查询词典 characteristic curve

In this paper, a region approximation idea that means using a "fat curve" with a width to approximate the offset curve is proposed, and a complete set of algorithms to approximate offset curve using disk Bézier curve are given and implemented. In the algorithms, the optimal and uniform approximate curve of the offset curve as the central curve of the Disk Bézier curve is found by using Remez method, and then the upper optimal and uniform approximation principle is proposed to compute the error radius function of the Disk Bézier curve. Thus, the whole Disk Bézier curve can be obtained. In the end of this paper, the approximate effect of the Disk Bézier curve is not only analyzed and assessed, but also some specific examples are provided.

提出用一条带宽度的"胖曲线"来逼近上述等距曲线的区域逼近思想，并建立与实现了圆域Bézier曲线等距逼近的整套算法，包括应用Remez方法求出等距曲线的最佳一致逼近曲线作为圆域Bézier曲线的中心曲线，提出上控最佳一致逼近的原理求出圆域Bézier曲线的误差半径函数，以及确定整条圆域Bézier曲线，最后还对该圆域Bézier逼近的效果做了分析和考核，并给出了一些具体实例。

This paper establishes cubic spline function, analyzes subsection curve function and curve slope and curvature, at last decides to place the curve especial points which can be obtain easement curve length and other line parameters, such as the ZH point (end of line and beginning of transition curve), the HY point (end of transition curve and beginning of circular curve), the QZ point, the YH point (end of circular curve and beginning of transition curve), the HZ point (end of transition curve and beginning of line).

针对公路平面线形的8种组合类型，其线形元素特征则由最基本的直线、圆曲线、缓和曲线组成的特点，解析三次样条函数模型，得分段曲线函数、曲线斜率、曲率，从而确定曲线特征点（直缓ZH点、缓圆HY点、曲中QZ点、圆缓YH点、缓直HZ点）位置，进而得到曲线缓和曲线长度及其他线形参数。

As the complete characteristic curves of reversible pump turbine are often used to calculate the instantaneous parameters, this paper studies the characteristic curve and the wicket closure and opening law in pumped storage plants.Chapter 1 presents the importance and the necessity of this study and reviews the previous related research on hydraulic transient process and valve regulation in pumped storage plants.Chapter 2 analyzes the six collected characteristic curves of reversible pumped turbine and studies their diversification from the point of view of specific speed. The six collected discharge and moment curves with maximum efficiency have been fitted to piecewise continuous curves. This curve-fitting procedure is listed.Chapter 3 takes Liyang Pumped storage plant as an example and analyzes the effect of different characteristic curves on regulation guarantee parameters and the variety of its trochoid during the same operation status.Chapter 4 takes three pumped storage plants with different heads as examples and studies the characteristic of coordinated closure with wicket gate and ball valve and its effect on dynamic pressure in the spiral case, inlet pressure in the draft tube and the rise of rotating speed.Chapter 5 summarizes this paper and point out what should be done in the future research.

由于在过渡过程分析计算中，需要频繁利用可逆式机组的全特性曲线推求机组的瞬时参数，所以本文就特性曲线及关闭规律问题进行了研究，其主要内容如下：第1章，指出本文研究的意义和目的，回顾前人对水力过渡过程、抽水蓄能电站及阀调节的研究成果，在此基础上提出本文的研究内容；第2章，针对收集到的六套特性曲线，从比转速的角度出发来研究可逆式机组特性曲线的变化规律；并对六套曲线的最高效率流量和力矩曲线进行分段拟合，得到各分段函数的具体形式，再通过举例说明最高效率曲线的拟合步骤；第3章，以溧阳抽水蓄能电站为实例，分析讨论不同比转速特性曲线对调保参数造成的影响及对于相同工况其轨迹线的变化；第4章，结合高、中、低三水头段抽水蓄能电站，在导叶直线关闭的基础上，研究导叶与球阀协联关闭规律的特点及对蜗壳动水压力、尾水管进口压力及转速上升造成的影响；第5章，总结全文，提出今后研究的重点和方向。

Finally it analyzes the feasibility that using hydromechanics to analyze traffic flow by contrasting various characters between traffic flow and fluid flow. It analyzes influence of road alignment to basic expressway segment capacity by hydromechanics, and obtains viscous resistance and viscous movement differential equation when the vehicle drives on circular curve segment of expressway. And it infers that viscous resistance is correlated with sideway force coefficient, slope of crown and radius of circular curve. Radius of circular curve, sideway force coefficient and slope of crown are bigger, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on nearside lane of circular curve; but radius of circular curve and sideway force coefficient are bigger, slope of crown is smaller, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on fast lane of circular curve.

