查询词典 chloric ether

After the coagulation and sedimentation in the jar test with ferric chloride, the residual COD in the supernatant was 9000 mg/L which was further oxidized by chloric acid or with Fenton method. The COD removal efficient increased with the increasing of the dosage of chloric acid from 0.5 ~ 100 g/L or the H2O2/Fe2+ from 5/2.5 ~ 50/25 g/L, and the economical dosage were suggested as chloric acid 50 g/L or the H2O2/Fe2+ 50/25 g/L which resulted in the residual COD of 400 and 3300 mg/L individually for 95 and 63 % COD removal percentages. Oxidation test showed that only 5 minutes was needed for 92 % COD removal in the case of chloric acid dosage 50 g/L.

废液A经氯化铁混凝沉淀后，COD浓度可降低至9，000mg/L，仍未符合符合工业区污水厂进厂限值(＜650mg/L)，进而使用氯酸钠直接氧化法及Fenton法以去除剩余之COD，其操作条件范围分别为氯酸钠加药量0.5g ~ 100g/L ，而最适加药量为50g/L，及Fenton法H2O2/Fe2+加药量范围为5/2.5g/L~50/25g/L，其最适H2O2/Fe2+加药量为50/25g/L，两种方法处理后残余COD浓度分别为400mg/L及3300mg/L，去除率约为95%及63%，而依此判断氯酸钠氧化处理残余COD有较好之效果，且利用氯酸钠氧化速率快，5分钟就能有92%去除率，所需水力停留时间较短，由此实验建议利用氯酸钠直接氧化处理，最适加药量为50g/L。

The one chloric firedamp in the product, 2 chloric firedamp, 3 chloric firedamp and 4 chloridize carbon are couplet product.

产品中一氯甲烷、二氯甲烷、三氯甲烷及四氯化碳为联产品。

By means of GC, GC-MS, GC-IR, IR, H1-NMR,the reaction products were investigated and the results showed that there are camphene, limoneneN terpinolene, Me a -fenchyl ether, Me -terpinyl ether, Me bornyl ether and Me isobornyl ether containing in the products,and the content of the main product Me a -terpinyl ether is up to 42.5%,the selectivity is 44.7%.

采用GC、GC-IR、GC-MS、IR、H~1-NMR等对反应产物进行定量和定性分析，结果表明：微波辐射下α-蒎烯与甲醇的反应产物含有莰烯、柠檬烯、α-小茴香甲醚、异松油烯、异菠基甲醚、菠基甲醚、α-松油基甲醚等，在较好的工艺条件下，主产物α-松油基甲醚的得率为42.5％，选择性为44.7％。

The method is realized by that polyether ether ketone is added into concentrated sulfuric acid to carry out sulfonation reaction, thereby obtaining sulfonated polyether ether ketone, then the sulfonated polyether ether ketone is dissolved in organic solvent, N, N (1)-Carbonyldiimidazole is added to stir for one to three hours, coupling agent is mixed for stirring the reaction for 1.5 to 4 hours, then inorganic crosslinking agent is mixed to react under the temperature of 50 to 80 DEG C. Proton conductors are mixed to continue getting the mixed solution of the sulfonated polyether ether ketone or the inorganic crosslinking agent or proton conductors under the temperature. Finally the proton exchange membrane for a direct methanol fuel cell is obtained by that the mixed solution of the sulfonated polyether ether ketone or the inorganic crosslinking agent or proton conductors is/are processed through membrane forming, drying and exuviation.

