查询词典 cantilever

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷（附加离心力和附加陀螺力矩），分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数（转速比、机动飞行半径、机动角速度等）对该系统振动特性的影响。

First, the angular velocity function and maneuver load for certain maneuver flight (including hover, dive-hike and these two combined) are set up. The simulation results of the vibration of double-disk rotor system with cantilever supported on rigid bearings show that rotor would be apparently deformed under maneuver load. Second, the performance of oil force of SFD in maneuver flight is analyzed. The results show that in maneuver flight, the SFD with centering spring will become eccentric and its oil force will be time-related and offset-related. Then, SFDs are introduced into typical Jeffcott rotor system. The whole system will be statically displaced in maneuver flight and the nonsynchronous components of oil force appear in the response of rotor system.

首先，建立了水平盘旋、俯冲拉起及盘旋+俯冲拉起复合机动三种机动飞行条件下的机动角速度函数，并确定了对应机动飞行条件下的机动附加载荷(附加离心力和附加陀螺力矩)，分析了带刚支的双盘悬臂转子系统在机动飞行条件下的振动特性，发现发动机转子在机动飞行时会发生明显变形；随后，分析了非定心挤压油膜阻尼器的油膜力特性，机动飞行时，油膜轴颈在机动附加载荷的作用下偏离外环中心，使得带定心弹支的挤压油膜阻尼器也变成了非定心挤压油膜阻尼器，其非定心挤压油膜力是瞬态时变的，并且与SFD油膜轴颈偏移量和进动形态有关；然后，在经典的Jeffcott转子系统中引入带定心弹支的挤压油膜阻尼器，分析了机动飞行时非线性转子系统的振动特性，发现挤压油膜阻尼器油膜力的非协调特性也反映到转子系统的振动响应中；之后，对机动飞行条件下带挤压油膜阻尼器的双盘悬臂转子系统的振动特性进行了分析，并重点分析、总结了俯冲拉起机动飞行时，系统结构参数和工作状态参数(转速比、机动飞行半径、机动角速度等)对该系统振动特性的影响。

They explain the interaction between these parameters, and help to the design of active vibration control system of piezoelectric smart cantilever beam. On the above, the optimal model with m pairs of PZT sensor/actuator and state equation are established, and the PZT films position/length and the feedback control gain are optimized with the method of moving asymptotes.

在此基础上，本文进一步研究了同位布置多对压电传感/致动元件的悬臂梁关于压电传感/致动单元对的布置、长度和控制增益的优化设计模型，并利用MMA(the method of moving asymptotes)算法对压电片的位置、尺寸和控制增益进行了优化计算。

The pylon of a cable-stayed bridge without backstays acts as a cantilever beam to resist loads from the girder transferred by stay cables, therefore, the pylon shaft is made incline to form a kind of equilibrium system of girder-pylon structure.

无背索斜拉桥结构主塔作为悬臂梁来抵挡斜拉索传递的梁面荷载，因此将塔身倾斜组成了梁塔结构的平衡体系。

Research of cantilever screen grating diagrid and matter coactions way imitation;2. Has studied vibration of a single grating diagrid firstly,analyzed the montion of matter on screen,lastly analyzed and simulated the track of matter on it by using Matlab.

针对一种新研制成功的振动筛—梯流棒条筛，首先研究了振动筛棒条的振动规律，之后主要分析了其上物料的运动，并以Matlab语言为基础分析和仿真了物料运动的轨迹。

Two kinds of cantilever beams used in the MEMS devices are designed as the fixed-fixed and crag-leg flexures, and the spring constants are derived respectively using energy methods of elastic mechanics.

设计了在MEMS器件中最经常用到的两种悬臂梁结构，即直角型和蟹脚型，通过利用弹性力学的能量分析法分别得到各自的弹性常数。

The research results showed that (1) inelastic compressive behavior of the gusset plate was similar to a cantilever plate in compression load,(2) buckling strength was reasonably predicted based on an inelastic plate buckling equation and buckling coefficient, and (3) design guidelines of the gusset plate in compression were proposed with inclusions of edge stiffeners.

本研究结果显示：(1)含挫屈束制消能斜撑之接合板在受轴压作用下，将产生的挫屈模式为Fixed-Free、(2)接合板在Fixed-Free模式下之挫屈强度预测及(3)如何加劲接合板使其强度能达到降伏后之非弹性挫屈行为。

Then impulse hammer technique on the cantilever beam was used to determine the vibrational damping.

此外，我们采用了悬臂梁锤击法对材料的动态阻尼进行了分析测算。

Head components of the methods and the possibility of damage to many, including head dirty, head wear, head cantilever deformation, magnetic coil damage, such as displacement.

磁头组件损坏的方式和可能性非常多，主要包括磁头脏、磁头磨损、磁头悬臂变形、磁线圈受损、移位等。

A novel scanning force microscope is studied in this dissertation. The point diffraction interference phenomenon on the V-shaped cantilever is described.

本文在分析了现有扫描力显微镜的优缺点的基础上，设计了一种新型的激光扫描力显微镜，对激光扫描力显微镜的各组成部分进行了详细的分析和研究。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新