查询词典 calorimetry

In this paper,a method for measuring acoustic power of plane piston transducer based on calorimetry is presented.

介绍了一种基于量热法的平面换能器声功率测量的方法。

Simultaneously uses the existing experimental condition, to the process of the electrolysis of watery potassium carbonate, we has done the further research of the power input, the initial temperature and the electrolysis time how to influence the system calorimetry coefficient.

根据现有的条件，本研究又对电解碳酸钾水溶液过程中的电解输入功率、电解起始温度和电解持续时间对系统k值的影响作了初步的探讨。

Using the analysis of differential scanning calorimetry, three exothermic peaks were found which were mainly attributed to crystallization of α-(373℃), relaxation of internal strain (410℃) and crystallization of the residual amorphous matrix (540℃) respectively.

对机械合金化形成的非晶〓的DSC测量表明：在40℃到700℃范围内，有三个位于373℃，417℃和540℃左右的放热过程，分别α-相的结晶，内应变的降低和残余非晶相的晶化。

Curing reactions of BPF/R EP system containing dicyandiamide were studied with differential scanning calorimetry,and the curing systems and curing condition were studied systematically with 2-ethyl-4-methyl imidazole(2E4MZ) accelerating dicyandiamide,which affected the property of BPF/resorcin copolymeriza.

通过差示扫描量热法研究了2-乙基-4-甲基咪唑对双氰胺-双酚F/间苯二酚共聚型环氧树脂体系固化反应的促进作用，并系统地探讨了固化体系及固化条件对固化物性能的影响。

The specific heat capacity of carbohydrazide perchloric acid energetic coordination compounds was studied by differential scanning calorimetry.

用差示扫描量热仪研究了高氯酸碳酰肼类配合物的比热容。

The synthesized monomer and fluorescent polymers were characterized by the methods of nuclear magnetic resonance (~1H NMR), mass spectrography, fourier transform infrared spectroscopy, ultra-violet-visible spectra and differential scanning calorimetry, respectively.

采用核磁(~1H NMR)，质谱，红外光谱，差示扫描量热法，可见紫外分光光度仪和荧光光谱等方法对合成的荧光分子以及荧光聚合物的结构和性能做了表征，系统地研究了所合成的荧光聚合物的荧光性能。

The solid-state reaction synthesis and sintering of zirconolite and sphene were researched by thermogravimet- ric-differential scanning calorimetry analysis and X-ray diffraction analysis.

以天然锆英石为主要原料，通过配方设计，采用热重–差热、X射线衍射等分析手段，研究了钙钛锆石(CaZrTi2O7)和榍石(CaTiSiO5)的固相反应合成及烧结。

ST5BZThe effect of the temperature of shape memory treatment,cold working rate and shot-peening process on the fatigue limit of Ti-50.2Ni shape memory alloy spiral spring had been studied by differential scanning calorimetry and thermal cycling fatigue test.

利用示差扫描热分析仪和热循环疲劳试验，研究了形状记忆处理温度、冷加工率和喷丸工艺对Ti 50 2Ni形状记忆合金弹簧疲劳寿命的影响。

The thermal performance of micron-sized Al particles and CU/Al micron-nano composites with WO3 were investigated by differential scanning calorimetry as a function of the equivalence ratio. Mechanisms of thermite reactions have been proposed.

在此基础上，利用DSC分析了Cu/Al-WO3的热反应性能，对比了Al-WO3与Cu/Al-WO3在不同化学配比下的热反应历程，同时分别提出了其相应的反应机理。

The effects of 1, 4-dinitropiperazine on the combustion characteristics and thermolysis of CMDB propellants were studied by differential scanning calorimetry and burning rate test.

用燃速测试和高压差示扫描量热法试验，研究了 N，N -二硝基哌嗪逐渐取代改性双基推进剂中的黑索今后，对推进剂燃烧性能和热分解特性的影响。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。