查询词典 ceramic

5 Wt% of P2O5 could give high content and prospecting SEM appearance of dental lithium disilicate glass-ceramic.

该玻璃体系中添加4.5 wt%的P2O5可以得到较高体积含量和理想显微结构的牙科二硅酸锂微晶玻璃。

The crystalline composition, microstructure and mechanical properties of experimental lithium disilicate glass-ceramic and IPS e.max Press were compared. No obvious difference in mechanical properties and crystalline composition was found between these two materials.

对比分析了实验二硅酸锂玻璃陶瓷和IPS e.max Press玻璃陶瓷的晶相组成，微观结构和机械性能，探讨了微观结构与性能的关系，并对牙科二硅酸锂玻璃陶瓷的自增韧机制进行了分析。

Oweing to the suitable coefficient of thermal expansion and refractive index of lithium disilicate crystals, lithium disilicate glass-ceramics could obtain high mechanical strength and translucent effect simultaneously, which show a brilliant future in dental aesthetic restorations. The purpose of the study was to investigate the effects of glass composition, content of P2O5 and heat treatment procedures on microstructure and properties of final glass-ceramic products.

二硅酸锂晶体具有适宜的热膨胀系数和光折射系数，与玻璃相能够达到良好的热力学和光学匹配，使得二硅酸锂玻璃陶瓷在具备较高机械性能的同时，仍能保持优秀的半透光特性，实现了高强度和美学效果的统一，在全瓷美学修复领域具有广阔的应用前景。

Its products are suitable for many industries such as pottery and porc elain ware for toilet sanitary ceramics, household china pottery and porcelain for daily use, glass-ceramic, powder metallurgy, rare earth chemical, magnetic material honeycomb ceramics, electric porcelain bridge and tile as well as structural ceramics.

业务涉及建筑卫生陶瓷、日用陶瓷、微晶玻璃、粉末冶金、稀土化工、新型建材、电瓷、技术结构陶瓷等多个行业。

Characteristic and fabrication technology of transparent electrooptic PMN-PT ceramic material.

PMN-PT透明光电陶瓷的材料特性及制备技术。

The giant ceramic ice cream created by Hsu Chia-Yu is enticingly cool and attractive. During the hot summer day people want to get as close as possible to sneak a lick.

许家瑜以陶瓷所创作的巨大冰淇淋散发出诱人的冰凉气息，在炎热的夏日让人忍不住想靠近舔舐一口。

The products use undee alloy belt and enwind on ceramic framework side stand, the surface is covered with dope which is insulating and can resistance to high temperature , it is good at emit heat and has the fixing bracket, the resistor has the ability of high power, low resistance, resistance to heat, easy to fix etc.

产品介绍：RXHG型涂料绕线电阻器是一种功率型绕线电阻器，该产品采用波状电阻合金带以侧立形式缠绕在陶瓷骨架上，表面被覆绝缘耐高温涂料，有利于散热，并配有安装支架，电阻器具有功率大，耐过载能力强，安装方便等特点。

The influence of sintering temperature and composition on the microstructure of Y-Ba-Cu-O superconducting ceramic prepared by reactive sintering was investigated. While the oxide powders react and sinter into the superconductor, transient liquid phase can disappear rapidly, and equilibrious liquid phase can promote the anisotropic growth of superconducting grains and isolate the grains.

本文运用X射线衍射、光学金相、扫描电子显微分析、热分析等材料研究手段研究了Y-Ba-Cu-O和Bi-Pb-Sr-Ca-Cu-O两个体系超导陶瓷的超导相与显微组织的形成过程，着重研究了液相在此过程中的作用，同时考察了显微组织与超导性能间的关系。

The effects of resins ratio, proportion of resin presents, different kinds of ceramic particles, impact angle, velocity of the erodent (alumina, silicon dioxide and calcite) and impact time (expressed by the weight of being used erodent) were demonstrated.

研究了树脂的配比、涂层中树脂的含量、增强体的种类、冲蚀粒子(刚玉、二氧化硅和方解石粉)的速度、冲蚀角度和冲蚀时间(用冲蚀粒子的用量来表示)等因素对涂层的冲蚀率的影响。

The results of the investigation showed that the best entrance angle of B〓C, B〓C/ C and Al〓O〓/ C ceramic nozzles is 11°, 14°and 16°respectively. Erosion wear model has been put forward. The B〓C and B〓C/ C nozzles exhibited a stress fatigue induced removal process under the condition of umber emery erodent impacting, and a brittle fracture induced removal process under the condition of white emery and SiC erodent impacting.

建立了不同磨损机理下的冲蚀磨损模型，提出了喷砂嘴的磨损属于多冲蚀机理并存的复合冲蚀机制。B〓C和B〓C/C陶瓷喷砂嘴在棕刚玉磨料的冲蚀下，主要表现为应力疲劳断裂冲蚀，在白刚玉和SiC磨料的冲蚀下，主要表现为脆性断裂冲蚀。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。