查询词典 carbon process

The friction performances of carbon face were investigated with an inertia friction tester. The torque curve of carbon face was ideal, the coefficient of static friction was lower than that of dynamic in 0.28 MPa, the friction coefficient of static and dynamic decreased with the braking pressure increasing. To the fiber face, the coefficient of dynamic friction of carbon face was more stable in cycle braking process, the wear rate was lower, and it was efficient to protect the couple plate not to be worn.

结果表明：碳质层的摩擦力矩在制动初期上升较快，中间过渡区平稳，尾部翘起较小；在制动压力小于0.28 MPa时静摩擦系数小于动摩擦系数，且动、静摩擦系数均随制动压力增加而减小；相对纤维层而言，采用碳质层摩擦时摩擦力矩曲线形态更好，连续制动时摩擦系数波动较小，磨损率低且能够有效保护偶件，是1种静/动摩擦系数比较低且适用于高载荷工况条件下使用的摩擦材料。

Corbicula fluminea (Müller 1774) was bred in the laboratory and two shell samples (shell height, A=13 mm, B=9 mm) were selected to determine the carbon isotopic composition of the increment shells (aragonite, CaCO3) and the host water. The results indicate that the carbon isotopic compositions of the two shells increased as the δ^13 C values of the host water increased from -5.24‰ to 1.41‰, showing the influence of δ^13C values on the shell carbon isotopes.δ^13C value ranges from -4.76% to -2.09% and δ^13 C from -8.49% to -2.89%. The δ^13 C values of shells A and B are both more negative than the predicted equilibrium ones, indicating that the shell had used the metabolic CO2 rich in 12C during their growth process.

对双壳类河蚬进行了室内养殖，并选取两个壳体样品（壳高，A=13 mm， B=9 mm），测定其生长部分壳体和生长期间水体碳同位素，研究表明，随着水体碳同位素的升高（δ^13C由－5.24‰升至1.41‰），两壳体碳同位素也随之升高，表明水体对壳体碳同位素的影响；δ^13CA分布范围为－4.76‰~-2.09‰，δ^13CB为－8.49‰~-2.89‰，壳体A和B碳同位素均比预测平衡值偏负，表明壳体在形成过程中利用了新陈代谢产生的富集12C的CO2。

The device for separating and recovering the carbon dioxide from the flue gas by dry process consists of a powder grinding device, a powder feeding device, a fluidized bed, a cyclone separator and a regeneration device, wherein, a flue gas inlet is arranged at the bottom of the fluidized bed, the powder grinding device is communicated with the lower part of the fluidized bed by the powder feeding device, the upper part of the fluidized bed is communicated with the upper part of the cyclone separator by a pipe I, the top of the cyclone separator is provided with an outlet pipe for the flue gas containing low-concentration carbon dioxide, the bottom of the cyclone separator is communicated with the upper part of the regeneration device by a pipe II, the bottom of the regeneration device is communicated with the bottom of the fluidized bed by a pipe III, and the top of the regeneration device is provided with an outlet pipe for the flue gas containing high-concentration carbon dioxide.

本发明提供一种干法分离和回收烟气中二氧化碳的装置和方法，无需分离前对烟气进行降温，而直接在高温下进行二氧化碳的吸收分离，从而避免降温过程中的能量损失；器中干法分离和回收烟气中二氧化碳的装置，由磨粉装置、给粉装置、流化床、旋风分离器和再生装置组成，所述流化床底部有烟气入口，所述磨粉装置通过给粉装置与流化床下部连通，流化床的上部通过管道I与旋风分离器的上部相连通，旋风分离器的顶部有低二氧化碳浓度烟气出口管道，旋风分离器底部经过管道II与再生装置的上部连通，再生装置的底部通过管道III与流化床的底部相连通，再生装置顶部设有高浓度二氧化碳烟气出口管道。

In order to Shanghai Hongqiao solid waste incineration process, the bag filter dust removal efficiency of 99.5%; to "dry except acid than acid + wet" treatment process, hydrogen chloride removal on the rate of 99% of the sulfur oxidation material could be removed in 95% of hydrogen fluoride could be removed in 90%; for the treatment of heavy metals in the main to take "effective capture" and "low control" measures, and adsorption using activated carbon, activated carbon for mercury, cadmium, removal of heavy metals such as lead up to 90%.

