查询词典 channel-section

We design a square lattice photonic crystal symmetry resonant cavity four-channel optical filter, the filter efficiency of every channel is high than 96%.

根据该条件，设计出正方晶格光子晶体对称式谐振腔四信道光滤波器，各信道滤波效率均高达96%。

Results show that the lightning channel is a good conductor, and electrons are the main carrier of channel current.

结果分析得出：闪电通道是良导体，电子是通道电流的主要载体；一般情况下，人工触发闪电的通道亮度比自然闪电通道大，而通道回击电流小于自然闪电。

From now on, this kind of the press does emission new channel oneself, the 2nd medium of communication that the press that be called releases, also make the main medium of communication that the press releases, become the hair linage of immediate impact the press to measure, affect the crucial channel of the press economic benefits and social benefit.

从此，这种报刊自办发行的新渠道，被称为报刊发行的第二渠道，也成为报刊发行的主要渠道，成为直接关系报刊的发行数量，影响报刊经济效益和社会效益的关键渠道。

After researching on open channel roughness coefficient, the authors conclude that coefficients n and k have a good relationship and fit out of n-k logarithmic equation. But smooth and rough open channel with different n-k equation, needing further study.

对明渠糙率系数的研究，得出结论：明渠糙率系数与系数k有良好的对数关系并拟合出n-k的对数方程，但是光滑床面和粗糙床面有不同的n-k方程，有待进一步研究。

The results show that a difficult-sheared region exists in the vicinity of the inner corner of the die channel; a dead zone at the outer corner of the die channel and obvious uniform shear deformation at the middle region of sample during ECAE processing are formed. The less-sheared regions caused by friction resistance are observed at lower and top parts, which are symmetric and gradually extend to the inner part along the sample longness. The less-sheared region percentage increases with ECAE processing.

结果表明：挤压过程中试样在模具通道内角点附近形成难变形区；在模具通道外角点形成变形死区；试样的芯部变形比较均匀，为明显的剪切变形；受摩擦阻力的影响，试样顶部和底部均出现了滞变区，该区域呈轴对称分布且沿试样长度方向逐渐向试样芯部扩展；滞变区比例随挤压的进行而增大。

The lose of count in multi-Channel pulse amplitude analyzer can produce the error of measured results. For nuclear spectrum measurement in nuclear analysis, the correction of dead time in multi-channel pulse amplitude analyzer must be considered.

核分析能谱测量所用的多道脉冲幅度分析器，在进行模数转换时需要一定的时间，会使分析器产生漏计数，给测量分析带来误差，需要对死时间进行修正。

An internal amplifier automatically adjusts the current channel gain to compensate for low-current channel-signal levels.

MAXQ3183和三相/3线以及三线/4线兼容，单电源3.3V 工作，典型低功耗为35mW。

Firstly, the Signal Noise Ratio characteristic of matched filter despread symbol and the distribution of coherent phase estimation error are derived. Secondly, the exact integration formula of BER for fading channel is presented, moreover, by using the Maclaurin series expansion of MPSK conditional Symbol Error Rate, the simplified BER approximations for BPSK and QPSK are derived over AWGN, Nakagami-m fading and Rayleigh fading channel.

首先推导了匹配滤波解扩符号的信噪比特性和相干相位估计误差的分布；然后给出了衰落信道中误比特率的精确积分式，并利用MPSK条件误符号率的麦克劳林级数形式，推导了AWGN，Nakagami-m衰落和瑞利衰落信道中BPSK，QPSK误比特率的简化逼近式。

According to the damage phenomena at the edge of electrodes, the thermal injection and relaxation characteristics of majority carriers were discussed. An injection model induced by minority carriers was proposed, which emphasized the surface field enhancement effect by non-equilibrium carrier channel, possibly leading to the ionization of the ambient gas above the filament channel.

结合电极边缘细丝状的破坏现象，讨论了电极边缘的热注入和内部多数载流子的弛豫特性，提出了少子引导的注入模型，强调了非平衡载流子通道引起的表面电场增强效应，可引起外部气体电离形成电离通道。

This research examines the interaction between the strategic transfer pricing commitment and downstream innovation in a supplier-manufacturer channel,and its influences on the optimal quoted delivery time and investment decisions.We model the channel operation in a make-to-order fashion and treat the demand as being linear in price and quoted delivery time.

以一个按照MTO模式运作，并且面临交货期-价格敏感性需求的"供应商-制造商"供应链为研究对象，对该供应链中上游供应商的战略性转移定价承诺与下游制造商创新之间的交互作用，以及这种交互作用对最优的交货期设定、转移定价决策，以及渠道内各合作伙伴的行为取向所产生的影响进行了初步探讨。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。