查询词典 calorimetry

The analysis by differential scanning calorimetry indicates that the thermal stability and the glass forming ability of Cu_(50)Zr_(42)Al_8 has been enhanced with the affiliating of RE...

经DSC分析发现，添加稀土元素Y有利于提高Cu_(50)Zr_(42)Al_8的热稳定性和非晶形成能力，且Cu_(50Zr_(42)Al_8_(99)Y_1的热稳定性和形成能力最强。

The thermal dynamic properties、glassing transition temperature and melting point of soybean proteins are studied by Differential Scanning Calorimetry , Thermogravimetry Analysis —Differential Thermal Analysis .

利用差示扫描量热分析、热重法-差热分析对大豆蛋白热力学性质、玻璃化转变温度和熔点等进行了研究，这些数据对于研究大豆蛋白可生物降解材料具有重要参考价值。

It is evaluated the oxidation properties of 6 hydrogenated base stocks and 5 antioxidants by pressure differential scanning calorimetry .

用加压差式扫描量热仪评价了6种加氢基础油和5种抗氧剂的氧化性能，以克拉玛依石化公司生产的基础油氧化稳定性好。

In this thesis, the phase diagram of Zn-Al binary system on 10~69.5 w% was reinvestigated by using differential scanning calorimeter, X-ray diffraction and pushrod dilatometer. The process of isothermal transformation during the aging of high-Aluminum-Zinc-based alloy was studied by using differential scanning calorimetry, and the aging behavior of the alloy was analyzed at the aspect of thermal analysis kinetics. The change of microstructure which the alloy was being heated was observed on high-temperature metallurgical microscope. The microstructure and wear-friction properties were compared among the alloys treated with several different heat treatment processes, and a model for heat treatment processes was proposed based on artificial neural network,so as to predict the relationship between friction coefficient and parameters of aging treatment such as aging temperature and time.

本文采用高温X射线衍射、示差扫描量热分析、热膨胀等方法重新测定含锌量范围为10％～69.5％的Zn-Al系二元相图，利用示差扫描量热分析法，研究高铝锌基合金时效等温转变过程，并从热分析动力学的角度分析高铝锌基合金合金时效行为；使用高温金相显微镜观察合金加热时的组织变化；比较几种不同热处理工艺对高铝锌基合金显微组织与耐磨性能的影响并利用人工神经网络建立高铝锌基合金热处理工艺模型，预测合金摩擦系数随时效温度及时间变化规律。

Stearic acid, stearic amide and their mixtures were investigated by differential scanning calorimetry at a heating/cooling rate of 5K/min.

相变材料是解决能源供需矛盾的一类新型的清洁廉价能源；硬脂酸、硬脂酰胺均为廉价易得的化工产品。

For the high affinity sites, binding constant decreases with the decrease of the alkyl chain lengh in the surfactants, but for the low affinity sites, binding constant increases and are not distinct when the alkyl chain is dedocyl. The binding sites are related to the alkyl chain lengh, not for the number of hydrophile groups and temperature.Isothermal titration calorimetry has been used to observe the enzyme-catalyzed hydrolysis reaction of urea.

对于高结合位点，结合常数随疏水碳链长度的减小而减小；对于低结合位点，结合常数随疏水碳链长度的减小而增大，相应的当碳链减小至C12时，低结合位点不明显，结合位点数可能只与碳链长度有关，随亲水头基和温度变化不明显。

The membranes were characterized by X-ray diffraction, Fourier transform infrared, Scanning electron microscope, Transmission electron microscope, Differential Scanning Calorimetry and contact angle meter, and their swelling and sorption properties, diffusion properties, and pervaporation properties were investigated systematically.

利用X一射线衍射、红外光谱、扫描电镜和透射电镜、差示扫描量热仪以及接触角分析等手段对膜的微观形态进行表征，系统研究了膜的溶胀吸附、扩散以及渗透蒸发性能。

Chemically pure elemental Al and CuO powder with an Al mass percentage of 20, 35, 57, 70 and 85 were milled respectively. The ball milled powders were analyzed by X-ray diffractometry and differential scanning calorimetry. When the amount of Al was under 20%, the reduction occurred only. When the amount of Al exceeded 20%, besides reduction, the synthesis reaction occurred simultaneously.

对Al含量在20%～85%范围内的Al/CuO进行高能球磨，采用X射线衍射进行物相分析，并对Al含量分别为20%和75%的试验分析了物相随研磨时间的变化，做了差示扫描量热分析，对比研究了固态还原反应与固态复合反应过程的异同。

The Gel Permeation Chromatography results indicated that the molecular distribution of end capped PAA was smaller than that of the no end-capped one. The Differential Scanning Calorimetry results showed PA end- capped polyimide films exhibited slower rising range of the T compared to no end cappers films'.

结果表明，封端可有效阻止分子链的无序增长，使聚酰胺酸分子量分布变窄；且可明显减少分子链在高温下的反应，表现为热处理前后封端薄膜T变化明显小于未封端的薄膜。

The thermally stable capability and mechanical property of the deuterated foam above were analyzed by the differential scanning calorimetry, dynamic mechanical analysis, stress-strain behavior analysis, and other methods. The results showed that the glass temperature or the decomposed temperature for the prepared foams is 100℃-120℃,or about 400℃, respectively. However, there was the irreversible change in the foams at between 50℃ and 100℃.

结果表明：1泡沫玻璃化温度在100℃-120℃，裂解温度在400℃左右；2在50℃-100℃之间和一定作用力下，泡沫存在不可逆的形变；3室温下(22℃)，随着密度增大，泡沫弹性模量增大，损耗因子减小；在泡沫密度为20 mg/cm3-160 mg/cm3时，弹性模量为2MPa-10MPa，屈服强度为0.01MPa-0.12MPa，破裂形变为5%-35%。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。