最后通过对比交通流与流体流的相似性，运用流体力学分析了道路线形对快速路基本路段通行能力的影响，求出了车辆在曲线路段的粘性阻力，建立了车辆在曲线路段的粘性运动微分方程，并由此推知，粘性阻力与横向力系数、路拱横坡度和圆曲线半径都有关系，当车辆在圆曲线外侧车道上行驶时，圆曲线半径、横向力系数和路拱横坡度越大，粘性阻力就越小，对道路的通行能力影响就越小；而当车辆在圆曲线内侧车道上行驶时，圆曲线半径和横向力系数越大，路拱横坡度越小，粘性阻力就越小，对道路的通行能力影响就越小。

Result: Scoliosis was identified in 58 cases with Marfan syndrome (38 males and 20 females), the prevalence rate was 42.03%, male-female sex ratio was 1.18:1, 6 cases were in younger than 10-year-old group. 12 cases were in 11~20-year-old group, 19 cases were in 21~30-year-old group, 11 cases were in 31~40-year-old group, 7 cases were in 41~50-year-old group, 3 cases were in 51~60-year-old group. Mean magnitude of Cobb angle in coronal plane was 26.8°±27.8°, the types of scoliosis curve included thoracic curve (36 cases), thoracolumbar curve (11 cases), lumbar curve (2 cases), double curve (6 cases) and triple curve (3 cases), apex vertebraes were convex to the right side among single curves in 38 cases while 11 cases were convex to the left side. Mean magnitude of kyphosis in sagittal plane was 14.3°±13.2°, 5 patients had thoracic lordosis and 40 patients had hypokyphosis and 12 patients had normal kyphosis.

结果：58例(42.03%)患者合并脊柱侧凸，男38例，女20例，男女患病率比例为1.18：1，其中≤10岁6例，11~20岁12例，21~30岁19例，31~40岁11例，41~50岁7例，51~60岁3例；平均冠状面Cobb角为26.8°±27.8°；胸弯36例，胸腰弯11例，腰弯2例，双弯6例，三弯3例；单弯中顶椎凸向右侧38例，凸向左侧11例；矢状面胸椎后凸平均为14.3°±13.2°，其中胸椎前凸5例，胸椎后凸不足40例，胸椎正常后凸12例，仅1例胸椎后凸45°；11例患者冠状面Cobb角＞40°，平均年龄15.9岁。

From a neutral gray balance curve, the curve Y, m, and the basic coincideut from neutral gray balance curve, the curve Y, m, and C coincideut basic curve the Y, m into a bow-shaped curve.

而从洋性灰不均弧线来看，Y、M弧线根基重分，而从洋性灰不均弧线来看，Y、M弧线根基重分，而C弧线则矮不入Y、M成为一条弓形弧线。

Flow characteristic curve, flow-pressure characteristic curve of steering control unit and load-speed characteristic curve, null region of system are given through analyzing the static model.

在此基础上，对各元件和系统进行静态分析，得到转向器流量特性曲线，流量—压力等曲线以及转向系统的速度—负载曲线和死区范围等相关静态特性。

On the studies of three different assist characteristic of EPS, the method of founding curve type assist characteristic is discussed and the curve of assist characteristic is trained offline by neural network. And with the toolbox of MATLAB, the perfect expression of assist characteristic can be obtained.

本文对三种不同形式的EPS助力特性进行了理论上的分析，在离散助力特性研究的基础上，探讨了初步确立曲线型助力特性的方法，并提出以神经网络对助力特性曲线进行离线优化训练，通过MATLAB工具箱拟合得到了比较理想的电动助力系统的助力特性表达式。

For a general parametric curve/surface, we usually cannot compute its exact implicit form. Even though its exact implicit form can be computed, the curve/surface implicitization involves relatively complicated computation and the degree is higher. Moreover, it may have unexpected components and self-intersections. All these unsatisfied properties limit the applications of the exact implicitization. So finding curve/surface approximate implicitization has become a practical problem. In this paper, we present an algorithm to solve the approximate implicitization of a given parametric curve by using a quadratic algebraic spline curve.

由于精确隐式化过程不一定可以实现，即使可以实现隐式曲线曲面的阶数高计算复杂，并且具有不希望的自交点和奇异分支，从而限制了隐式化的运用，所以寻求参数曲线曲面的近似隐式化问题成为很实际又重要的问题，提出利用二次代数样条曲线来实现一般平面参数曲线近似隐式化的一种算法。

This article first introduces the math foundation required by ECC,including the addition rule for elliptic curve point defined over finite field.Then , the principle of ECC is discussed and its security and efficiency of ECC are analyzed.Third, a cryptosystem is designed through analyzing the security requiration, choosing the elliptic curve domain parameters,denoting field element,elliptic curve and elliptic curve point,choosing associate primitves and schemes andpartitioning functional module.Forth, how to develop a crytosystem based on elliptic curve encryption algorithm is investigated.Fifth, a cryptosystem we have developed by us and the testing result is described.

本文首先介绍了ECC的数学基础，对有限域上椭圆曲线点的运算规则进行了详细描述；其次探讨了ECC的原理，分析了ECC的安全性和有效性；第三，设计了一个基于ECC的加密系统，包括系统的安全需求分析，域参数选择，域元、椭圆曲线、点的表示，原语和方案的选择，及整个系统的模块功能划分；第四，在设计的基础上，研究如何开发一个基于椭圆曲线的加密系统；第五，描述了一个我们已经设计与开发的基于椭圆曲线的加密系统，并给出了相应的测试结果。

"Yes, now you can give yourself airs," she said, you have got what you wanted.

"对了，您现在高兴了，"她说道，这是您所期待的。

Then the LORD said to me: Rebel Israel is inwardly more just than traitorous Judah.

上主于是对我说：＂失节的以色列比失信的犹大，更显得正义。