查询词典 channel-section

In this paper, we analyse the characteristic of the traditional collection card, which processes of multi- channel analog signal, introducing the principle and design project of the collection card, describing the relation of each module and scheduling of module in detail.

本文通过分析传统的多通道模拟信号的采集系统电路的特点，介绍了多通道可编程采集卡的总体设计方案及其原理，并详细描述了各个模块之间的状态关系和工作时序。

For example, if you wanted to measure a temperature, you would need to wire the temperature sensor to an analog input channel on the DAQ device in your computer (often via signal conditioning equipment, depending on the sensor).

举个例子，如果你想测量温度，你将需要用线连接温度传感器和你的电脑中DAQ装置的一个模拟输入通道（常常需要通过信号调节设备，这决定于所使用的传感器）。

Firstly, the design and implementation of Analog Channel in CR system is introduced, which takes on the responsibility of power control, dynamic frequency switch, and receive terminal for authorized user detection.

本文首先在认知无线电实验系统中设计并实现了模拟通道，其任务包括执行功率控制和动态频谱切换的功能，以及作为授权用户检测的接收通道。

MS-500 option, can have analog channel sampling rates as high as 5 GS/s or 10 GS/s, respectively.

MS-500的选项分别有采样速率高达5 GS/s或10 GS/s的模拟通道。

The model selection and parameters optimization for analog channel were discussed. The Laplace model and the Gauss model in common used in the video frequency were researched.

讨论了模拟信道的模型选取和参数优化，研究了视频序列中常用的Laplace模型和Gauss模型，提出了一种带校正系数的虚拟相关信道参数估计方法，验证了虚拟相关信道更接近残差数据的真实分布。

Analog Control Channel.

模拟控制信道。

After adjusted the voltage of analog signal, corresponding channel selection was implemented with relay matrix. The analog signal is transmitted as the input of tested instrument.

输出的模拟信号经电压调整后通过继电器矩阵完成相应的通道选择，作为被测试设备的输入信号。

With the change of the interval, analog output channel outputs variant voltage to frequency converter that controls the speed of the motor.

根据载荷设定值的大小，系统根据等比关系将其模糊化成几个区间，并确定当前采集到的载荷的区间号，根据区间的变化赋予采集卡的模拟输出通道一定电压输出到变频器，最终控制电动机的转速，使整个加载过程保持平稳。

A high-speed electronic switch (12a) is used to present the analog information signal of each channel, taken in turn (12b), to the codec.

一个高速的电子开关被用来将每一话路的模拟信号依次地送往编、译码器。

"In FDM (typically used for analog signals) the channel is subdivided into subchannels, each with a different frequency width that is assigned to a specific signal."

在分频多任务，信道切割成次信道，每个信道具有不同的频率宽度，指定给特定的讯号。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。