be aged in a wider temperature range and the mechanical property is stable. So the treatment process can be easily controlled.

对不同微量添加元素的1〓、2〓和6〓三种合金经热轧态时效后的室温力学性能表明，不添加微量元素的1〓合金对时效温度较敏感，温度偏高时容易产生过时效，且过时效的温度明显低于加Mg的2〓合金和同时加Mg、Cr、Co的6〓合金，这对生产过程中的工艺控制增加了难度，6〓合金的过时效倾向最小，合金可以在较宽的温度范围内进行时效，力学性能较稳定，使生产工艺较易控制。

Alarm for CO and SO MOKE Alarm and related portfolio machine debugging, testing, manufacturing processes, are quite familiar.

对CO Alarm和SOMOKE Alarm及相关组合机的调试、测试、生产制程，十分熟悉。

The method is used to investigate the reaction of myoglobin with CO after light excitation.

实验中以肌红蛋白为研究对象，由于肌红蛋白受光激发后，会与CO发生化学反应，导致系统的热力学量发生变化，从而引起系统折射率的变化。

The phase transition temperature increases and the transition ranges tends to be broad when PNIPA brushes were substituted with P or P(NIPA-co-NVP) brushes obtained by the copolymerization of NIPA with AA and NVP, respectively. However, the phase transition is not obvious if adding excessive hydrophilic comonomer.

结果表明，纯PNIPA刷的相变温度在29℃~33℃之间，通过共聚所得的单一P或P(NIPA-co-NVP)刷均使相转变温度提高，转变区域拓宽，当亲水性共单体的量过多时会导致相变过程不明显。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。