查询词典 circuit

By using the measure and research of the emulating two-port network parameters of using direct-current analysis and figure value output function of sinusoidal steady state circuit in circuit emulating sofeware PSPICE8.0,the measune and reseavch have solved the problem of the measuring purely resistive network of simple and odd one in traditional experimient,and also brought about the analysis of alternating current and direct-current for two-port network of any one complex and measure and research of Y、Z、T、...

利用电路仿真软件PSPICE8.0中直流分析及正弦稳态电路的数值输出功能仿真二端口网络参数的测量与研究，解决了传统实验中只能测量简单、单一的纯电阻网络问题，实现了对任一复杂二端口网络交、直流的分析及Y、Z、T、H等参数的测量与研究，为更多的不易完成的传统实验以及复杂电路的分析研究开辟了一条新路。

In order to avoid the analysis difficulties of DBD circuit in time domain method, a new fundamental wave analysis method of DBD circuit is presented since the current of inverter is closed to sinusoidal wave.

3为降低时域分析方法的复杂和烦琐，本文利用串联谐振电路工作时电流接近正弦波这一特性，提出了串联负载谐振式DBD电路的基波分析方法，推导了DBD电源中主要电气量的表达式。

At last, we show the effectiveness and the applicability of the improved snubber circuit through theoretical analysis and circuit simulation.

最后，通过理论分析和电路仿真，验证了改进型吸收电路的有效性和适用性。

This paper analyzes the working principles of the system and some key technical issues of the application based on the IGBT apparatus, which include drive circuit,snubber circuit,protection and controlling the quantity of heat, and so on.

论文分析了系统工作原理和提高调速性能的方法，研究了IGBT模块应用中驱动、吸收、保护控制等关键技术。

Based on the analysis of some configurations of the lossless snubber circuit, a lossless snubber circuit topology is proposed, corresponding theoretical analysis, simulation and experiment on IGBT is carried out.

在对已有的无损耗缓冲电路分析基础上提出了一种适用于IGBT的谐振无损耗缓冲电路的拓扑结构，并进行了理论分析和实验研究。

From LS method and singularity theory GS normal form of the circuit bifurcation solution is obtained, and that noly one circuit solution curve exists near bifurcation point is proved.

利用LS约化方法和奇异性理论，导出了非线性电路解分岔的GS范式，证明了电路转折分岔解附近只有唯一一条解曲线。

He used an oscillating circuit containing a spark gap as a generator, and a similar circuit as a detector.

他利用一个振荡电路，其中包括一个电花隙作为发生器，并用另一个相似的电路作为探测器。

Aimed at the problem of choosing the initial value when the Newton method is used to compute the controlling unstable equilibrium point, a practical and rigorous solving scheme was presented: by identifying the controlling load bus of the given fault, and using the Thevenin equivalent circuit to represent the rest of the system at the state of the post disturbance stable equilibrium point, using the steady equivalent circuit to represent the induction motor in composite load, and then using the torque characteristics of induction motor, a point near the CUEP is gained to be the initial value. The second order normal forms was used to approximate the stable manifold of CUEP, and the local approximating boundary of the region of attraction of the post disturbance stable equilibrium point was gained. Then just by simulating the state of the system at the fault clearing time, the transient voltage stability of the system could be determined.

针对采用牛顿法求取故障后系统主导不稳定平衡点(controlling unstable equilibrium point，CUEP)存在的初值选取难题，提出一种实用但不失严谨的解决方案：通过识别给定故障的主导负荷母线，对主导负荷母线以外系统由故障后稳定平衡点处的状态进行戴维南等值，对负荷中感应电动机部分采用其稳态等值电路，再由感应电动机的转矩特性求得CUEP附近的一个点作为近似的CUEP，以此为迭代初值可靠求得CUEP；采用二阶正规型来近似CUEP的稳定流形的方法求得近似的局部吸引域边界；由仿真得到故障清除时刻系统的状态并根据该状态是否位于吸引域内判断系统的暂态电压稳定性。

Memory circuit, dynamic and static ram circuit module

存储器电路，动态及静态随机存取存储器电路模块

This paper includes the main wiring design of the papermaking factories' substation, choice of the total step-down substation's transformer, short-circuit current calculate, primary equipment selection ,program design with relay protection, setting parameters for the distribution circuit design.

本文设计包括造纸厂变电所的主接线设计，总降压变电所与车间变电所变压器的选择，短路电流计算，一次设备的选择，继电保护方案设计与参数整定，供配电线路设计。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新