查询词典 case

A case in point centers on the ongo negotiations or antic网络地址ated eminent resolution of the Middle East peace process .

唯一恰当的CASE是正在停止的Abaway中东和平进程的谈判和预期达成的引人注目的决议。

First, the individuals who would be most likely to benefit need to be identified, writes editorialist Sanford Markowitz, MD, PhD, from Case Western Reserve University, in Cleveland, Ohio. Then, it needs to be shown that certain persons reproducibly demonstrate high COX-2 expression in independent adenomas or cancers, because of genetic predisposition or environmental exposures. And third, the work of Dr. Chan and colleagues needs to be extended by demonstrating that prevention of colon adenomas by aspirin or COX-2 inhibitors also involves blocking the development of the highest COX-2–expressing lesions, he says.

俄亥俄州克里夫兰Case Western Reserve大学的Case Western Reserve医师表示，首先，必须要拿找出最能受益的一群病患；接著，必须要能证实部分病患的独立腺瘤或癌症，因为基因及环境的影响，会一再地是高度表现COX-2的；第三，Chan医师与其同事的研究，需要透过aspirin或是COX-2抑制剂可以预防大肠腺瘤的作用，也牵涉到阻断COX-2表现病灶的生成。

The theory of high-strain dynamic testing of pile bearing capacity. The basic calculation expression of pile high-strain dynamic testing is rederived in a simple way, especially the semi-empirical analytical expression of wave equation . Besides, theoretically it has been proved that it's not necessary to have identic section hypotaxis along pile, and the application condition and reasonable operation have been pointed out. the CASE comprehensive method is suggested to replace the traditional CASE method. author has made a lot of improvement for the mathematical model of the matching analysis measured curves in the business software CCWAPC and scientific research software JXWAPC of which the author is in charge.

关于高应变动力试桩法的理论研究以简明方式重新推导了高应变动力试桩法基本计算表达式，尤其波动方程半经验解析表达式，同时从理论上证明了CASE法并不需要桩身等截面假设，亦指出了该方法的适用条件及合理使用办法，并建议利用CASE综合分析法取代传统的CASE分析法；作者在其负责编制的商业软件CCWAPC及科研软件JXWAPC中，对波动方程拟合分析法数理模型进行了一系列重大改进，考虑了灌注桩桩周土体的变形特性和动荷截作用下的非线性效应、大直径桩的横向惯性效应。

By now I hope you've read Case 1: Basic Indexes and Case 2: Table Design and Index Details so we'll jump straight into the action.

到现在为止，我希望你已经读了Case 1： Basic Indexes and Case 2： Table Design and Index Details。所以我们直接去优化。

Case-Based Reasoning is a memory-based method which utilizes old cases and experience to solve new problem, and it can be seen as analogism from a case to another case.

摘要基于案例的推理(Case—Based Reasoning)是一种基于记忆，利用过去的案例和经验来解决新问题的一种方法，它可以看作是从一个案例到另一个案例的类比推理。

Case-Based Reasoning is a memory-based method which utilizes old cases and experience to solve new problem, and it can be seen as analogism from a case to another case.

基于案例的推理(Case—Based Reasoning)是一种基于记忆，利用过去的案例和经验来解决新问题的一种方法，它可以看作是从一个案例到另一个案例的类比推理。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

Is this Case the Ke Xiang USA country makes enterprise or chairman Bill of company · Xifo promotes sales of the clue making Western-style clothes customarily being with salesman Mac · cowry, 5 famous sale promotion experts comment on and analyse the process, and reason having narrated a entire sale promotion all over US all round according to self experience is in progress to Case.

本Case以推销员麦克·贝柯向美国国家制造企业或公司董事长比尔·西佛推销定制西服为线索，叙述了一个完整的推销过程，并由全美5位著名的推销专家依据自己的经验对Case进行全面的评析。

Therefore,the Bayesian network inference based on CBR(Case-based Reasoning) is proposed in this ***,constructed a suitable description of cases using Bayesian network,assessed and retrieved the cases through technology of probability spreading,achieved machine learning through revising the acquired case and updating the conditional probability of Bayesian networks.

于非，引入了基于案例的推理方式—CBR，降出了基于CBR(Case-basedReasoning)的Bayesian推理，当用Bayesian网构造一个闭于案例的适开描述，且用概率传布技巧评价和检索案例，并通功建改未获得的案例和更旧Bayesian网络须要的后降概率入行教习。

Printers once kept the type for capitals and for small letters in separate cases; capitals were kept in the upper half of the type case and so became known as upper-case letters.

排版工人一度将大写字母和小写字母活字置于不同的格盘中；大写字模放在格盘上的上半方，故而又称为&upper-case letter&。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。