该方法首先将聚醚醚酮加入浓硫酸中进行磺化反应得到磺化聚醚醚酮；然后将磺化聚醚醚酮溶于有机溶剂中，加入N，N′-羰基二咪唑搅拌1～3小时后加入偶联剂搅拌反应1.5～4小时，再加入无机交联剂在50～80℃下反应，然后加入质子导体继续在此温度下反应得到磺化聚醚醚酮/无机交联剂/质子导体的混合溶液；最后将磺化聚醚醚酮/无机交联剂/质子导体的混合物溶液成膜，干燥，脱膜即得到所述的直接甲醇燃料电池用质子交换膜。

The preparation of avermyctin emulsions in water was achieved by mixing the surfactants polyoxyethylene (10) octylphenyl ether (OP10), polyoxyethylene styrenated phenol ether (602), and polyoxyethylene (40) castor oil ether (EL-40) with polyoxyethylene (20) castor oil ether (EL-20), separatively. Emulsion stability was investigated by analyzing the hydrophile-lipophile balance, critical micelle concentration, and surface tension. Then, the surfactants of polyoxyethylene polyoxypropylene styrenated phenol ether (1601), block copolymer (L64), and octyl phenyl polyoxyethylene phosphonate were added to the emulsion made by blending EL-40 and EL-20, separatively. The stability of the emulsions was investigated further and discussed in terms of droplet size, surface tension, and zeta potential.

首先将辛基酚聚氧乙烯醚(OP10)、苯乙烯基酚聚氧乙烯醚(602)和蓖麻油聚氧乙烯(40)醚(EL-40)分别与蓖麻油聚氧乙烯(20)醚(EL-20)复配制备阿维菌素水乳剂，从亲水亲油平衡值、临界胶束浓度、表面张力等方面分析了二元表面活性剂复配对乳液稳定性的影响；其次，在EL-40与EL-20复配基础上，将苯乙烯基酚聚氧乙烯聚氧丙烯醚(1601)，嵌段共聚物(L64)和辛基酚聚氧乙烯醚磷酸酯分别添加到乳液中，从粒径、表面张力和zeta电势等方面考察三元表面活性剂复配对乳液稳定性的影响。

BHT is used as ether stablizer in chemical reagent diethyl ether、 industrial ether、 anesthetic ether, has more obvious steady effect than others, and doesn't influence ether's other quality index.

用bht作为乙醚稳定剂，应用于试剂乙醚、业乙醚、麻醉乙醚等均有比一般乙醚稳定剂更显著的稳定效果，而且基本上不影响乙醚产品的其它质量指标。

Alcohols, ketones, esters, alcohols, ethers common media are methanol, ethanol, ethylene glycol, propanol, etc., ketones medium with acetone, methyl ethyl ketone, etc., there are a variety of methyl esters of medium, ethyl ester, ether medium with ether, ethyl ether, butyl ether, etc., they basically did not corrosive materials can be used for the specific use of the property should also be under the media and related requirements to make reasonable choices.

醇类、酮类、酯类、醚类常见的醇类介质有甲醇、乙醇、乙二醇、丙醇等，酮类介质有丙酮、丁酮等，酯类介质有各种甲酯、乙酯等，醚类介质有甲醚、乙醚、丁醚等，它们基本没有腐蚀性，常用材料均可适用，具体选用时还应根据介质的属性和相关要求做出合理选择。

In general craft,∶ of 2 chloric firedamp ∶ of 35~30 of ∶ of =65 of 3 chloric firedamp 70, their scale can adjust, and 4 chloridize carbon occupies 7%~10% about.

在一般的工艺中，二氯甲烷∶三氯甲烷=65∶35~30∶70，它们的比例是可以调节的，而四氯化碳约占7%~10%。

The system can endure the change of chloric ion concentration by increasing from 8 500 mg/L to 12 500 mg/L or decreasing from 8 500 mg/L to 4 500 mg/L, and it is more tolerant to the sudden increase than that of the sudden decrease of chloric ion concentration.

系统能够忍受氯离子浓度从8 500 mg/L直接升到12 500 mg/L和从8 500 mg/L直接降低到4 500 mg/L的变化，且抗氯离子浓度突然升高的能力比抗氯离子浓度突然降低的能力要强。

And in Jiangsu can early absorbed domestic and international technology before two years, have development, research to technology of chloric hydrogen sulfide, through countless experiment, mastered skill of chloric hydrogen sulfide eventually, passed the sanction of bureau of national technology property right.

而江苏中能则早在两年前就吸收了国内外的技术，对氯氢化技术进行开发、探究，通过无数次的试验，终于把握了氯氢化技术，并通过了国家技术产权局的批准。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48