查询词典 chemical fiber
- 与 chemical fiber 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Independent research and development company products include: fiber optic test instruments (power meter, light source, optical multimeter), video and audio Optical, fiber optic transceiver, PDH Optical Multiplexer, Protocol Converter, fiber optic network to monitor the alarm system (Master Station Software , rack light source, optical power monitoring alarm rack Miriam), optical fiber protection equipment, etc. At the same time, agents have imported products: NOYES, FOD optical test instruments, OTDR, Optical Fiber Fusion Splicer, etc..
公司自主研发生产的产品包括:光纤测试仪表(光功率计、光源、光万用表)、视音频光端机、光纤收发器、PDH光端机、协议转换器、光纤网监测告警系统(主站软件、机架光源、机架光功率监测告警仪)、光纤保护设备等,同时代理的进口产品有:NOYES、FOD光测试仪表,OTDR、光纤熔接机等。
-
By taking cotton fiber in high yield cotton field of north Xinjiang as the object, the niche-fitness theory were introduced, through analysis the niche-fitness of cotton fiber in three mono-topping and multi-topping intercrop system treatment, the result showed, it is acceptable that evaluate cotton fiber quality by niche-fitness, the niche-fitness value of cotton fiber at the middle part of the cotton plant is the biggest that topping inJul.10th and Jul.25th in this three treatment, moreover, with the increase of topping times, compare with it's top part of cotton plant, the niche-fitness of cotton fiber at the low part of cotton plant have a raise tendency, the niche-fitness value of top and low part of cotton plant in multi-topping treatment is bigger than what of mono-topping.
以北疆高产棉田棉纤维作为研究对象,引入生态位适宜度理论,对三个打顶次数不同的处理的棉花群体棉纤维生态位适宜度进行分析研究,结果表明:用生态位适宜度来评价棉纤维品质是切实可行的,三个打顶处理中7月10日和7月25日打顶棉株棉纤维生态位适宜度均为中部最高,并且随着棉花群体打顶次数的增加,其下部棉纤维生态位适宜度较上部有逐渐增高的趋势,与一次打顶相比较,其二、三次打顶棉株上、下部棉纤维生态位适宜度均升高。
-
Then the MEMS solenoid type electromagnetic actuating and novel, frictionless and wear-free, and simple structure are designed for fiber-deflecting type MEMS VOA: One of the two coupled single mode fibers is completely fastened in one of the three aligned U-shaped grooves while the deflectable fiber is partially fixed in another groove with a long front section suspending over the wider groove as a cantilever beam. The two fibers, any one for input and the other for output, are well aligned initially so that the insertion loss is very low. Beside the deflectable fiber is a solenoid microactuator with a U-shaped permalloy core attracting a permalloy piece glued on side of the fiber cantilever so that the fiber is deflected and the optical power coupled between the fibers decreased continuously. Using MEMS solenoid as a continuous actuator and the novel structure of VOA are not seen in literature.
为光纤偏移型MEMS可变光衰减器设计了MEMS螺线管电磁驱动方式以及新颖的避免了静摩擦、磨损而且简单的整体结构形式:在硅基片的三段V形槽结构中,将两个对接单模光纤之一完全固定在基片上,只将另一根光纤的稍后部位固定于基片上而使其前端的一定长度悬空,形成一个悬臂梁结构;初始对准后两根光纤之间的光传输损耗很小;通过U型铁芯MEMS螺线管吸引固定于光纤悬臂梁上的坡莫合金片,驱动光纤悬臂梁连续偏移以使两根光纤之间功率传输系数连续变化,从而达到光功率连续衰减的目的。
-
Studies on basic working principles and designs of fiber lasersThe basic working principles as well as the major characteristics of laser and fiber lasers are firstly reviewed,including the interaction between light and matter, the laser oscillation conditions and the spectrum distribution,the gain characteristic and spatial hole burning effect,the influence of external environment on the stability of laser output and the actual limits of fiber laser bandwidth;The designs of bidirectional single-mode Er-doped fiber ring laser and multi-wavelength laser is then discussed,respectively;The characteristics of dynamic grating reflection spectrum of the fiber saturable absorber is systematically analyzed.?
在激光型光纤传感器的设计、实验现象的理论解释等方面做了如下的研究工作:光纤激光器的基本原理与设计方案概述了激光和光纤激光器的基本原理,包括光与物质的相互作用,激光振荡的条件及频谱分布等激光产生的基本原理:掺铒光纤的增益性质,空间烧孔效应和外界扰动对激光输出稳定性的影响,光纤激光器的实际极限带宽等光纤激光器的相关知识;分别讨论了双向单纵模环形腔激光器和多波长激光器的设计方案;系统地分析了掺杂光纤饱和吸收体中形成的动态光栅的反射谱特性。
-
The Surface composition of grafted PET fiber was characterized by ATR-FTIR. THE results showed that there were no obvious differences between ungrafted and graft PET fiber in the spectra ,except that the typical peak of-OH in 3100cm~(-1) appeared in both Citric acid treated PET fiber and Acrylic acid treated PET fiber indicated citric acid and acrylic acid had been successfully grafted on the surface of PET fiber.