在以上海江桥生活垃圾焚烧过程中，布袋除尘器除尘效率可达99.5%以上；采取"干式除酸＋湿法除酸"处理工艺，对氯化氢的去除效率可达99%、对硫氧化物的去除效率可达95%、对氟化氢的去除效率可达90%；对于重金属的处理主要采取"高效捕集"和"低温控制"措施，并用活性炭进行吸附，活性炭对汞、镉、铅等重金属的去除率可达90%以上。

In this paper, the performance characteristics of bamboo carbon viscose fiber are described, and the processing practice in spinning blended knitting yarn of bamboo carbon viscose fiber and combed long-staple cotton fiber is discussed with its process flow and key measures in each process proposed.

介绍了竹炭粘胶纤维的性能特点，探讨了竹炭粘胶纤维与精梳长绒棉混合纺制针织用纱的生产实践，提出了纺纱工艺流程和各工序关键生产技术措施。

Both Milled Carbon and Adherent use a pyrolytic process, In Milled Carbon's process, the resin burns, providing heat and thus reducing the external energy, explains Carberry.

Carberry指出，尽管波音公司对该项目的业务端头不进行直接管控，不过会为其提供复合材料原料，这些原料来源于其在美国华盛顿州普吉特海湾的工厂。

According the research, by inducing TiC into conventional carbon/ graphite materials, their flexural strength increased 13.4%, compressive strength increased 38.1%, void ratio decreased 16.9% in respective. The reason of the performance improvement is as follows: TiC decomposed during the process and hence Ti accelerate the graphitize process, which can increase the mechanical performance of the carbon/ceramic composite materials.

从研究结果可以看出，TiC掺杂可使碳陶瓷复合材料的抗折强度提高13.4%，抗压强度提高38.1%，气孔率降低16.9%；其机理在於TiC掺杂在碳陶瓷复合材料制备过程中能促进碳陶瓷石墨化，使晶体更加完整、细化，有利於力学性能的提高。

Pretreatment of wastewater from pyrimidine production by iron-carbon microelectrolysis -Fenton oxidation process;2. The per-treatment of high strength cyclohexanone wastewater by iron-carbon microelectrolysis -coagulation process was studied, and four affecting factors,i.

研究了用铁炭微电解-混凝工艺预处理高浓度环己酮废水，通过实验确定了铁炭质量比、进水pH值、水力停留时间及曝气时间4个影响因素的最佳条件分别为：铁炭质量比为1∶2，环己酮废水进水pH为2～3，停留时间为4h且有曝气条件下，COD去除率达到55。

It has been successfully applied in the fields of high-performance carbon fiber, needle coke used for ultrahigh power electrode, anode of rechargeable lithium-ion batteries, activated carbon with super-high surface area, catalyst supports and carbon foams、 In this paper, the effects of raw materials and pyrolysis conditions including heat-treatment temperature, pressure and time on the formation and development of carbonaceous mesophase were discussed in detail Since complex constitutes of raw material, various reactions and phases are involved in the process of mesophase evolution, we suggest that a given carbonaceous mesophase product should be manufactured by selecting raw materials and setting pyrocondensation conditions according to the specific requirement of the product, so that products with the best structure and performance could be obtained.

它在高性能炭纤维、超高功率电极用针状焦、锉离子二次电池负极、超高比表面积活性炭及催化剂载体、泡沫炭等领域得到了较好的应用。综述了原料和热缩聚条件对炭质中间相形成和发展的影响，这些影响因素包括原料的种类、热缩聚温度、反应压力和保温时间等。通过讨论指出，由于炭质中间相涉及的原料种类多样，热缩聚制备过程中涉及的反应、物相复杂，因此，在制备特定性能的产品时，应针对产品的特定性能要求来选择原料、设定热缩聚条件，以制得具有最佳结构和性能的产品。

Based on the dynamic composting process of wastewater sludge from China Resources Breweries Co., Ltd., the dynamics of different operational and evaluating indices, such as temperature, moisture content, pH, humic acid, total organic carbon, total nitrogen, water-soluble organic carbon and germination index and so on, during the treatment process were discussed. The results indicated that cottonseed cake used as compost amendment of brewery sludge.

为快速高效无害化处理啤酒厂污泥，对啤酒厂的污水污泥进行微好氧堆肥发酵处理工艺进行了研究，重点研究了啤酒厂污水污泥袋式堆肥过程中温度、含水率、pH值、腐殖酸、有机碳、全氮、水溶性有机碳、发芽指数等参数的变化规律。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。