查询词典 carbonization

Since its inception in 2002, constant efforts in scientific and technological research, innovation developed using a variety of straw in rural areas and agriculture, forestry and waste, and industrial and living sewage sludge as raw material, rapid carbonization of the production process and ancillary facilities.

唐山市丰南区权达环保型煤有限公司自2002年成立以来，不断努力进行科学技术的研究，自主创新研制出利用农村各种秸秆及农、林废弃物以及工业、生活污泥为原料，进行快速碳化的生产工艺及配套设备。

A new type of porous silicon carbide was fabricated by filter paper-phenolic resin composite through mold-stacking, drying, carbonization and Si infiltration process.

以滤纸和酚醛树脂为原料，通过模压成型、固化、碳化和渗硅制备出微观结构均匀的多孔碳化硅。

The contamination of the different target, the oxidation and the carbonization during the sputtering process and the crystal structure of Pd all have the significant influence in the performance of the rare earth films.

研究结果表明，衬底温度为150℃，Ar~+的溅射气压为4.5×10~(-1)Pa时比较适宜；溅射过程中，不同溅射靶之间的相互污染、氧化、碳化以及Pd保护层结晶性能的好坏等都对稀土薄膜的性能有很大影响。

Ferric nitrate and cupric nitrate can catalyze carbonization process. It is discovered that the catalyst dispersion on alkaline surface is poor through catalyst adsorption study.

对单元催化炭化过程的研究发现，铁、铜的硝酸盐对炭化过程有催化作用，能够减缓炭化过程中挥发份的最大析出速度，有利于各向同性炭前驱体的形成。

It was found that the woodceramics underwent chemistry structure transformation contrary to uncarbonized wood powder during carbonization process on the basis of FTIR analysis, and the aroma structure in the woodceramics was increased.

木质材料和酚醛树脂的质量比为50：50时，在9KHz～1500MHz范围内，木陶瓷具有中等屏蔽效果(40～50)dB，可以用作高温环境下电气设备的电磁屏蔽材料。

The oxidized graphite was treated with phenol resin as coating agent to prepare composite anode material, which involves liquid-phenol-impregnation and carbonization process.

球形石墨上采用氧化-浸渍-固化-炭化的方法沉积一层酚醛树脂热解炭，制备成包覆石墨，对包覆石墨电化学性能进行了研究。

The microstructures of the new developed carbon aerogels was investigated by means of low-temperature N_2 adsorption, TEM, XRD, XPS and etc. We studied the influence of synthesis conditions on the aerogels structure, such as reactant mass percent, catalyst concentration, carbonization process and supersonic.

采用低温N_2吸附、TEM、XRD和XPS等手段研究了碳气凝胶的微观结构特点，考察了反应物质量分数、催化剂浓度、碳化过程对气凝胶孔结构的影响，同时还研究了超声作用对气凝胶微观结构的影响。

In this paper several technologies, such as Fourier transform infrared spectroscopy, elemental analyzer, wide angle X-ray diffraction, field emission scanning electron microscopy, transmission electron microscopy and high resolution transmission electron microscopy were used to systemically investigate the evolution of crystal structure, chemical structure, microstructure and properties of wet-spinning and dry-jet wet-spinning PAN precursor fibers during proxidation and carbonization process, analysis the structural change of carbon fibers during graphitization, and discuss the correlation between the structure and properties.

本文采用傅里叶变换红外光谱、元素分析仪、X射线衍射仪、场发射扫描电镜、透射电镜以及高分辨透射电镜等测试技术，分别系统研究了湿纺原丝和干喷湿纺原丝在预氧化和碳化过程中纤维晶体结构、化学结构、微观结构和力学性能的演变规律，分析了碳纤维在石墨化过程中的结构转变，并对碳纤维结构与性能的相关性问题作了探讨。

The durability of concrete structure in general air environment, including concrete carbonization mechanism and influencing factors, steel corrosion mechanism and influences to the structural mechanical performance, cracks of concrete caused by the expansion of corrosion and the relation between width of crack and amount of corrosion, and the life estimation of reinforced concrete structure. At the same time, the paper introduced durability paint for concrete of xichang Cable-stayed bridge.

一般大气环境下普通钢筋混凝土结构的耐久性，包括混凝土碳化机理及影响因素、钢筋锈蚀机理及对结构力学性能影响、混凝土锈胀开裂及裂缝宽度与锈蚀量之间的关系以及钢筋混凝土结构寿命评价等，并利用以上理论对西昌斜拉桥钢筋混凝土塔柱进行了预测分析。

This milling shoe is a foundation with MP common milling shoe, in carbonization tungsten solder pregnant mounted high grade hard metal, increased the cutting capacity of milling shoe.

该磨鞋以MP型普通磨鞋为基础，在碳化钨焊料中孕镶了优质硬质合金，提高了磨鞋的切削能力。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。