对样品的接枝效果进行红外光谱表征,发现无论是经过丙烯酸接枝处理,还是柠檬酸接枝处理,处理前后纤维的红外吸收光谱图都没有明显的区别,说明接枝前后纤维的主体性质没变,但是,二者在3100cm~(-1)处都出现了羟基的特征吸收峰,说明柠檬酸和丙烯酸都已经接枝上了PET纤维表面。
-
In the middle of 20 century, agreat lot of scholars simulated the relation between the velocity of action potentialpropagated along a myelinated fiber or an unmyelinated fiber and the fiber diameteror the temperature. The results were according to the experimental results. But by far,there are lacking in the quantitative analysis of the velocity of action potentialpropagated along a myelinated fiber and an unmyelinated fiber.
本文首先分析了动作电位在无髓神经纤维上的传递机制,得出了可用跨膜电流的移动速度来等效动作电位传递速度的结论,结合电缆模型与 H-H 模型,建立了动作电位传递期间神经纤维的等效电路模型,并在此基础上推导出计算传递速度的公式,对其进行了验证。
-
The carbon fiber complex such as combinations of carbon fiber/glass fiber, carbon fiber/carbon particles/ceramic particles, carbon fiber cloth/resistance wire have been developed toward smart functional composites and in the future it must play more and more important role on smart engineering structures.
炭纤维与玻璃纤维的复合、炭纤维与碳颗粒及陶瓷颗粒的复合、炭纤维布与电热丝的复合及其应用,将成为未来大型构件的智能化发展的重要方向。
-
Based on traditional wood fiber processing way at home and abroad, this paper draws up mathematical description theory of wood fiber, finishes the mathematical description theory of single wood fiber, sum up the reason of low density of wood fiber at microcosmos state, completed the laboratory study on Micron Flake Fiber High Strength Board, set up the forming methodology of this kind of wood-based panel.
本文在总结国内外传统法木纤维加工的基础上提出了木纤维数学描述理论,进行了单个木纤维细胞的数学描述,总结了现在木纤维强度低的微观原因,完成了微米长薄片木纤维高强度人造板的实验室研究,创立了该板种的形成方法学,所提出的MFB形成理论体系和加工方式,是利用木材微纳米技术在人造板加工业中开创出的一片新研究领域,提出了微米纤维细胞劈裂的条件。
-
A radiant energy path means comprising a first optical fiber waveguide means and a second optical fiber waveguide means; sensing means prismatically configurated so as to provide a direct reflective path from said first waveguide means, through said sensing means, to said second waveguide means, said sensing means being fabricated from material which absorbs a portion of a monochromatic radiant energy transmitted along said direct reflective path through said sensing means as a function of temperature; a monochromatic radiant energy source means optically coupled to said first optical fiber waveguide means, thereby introducing said monochromatic radiant energy into said first optical fiber waveguide means; and detecting means optically coupled to said second optical fiber waveguide means for detecting the intensity of the monochromatic radiant energy transmitted along said direct reflective path through said sensing means, the detecting means correlating the intensity of the transmitted monochromatic radiant energy with the temperature of the sensing means.
温度传感器组成一个联合:辐射能走了一首手段包括光纤波导手段和光纤波导第二手段;硒干旱prismatically手段配置以提供直接从反光路波导首次表示,次传感手段粗糙说,第二说波导手段飒传感手段伪造身份证从物质吸收了部分单色辐射能直接传送沿线说重 flective路径通过说温度传感功能为手段;一单色辐射能来源地说,就是先光光纤耦合波导手段次 ereby介绍说,首先说成单色辐射能光纤波导手段;一丁光学检测手段波导光纤耦合说二是加大检测手段的单色辐射恩顺沿说传染途径通过直接反光说传感手段,次五是加大检测手段的传播相关单色辐射能与温度传感手段。
-
The method includes the following steps: getting specific amount of knitted or unknitted natural fiber and dipping the natural fiber in the aqueous solution of silane coupling agent for 1-100min, taking out and drying the natural fiber, thus producing natural fiber with modified surface; then pressing the polylactic acid into sheet in a plate vulcanization machine; disposing 2-10 polylactic acid sheets into a die and arranging one modified natural fiber sheet between every two polylactic acid sheets; pressing and molding the sheets; in this way totally biologically degradable polylactic acid composite material can be made.
该方法为:先取一定量的经过编织或未编织天然纤维,将其浸渍在偶联剂水溶液中1~100分钟后取出,经干燥后得到表面改性的天然纤维。然后,将聚乳酸在平板硫化机中压制成薄板;将2~10片聚乳酸薄板放在模具中,且每2片之间放置1片改性的天然纤维,然后模压成型,得到可完全生物降解聚乳酸复合材料。
- 相关中文对照歌词
- The Motions
- The Chemical
- Chemical Love
- Chemical Rush
- Chemical Love
- Slow Chemical
- Chemical Tribe
- Chemicals
- Chemical
- Chemical Infatuation
- 推荐网络例句
-
The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.
论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。
-
I have not really liked him,I do not like his this kind of disposition.
我没有真的喜欢他,我不喜欢他的这种性格。
-
As we know the price of traditional product is composed of the cost and the profit of the company involving market competition, monopolizes and many other factors.
我们知道作为传统的商品,定价的模式往往是在成本的基础上增加厂商的预计利润而形成其价格,当然也要考虑到市场竞争、垄断等其他方面的因素。