查询词典 circuit binding

It is necessary to discuss and deliberate this type of circuit because they are widely used in many important fields of engineering,such as the switch test of high-voltage circuit-breaker,the research of controllable thermonuclear reaction,etc.

本文首先介绍了建立数学模型的方法，然后利用了时域中传统的微分方程法和频域中经典的拉普拉斯变换法对电路进行分析。

Focuses on a variety of magnetic starter circuit form, cabin air, the typical pump control circuits, refrigeration equipment, electrical control circuits, AC three-speed anchor machine control circuit.

着重介绍磁力启动器的各种电路形式，机舱风、泵的典型控制电路，冷藏设备的电气控制电路，交流三速锚机的控制电路。

Uses the 89S51 monolithic integrated circuit to take the system the control core, the crystal thyratron zero has triggered the way realization alternating current supply the soft start, finally uses the multi-purpose board to build the overall system electric circuit.

采用89S51单片机作为系统的控制核心，晶闸管的过零触发方式实现交流电源的软启动，最终采用万用板来搭建整个系统电路。

The system by 8,098monolithic microcomputers, the temperature sensor, the A/D switch, thekeyboard and the display circuit, the crystal thyratron triggers theelectric circuit and so on the controller which is composed and iscontrolled the object resistance furnace to constitute a closed-loopcontrol system.

系统由8098单片机、温度传感器、A/D转换器、键盘及显示电路、晶闸管触发电路等组成的控制器和被控对象恒温库构成一个闭环控制系统。

The intelligence motor soft starters partial hardware electric circuit has designed mainly includes the electric current, the voltage examination module, the crystal thyratron triggers and the pulse width enlargement electric circuit module, the numeral keyboard entry and the liquid crystal display output module.

设计了智能型电机软起动器的部分硬件电路，主要包括有电流、电压检测模块、晶闸管的触发及脉宽放大电路模块、数字键盘输入及液晶显示输出模块。

In recent years, cold cathode thyratron KN-22 is widely used in circuit, but here KN-22 is replaced by MOSFET. The circuit with MOSFET has stable and credible performance, it can output a pulse of -6.6～-8kV and the pulse width can be adjusted from 5ns to 10ns.

应用冷阴极闸流管KN-22作为开关线路比较广泛，但近年来我们改用MOS场效应管线路代替KN-22，该线路性能稳定可靠，输出脉冲幅度为-6.6～-8kV，脉冲宽度5～10ns可调，触发晃动小于0.5ns，触发延时30～40ns，单脉冲选出率为100%。

The composition voltage, the electric current double closed loop voltage-stabilized source, used the integrated phase shifting crystal thyratron module to do for the electrical energy transformation component, in detail has calculated the rectification main circuit main component parameter; In the pulse-duration modulation part, used the special-purpose integrated circuit to realize the frequency modulation to adjust the pressure, did take IGBT as the power transformation component, realized the output voltage frequency modulation to adjust the pressure, and has calculated the related parameter.

在调压稳压电压源设计中采用二阶工程设计法设计了电压和电流调节器，组成电压、电流双闭环稳压电源，采用集成移相晶闸管模块做为电能变换器件，详细计算了整流主电路主要器件的参数；在脉宽调制部分，采用专用集成电路实现了调频调压，以 IGBT 做为功率变换器件，实现了输出电压的调频调压，并计算了有关参数。

Working Principle Transmitter is composed of sensor and electronic element circuit, pressure of measured medium directly applies on sensor s ceramic diaphragm, force diaphragm to displace tinily in proportion to pressure of medium, under normal working condition, diaphragm displace no more than 0.025mm, electronic circuit detects this displacement, and convert it into standard industrial measuring signal i.e.(4~20mA) corresponding to this pressure.

工作原理变送器由传感器与电子元件线路组成，被测介质的压力直接作用于传感器的陶瓷膜片上，使膜片产生与介质压力成正比的微小位移，正常工作状态下，膜片最大位移不大于0.025mm，电子线路检测这一位移量后，即把这一位移量转换成对应这一压力的标准工业测量信号即（4～20mA）。

Transmitter is composed of senselectronic element circuit, pressure of measured medium directly applies on senss ceramic diaphragm, force diaphragm to displace tinily in proportion to pressure of medium, under normal working condition, diaphragm displace no more than 0.025mm, electronic circuit detects this displacement, convert it into standard industrial measuring signal i.e.(4～20mA) corresponding to this pressure.

变送器由传感器与电子元件线路组成，被测介质的压力直接作用于传感器的陶瓷膜片上，使膜片产生与介质压力成正比的微小位移，正常工作状态下，膜片最大位移不大于0.025mm，电子线路检测这一位移量后，即把这一位移量转换成对应于这一压力的标准工业测量信号（4~20）mA。

Transmitter is composed of sensor and electronic element circuit, pressure of measured medium directly applies on sensor s ceramic diaphragm, force diaphragm to displace tinily in proportion to pressure of medium, under normal working condition, diaphragm displace no more than 0.025mm, electronic circuit detects this displacement, and convert it into standard industrial measuring signal i.e.(4～20mA) corresponding to this pressure.

变送器由传感器与电子元件线路组成，被测介质的压力直接作用于传感器的陶瓷膜片上，使膜片产生与介质压力成正比的微小位移，正常工作状态下，膜片最大位移不大于0.025mm ，电子线路检测这一位移量后，即把这一位移量转换成对应于这一压力的标准工业测量信号（4~20） mA 。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。