查询词典 charging by contact

Use k-12 contact angle meter to measure the contact angle of pieces in four groups and do statistical analysis.

用k-12接触角测量仪测量四组试件各自的接触角并进行统计分析。

E. exserta has smaller contact angle and better wettability than that of E.citriodor, for instance, the contact angle of E.

窿缘桉比柠檬桉具有更小的表面接触角和更好的表面润湿性能。

Anthropometry is one of the most important basic tasks in the apparel industry. At present, there are mainly about two methods of human body measurement, including contact measurement and non-contact measurement.

人体测量是服装设计过程中十分重要的基础性工作，现行服装行业中人体测量的方法主要有接触式和非接触式两种。

Finally, a two-mask process was attempted to extend the same concept of the chip process. Here the mask of the contact aperture was replaced by the mask of the LED pad. After etching the SiO2 and ITO in the aperture region, a lateral etch of SiO2 was made to increase the ITO contact area. Although the forward voltage of the GaN LED shows a normal value, the process yield is still low and requires further study.

二道光罩制程延伸了三道光制程的理念，只是因为透明导电层的圆孔图形，是用电极的光罩去开的，所以蚀刻完二氧化矽膜及氧化铟锡膜后，必须再做二氧化矽膜的回蚀刻，让二氧化矽再内缩进去，以增加氧化铟锡和电极的接触面积，不会造成发光二极体的顺向电压提高，但因制程良率太低，所以还须要继续研究改善。

Step 6 shows how the strokes' strength lies inward from the contact spot, as an arc to a tangent, and that head-on contact creates a right angle against the ball's flight line, 6B.

图7G。第6课展示了击球的力量来源于从触球点的内旋，是球切线上的一道弧线，迎头碰撞与球的飞行路线产生正确的角度， 6B。

By applying the difference arithmetic to solve the differential vibration model of the single-degree-of-freedom,the acceleration responses of the vibrated bevel wheel was calculated.The bevel wheel contact fault was simulated by taking it as the impulsion loading in local point.By using techniques of wavelet de-noising and demodulated resonance,gear contact character information was picked up successfully.

从齿轮的单自由度振动模型出发，运用差分算法对模型进行求解，得到斜齿轮的振动加速度响应，将齿面接触型故障等效为在局部点突加一个冲击载荷，对齿轮齿面接触型故障进行了仿真，利用小波降噪和共振解调技术分别对仿真的染噪振动加速度信号进行处理，成功地提取了轮齿接触故障的信息。

In the course of numerical calculation, the influence among asperities, the coupling problems of the variation of temperature and pressure on contact surfaces, the variation problems of the maximum temperature, maximum contact pressure, maximum stress were taken account into.

在数值计算过程中，着重考虑了微凸体之间的相互影响，温度变化与接触区域压力变化的耦合问题，最高温度、最大接触压力以及最大等效应力的变化问题。

The contact pressure and temperature distribute only at the asperities in real contact. The equivalent stresses have been interpreted in light of VonMises and Tresca principle.

粗糙实体上的接触压力和温度场分布均表现出明显的不均匀性，只分布在少数实际接触的微凸体上。

Real contact between two surfaces occurs only at the asperities, which resulted in the fact that the asperities in real contact carry high load and are prone to elasto-plastic deformation.

摩擦副接触表面的接触只发生在极少数微凸体上，导致这些微凸体承受了较大的载荷，极易产生弹塑性变形。

Under the basis of fracture topography analysis, the micro-contact model of asperity and the contact process between two fracture surfaces have been studied.

在裂缝拓扑特性参数分析的基础上，对裂缝接触的微观弹性模型和自然裂缝的实际接触过程进行了深入地分析。

But our empire has been weakened, and war...

但是目前我们的帝国已经被严重削弱了，而战争

When you have a chance or enough money and time, you can travel around the world.

当你有一个机会，或者有足够的时间和金钱，你能周游全世界。