查询词典 circuits

A novel contactless inductive charging system with its circuit topology for electric vehicles is proposed, and the equivalent models for the primary and secondary circuits are built based on the theory of mutual induction.

提出了一种新型的电动汽车无接触感应充电系统及其电路拓扑结构，建立了基于互感理论的一次侧与二次侧的等效电路模型。

Guidelines for the optimum inductor design are proposed from the point of view of the integrated circuits design and technology.

在此基础上，分别从集成电路设计和工艺实现的角度提出了电感的优化方法。

Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.

虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。

The number of circuits that can be fed input signals from an output device.

影响信号并使信号中的信息失真的一种干扰。

In high resistance circuits, the noise bandwidth is often limited by the time constant of the source resistance and input capacitance, and this value In this case, noise bandwidth is

在高阻电路中，噪声带宽常常受到源电阻和输入电容的时间常数的限制。这个数值为上述各种噪声带宽计算结果中的最小者。在这种情况下，噪声带宽为

In this paper, two harmonic current detecting methods based on the theory of instantaneous reactive power of three-phase circuits are analyzed and compared with different voltage condition.

分析了基于瞬时无功功率理论的三相电路谐波电流检测的两种算法，并根据算法原理在不同电压条件下进行了对比研究。

By the instantaneous power generated by the impact of voltage fluctuations in the computer hardware chips, circuits, resistors and so on.

由停电的瞬间产生的电压波动会冲击电脑硬件的芯片，电路，电阻等。

This paper uses a new method in which a intermediate variable is used to solve the problem of the controlled circuits. This method can make the calculation simpler.

本文介绍一种通过计算中间变量来求解含受控源电路的方法，这种方法可使含受控源电路的分析计算更加简便、灵活。

The global modeling is the intrinsical method for the vairous interactions in microwave devices and circuits.

全域建模是解决微波器件和电路中各种相互作用问题的根本方法。

Three elements should be calculated in first-order circuit, which can synthesise analytical solution. Second-order series RLC and parallel RLC both can be calculated by the general function, which uses the Matlab to calculate differential equations. Generally, second-order and high-order circuits use Laplace transformation to formulate circuit equation, and get analytical solution by using Laplace inverse transform.

一阶电路先计算3要素，后合成解析结果；RLC串联和并联的二阶电路采用自编的通用函数计算，自编函数采用了Matlab求解微分方程的符号运算方法；一般的二阶电路和高阶电路采用拉氏变换列写电路方程，再用拉氏反变换得到解析结果。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。