查询词典 camber

A blading design method for both axial and centrifugal compressor blades was discussed by using arbitrary camber lines.

开发了一种通用于轴流、斜流和离心式压气机叶片的任意中弧造型设计方法。

And the frontal technique is adapted to solve the FE equations. The techniques are studied to deal with the large slip frictional contactproblems between a deflectable body with large deformation and a rigid bodywith flat or curved surface. A new algorithm is presented to resolve such contactproblems, including incremental displacement constraints and force constraints,and the modules are programmed. The performances of tire under static load invertical loading state and camber state are analyzed by this method. And theexperiments were carried out at the same condition as used in analysis process.

研究了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题，提出了求解这类接触问题的位移增量约束和主动力增量约束处理方法；编制了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题求解模块；利用本文提出的大滑移接触问题处理方法，分析了轮胎在径向静载和静态外倾加载条件下受力和变形，并对部分分析结果进行了试验验证，验证结果表明，本文提出的位移增量约束和主动力增量约束处理接触问题的方法是正确可靠的，而且具有精度高、收敛性好、收敛速度快的优点。

In this paper,based on phased array transducer,we excite one element of array and incept reflection by the others.Then we study the change rule of wave reflection groups of camber and plane.

模拟相控阵阵列探头，利用单个晶片依次激发、所有晶片接收的方法，研究平面和弧面反射波组的变化规律。

The upper deck shall be extended to the whole length of vessel with deck camber of knuckled type.

上甲板延伸至整个船长，甲板梁拱为折角型。。

When the parameter matching of the wheel location is improper, namely, the matching between the wheel toe-in and the wheel camber angle is ill-suited, abrasion of the two wheels of the same steering axle is inside or outside simultaneously, because of wheels sideslip. However, when double-front-axle steering system failure take place, abrasion of the two wheels of the same steering axle is in the same side, and that, tyre abrasion direction of front and back steering axles is rightabout. That is to say, if tyre abrasion of front steering axle lie in the left side, tyre abrasion of back steering axle lie in the right side to a certainty, which is the rule of tyre abrasion of double-front-axle steering automobile.

当定位参数匹配不当时，同一转向轴上左右车轮的磨损部位都在内侧或外侧，原因是左右车轮在滚动的同时还要产生相向或反向侧滑；而双前轴转向汽车前、后转向轴引导汽车转向方向不一致时，同一转向轴左、右车轮的磨损部位都在同一侧，而且前、后转向轴上的车轮偏磨损方向正好相反，即如果前转向轴左、右车轮磨损部位在左侧或右侧，那么后转向轴左、右车轮磨损部位就在右侧或左侧，这是双前轴转向汽车特有的轮胎磨损规律。

Ack to class: Rolf Girsbergs famous creation: The RG 15 can be and has been modified to suit a variety of different tasks, you can modify the camber from 1,5 to 3,0% without problems and at the same time you can change the thickness from 7 to 13%.

回到班级：罗尔夫girsbergs著名的创造：丽晶花园 15 ，可以和已经被修改，以适应各种不同的任务，您可以修改曲面，从1，5至3，0 ％，如果没有问题，并在同一时间，你可以改变厚度从7日至13 ％。

"Red" of Pu'er Tea is divided into rubine red, carnelian red, amber red,etc. Among them, it is the most difficult to get rubine red, which is theultimate in tea, the second, carnelian red, and then the camber red

普洱茶的红又根据品质不同分为宝石红、玛瑙红、琥珀红等，其中以宝石红最为难得，为茶中极品，其次是玛瑙红，再其次是琥珀红。

According to the quality, the "red" of Pu'er Tea is divided into rubine red, carnelian red, amber red, etc. Among them, it is the most difficult to get rubine red, which is the ultimate in tea, the second, carnelian red, and then the camber red followed.

普洱茶的红又根据品质不同分为宝石红、玛瑙红、琥珀红等，其中以宝石红最为难得，为茶中极品，其次是玛瑙红，再其次是琥珀红。

Compared with even die-drawing, camber die-drawing's limit drawing coefficient is detracted, so efficiency is increased.

曲面凹模拉深与平端面凹模拉深相比，降低了极限拉深系数，减少工序、提高了效率，降低了成本。

Without the back wheel, it has a rough stick on road vibration, a lot of drag and it fishtails as the stick slides sideways down the camber of the road toward the gutter.

没有回轮，它有一个粗略的道路坚持振动，有很多阻力和fishtails作为幻灯片一边坚持了曲面的道路了排水沟。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。