查询词典 clearance

If valve clearance needs to be adjusted, loosen the locknut on rocker arm adjusting screw. Turn adjusting screw until feeler gauge slips with a slight drag.

如果气门间隙需要调节，松开摇臂调节螺丝上的防松螺母，转动调节螺丝直到测隙规滑动时稍带阻力为止。

The proper clearance setting should be at 0.04-0.1mm. The adjustment is achieved by loosening the locknut (fig.2) and turning the adjusting screw. Tighten the locknut after the adjustment is achieved. Alter the initial 1 hour adjustment, this procedure should be performed a few every 2 hours of use.

正确的汽门间隙为0.04-0.1mm之间，间隙调整螺丝被一个固定螺帽固定住，先将固定螺帽放松就可以转动间隙调整螺丝(如图2)调整后每一小时检查固定螺帽有没有松掉，每2个飞行小时检查汽门间隙。

The proper clearance setting should be at 0.04-0.1mm. The adjustmentscrew. Tighten the locknut after the adjustment is achieved. Alter theinitial 1 hour adjustment, this procedure should be performed a fewevery 2 hours of use.

正确的汽门间隙为0.04-0.1mm之间，间隙调整螺丝被一个固定螺帽固定住，先将固定螺帽放松就可以转动间隙调整螺丝(如图2)调整后每一小时检查固定螺帽有没有松掉，每2个飞行小时检查汽门间隙。

Metal-slitting saws are thin, plain milling cutters, usually from 1/32 to 3/16 inch thick, which have their sides slightly "dished" to provide clearance and prevent binding.

开槽铣刀是一种薄型的圆柱形铣刀，厚度一般为1／32—3／16英寸。这种铣刀的侧面呈盘状，有间隙，可以防止粘连。

If it leaks less than 20 drops per minute, then either the bearing clearance is too small or else the oil line to the bearing is stopped up.

如果油漏的过多，轴承即以磨损；如果每分钟漏油少于20滴，那么或是轴承的配合间隙太小，或是油道堵塞。

If it leak s less than 20 drops per minute, then either the bearing clearance is too small or else the oil line to the bearing is stopped up.

如果油漏的过多，轴承即以磨损；如果每分钟漏油少于20滴，那么或是轴承的配合间隙太小，或是油道堵塞。

The following example scopes show how these modifiers can be used in clearance rule definitions

以下的例子表示了这些表达式在间距控制的定义中的使用方法。

Results All of the 24 cases syndromes were cured by puncture pumping or operative extirpate.The pathology examination result showed that sheet granules spread in the clearance of muscular cell,which HE dyeing was light blue.Fiber tissue seemed to surround the rather big eye winkers and encroached by lymph cell.

结果：24例并发症均经穿刺抽吸或手术摘除治疗，4例注射部位肌组织病理检查显示：肌细胞间隙均散布有大小不等的片状异物颗粒，HE染色呈淡蓝色，较大异物周围似有纤维包囊，有淋巴细胞浸润。

The sound field in the volute and the sound power levels of the cut-off noise for three volutes with different cut-off clearance have been computed and the acoustic pressure distribution in space and change with time are discussed.

本文用此方法计算了三个不同风舌间隙的离心风机蜗壳声场及风舌噪声声功率，并讨论了蜗壳内声压场分布和随时间变化。

This company is the professional hoisting crane, hoisting equipment, shelf mounted unboxing, large hoisting equipment, plant equipment relocation, car transport, terminal handling and customs clearance on behalf of business and equipment insurance.

本公司系专业起重吊装、设备吊装、货架装拆箱、大型设备吊装、厂房设备搬迁、汽车运输、码头装卸及代报关和设备保险等业务。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。