查询词典 circuits

Switching Power Supply has three kinds of control circuits: Pulse Width Modulation, Pulse Frequency Modulation, Pulse Width and Frequency Modulation.

开关电源有三种控制方式：脉冲宽度调制、脉冲频率调制、脉冲宽度频率调制。

Portable products in most of the time in a dormant state, only the occasional run, manufacturers can allow processors and other circuits in most of the time in a low-power dormant, and when necessary to allow them in turn to higher energy consumption, high-performance status ; Google servers running mode is entirely different: most of the time they complete the appropriate amount of work, and sometimes also need full-load operation, but rarely in sleep mode.

便携式产品在大多数时间内处于休眠状态，只偶尔运行一下，厂商可以通过让处理器和其它电路在大多数时间内处于低能耗的休眠状态，在需要时让它们转入能耗较高的高性能状态；谷歌服务器的运行模式则完全不同：它们在大多数时间内完成适量的工作，有时也需要全负荷运行，但很少处于休眠模式。

These circuits compile with I2C fast-mode and USB full-speed I/O stages electrical Specification, respectively.

这两个电路各项性能指标均能很好的满足设计要求。

This investigation could be beneficial for the selection of annealing atmosphere in the internal gettering process during the manufacture of the integrated circuits.

此研究对集成电路生产中内吸杂工艺的保护气氛的选择有指导意义。

Inspecting dielectric strength of independent electric circuit over the ground and between electric circuits.

检验各独立电气回路对地及回路间的绝缘介电强度。

The design and simulation of the power/ground net is essential functions of the electronic design automation tools for high speed integrated circuits.

电源/地线网的设计和仿真是集成电路自动化设计工具中的重要功能。

Also, by using a novel offset architecture, as opposed to completely overlapped architecture, for the differential transmission pair, a 33% reduction of thickness is achieved in the design of a miniaturized common-mode filter with multi-layer LTCC technology. In view of increasing need of high-speed clock and data circuits to control their skew problems, a design of LTCC delay line is then conducted. To improve the waveform distortion associated with the microstrip/stripline-type meander delay line, a miniaturized high-frequency 3-D delay line with grounded guard traces is introduced. By means of 3-D structure, the 233 ps delay time, which requires extra board space amounting to a factor of 2.34 by stripline type meander delay line, can be shrunk into an EIA 1206 form factor.

为因应高速时脉及高速线路的不断发展，用於控制讯号、时脉同步的延迟线路需求日益增加，接著讨论的题目便是应用低温共烧陶瓷制程技术设计多层的延迟线路元件，为了改善在微带线/带线型折线式延迟线路波形失真的问题，论文中提出以接地的防护线来设计小型化的三维多层延迟线路元件，比较应用带线型折线式延迟线路和应用三维架构设计的延迟线路元件，同样提供233 ps的延迟时间，多层架构设计之延迟线路可缩小至EIA 1206 的尺寸，省下2.34倍的电路板面积。

The circuits are extra-thin and flexible and were hand-embroidered on to a layer of silk in a way to give it stretch.

的电路是超薄和灵活的手工刺绣到1层丝绸的方式给它舒展。

This curriculum designs needs to complete one take 51 monolithic integrated circuits as heart bond ADC chip signal gathering, processing as well as the demonstration system circuit design case.

本次课程设计需要完成一以51单片机为中心结合ADC芯片的信号采集，处理以及显示的系统的电路设计案例。

Also the usage of the calculation method of heat resistances in equivalent electrical circuits, by which the difference between the temperature of the attention point inside the lighting and environment temperature can be directly obtained.

本文对灯具的热传导计算方法进行了讨论，提出对于灯具的散热计算方法使用等效电路的热阻法计算，可以直接算出灯具内温度关注点与环境温度的温差。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。