查询词典 circuit

The data can be picked off by a decoding circuit added to the power-conversion circuit on high-voltage terminal.

在高压侧，通过在能量变换电路中增加一个解码电路将控制信号提取出来。

A small aluminium resistor is added into reference current source circuit of the original major circuit, its influence on temperature range -50℃ to 150℃ can be limited to 1％～2％.

与现有的电路相比，本电路并没有改变原来的主电路结构，而仅仅在参考电流源中增加了一个小电阻。它在零下50℃到150℃的大范围内的温度效应被限制在1％-2％。

If a clock is added to a Boolean circuit, we obtain a device called clocked circuit that is equivalent to a finite automaton (but with a description that can be used to build a physical realization of it).

如果时钟被添加到一个布尔电路，我们获得的设备称为频率电路，是相当于一个有限自动机（但描述，可以用来建立一个物理实现它）。

One high-speed buffer circuit is added to the volume potentiometer to eliminate its influence on frequency bandwidth of the bridge circuit.

1，在音量电位器后增加一级高速缓冲电路，杜绝由于音量电位器对后级电路的频率带宽影响，音量控制方式使用并联型，有效提升音质，也降低了对电位器的要求，降低成本。

Core saturation and the rotor bar skin effects were directly taken into account in the field calculation. The adopted circuit equations are suitable for describing the stator windings and the special rotor-bar connections of BDFM. The waveform of supplied voltage source may be an arbitrary. Three-dimensional end effects were considered in the circuit parameter corrected by classical formulas. In addition, the coupling and constraint equations were used to handle rotor rotation without any process of remeshing.

其特点是：铁心饱和以及转子导条集肤效应可以直接在场的计算过程中加以考虑；采用的电路方程可以方便地处理无刷双馈电机定子绕组和转子端环的各种特殊连接方式，电压源可以是任意电压波型；三维端部效应可以通过传统的方法在电路参数中加以修正；采用耦合与约束方程来处理转子转动问题，而无须不断地对转子重新进行刨分。

When designing the step motor drive circuit of 5 phase 10 pat,89C2051 is adopted as the Loop allotter. The VMOS is adopted in power elements. It is designed as chopper-type constant current circuit.

设计五相十拍步进电动机驱动电路时选择了89C2051作为环形分配器，而功率器件选用电压型的VMOS管。

First it produces the pulse signal by the multivibratorwhich is consisted of 555 timer and send in the detecting coil to form the alternating magnetic field, then it asopts UGN3503 linear half-effect as prode to the magnetic field change into the voltage signal change,after enlargement electric circuit and peak value examination electric circuit,the signal be treated to send into ADC0809 modulus converter change moduluses, then the digital signal after the modulus converter is changed is sent into AT89C51one-chip computers afterwards, after the digital filter, AT89C51one-chip computers afterwards compares the data to the reference voltage and judges whether to have detected the metal and alarm.

这个系统是以AT89C51单片机为核心，首先由555定时器构成多谐振荡器产生脉冲信号送入探测线圈以形成交变磁场，然后经过线性霍尔器件UGN3503将磁场变化转换为电压信号的变化，经过放大电路和峰值检测电路，经数模转换之后输入到单片机中，由单片机对数据进行软件滤波之后，与基准值比较之后，判断是否存在金属和报警显示。

First of all, we analogize out the calculation formula of short circuit current in the distribution systems with dispersed generations through basic circuit theory.

文中首先以电路分析原理推导出含有分散式电源之配电系统的各种短路故障电流计算公式，续由这些公式分析在甚麼情况下的短路电流会最大以及并联位置和产生之短路电流的关系如何，最后利用电脑程式模拟并验证推论结果的正确性。

ABSTRACT: With the development of the times, digital electronictechnology has been popular in all of our lives, work, research,and all fields. This paper introduces a NC DC power supply, thepower consists of analogue power supply, display circuit, controlcircuit, digital-to-analog converter and circuit amplifier.

随着时代的发展，数字电子技术已经普及到我们生活，工作，科研，各个领域，本文将介绍一种数控稳压电源，本电源由模拟电源、显示电路、控制电路、数模转换电路、放大电路五部分组成。

The most relevant circuit laws being violated are those laws pertaining to a closed loop circuit: Ohm's Law, Joule's Law, Kirchoff's Mesh Law, etc. According to ordinary theory, a working circuit must be a complete loop of some sort.

最相关的电路的法律受到侵犯，是那些有关的法律闭环电路：欧姆定律，焦耳定律， kirchoff的网格法等，根据一般的理论，一个工作小组，电路必须有一个完整的闭环某种形式的。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。