查询词典 calculus of finite difference

On the basis of experimental research, this thesis applies 2-dimensional non-linear finite element method to the analysis of transient temperature field on the section by means of relatively high precision triangular element of six joints. When the temperature field is analyzed, finite element reseaus are divided in space field and finite difference reseaus are divided in time field, and then the program is compiled. The computing results are in good agreement with the test data. It indicates that the program is stable and precise.

在试验研究的基础上，本文采用精度较高的三角形六结点单元对构件截面二维非线性瞬态温度场进行了有限元分析，即在空间域内采用有限元网格划分，在时间域内采用有限差分网格划分，据此编制了计算程序，计算结果与试验数据符合较好，程序稳定性好，精度满足要求。

This paper is devoted to solving linear saddle point problems, Specifically, We consider nonsymmetric systems, written as usual in block form, where the upper left block is an invertible linear operator with positive definite symmetric part. Such saddle point problems arise, for example, in certain finite element and finite difference discretizations of NavierStokes equations, Oseen equations, and mixed finite element discretization of second order convection-diffusion problems.

中文题名求解鞍点问题的迭代方法副题名外文题名论文作者冯丽红导师曹志浩教授学科专业计算数学研究领域\研究方向学位级别博士学位授予单位复旦大学学位授予日期2002 论文页码总数87页关键词鞍点问题迭代方法网格离散线性方程组馆藏号BSLW /2003 /O241 /15 论文针对鞍点问题的求解分析了一些典型的快速算法。

Finite element discretization was carried out on the mathematical model to get a fully coupled finite element equation with the parameters of element nodal displacement and element nodal pore pressure as unknown variables. Finally, the transient nonlinear finite element equation in incremental form for reservoir fluid-solid coupling is obtained by means of time discretization in implicit difference scheme.

基于与微分方程等价的加权余量公式，在空间域采用有限元离散，对时间域进行隐式差分格式离散，导出了以单元节点位移和单元节点孔隙压力为未知量的储层流固耦合的非线性有限元增量方程。

Firstly, the fully discrete standard finite element Galerkin method and the nonlinear finite element Galerkin method and the modified finite element Galerkin method in which time is discretized by the Euler implicit difference scheme are considered, and the - and - global relative errors and CPU time corresponding to the SG method, the NG method and the MNG method are computed respectively.

首先，对于全离散(时间离散是欧拉显式格式)标准有限元Galerkin方法和非线性有限元Galerkin方法以及修正有限元非线性Galerkin方法，分别进行数值计算，并比较了三种算法的计算解与精确解的误差估计及所耗费的CPU时间，结果验证了MNG方法要优于NG方法，而NG方法又优于SG方法。

The formulas derived show that FAM is more accurate and reasonable than finite difference method and finite element method , also, on the element partial differentiation of dynamic Reynolds equations with respect to circumferential and axial direction is directly obtained by finite analytic solution.

本文在详细分析目前流体润滑轴承层流、紊流润滑理论及轴承-转子系统稳定性理论的基础上，提出了将有限分析法用于计算动压、静压、动静压轴承的静特性和动特性系数，并推导了相应的计算公式。

The book covers one-, two- and three dimensional problems which are solved by using exact and approximate analytical methods and numerical methods such as: the finite difference method, the finite volume method, the finite element method and the boundary method.

书中涵盖一，二和三是利用精确和近似分析方法和数值方法，如：有限差分法求解二维问题，有限体积法，有限元法和边界法。

In studies of interaction among pile, platform that above it and surrounding soil, this paper employ the concept of plate element to simulate the loading character of platform, and employ the concept of solid element to simulate the character of pile and soil, using the finite element method after understanding the geometry properties of pile, soil and the platform. Analyzing the loading properties of the three entities above and their deformation, this paper also employ a special element, Penalty Element. The introduction of penalty element of this kind has served to guarantee the join harmony of displacement between solid element and plate element, thereby effectively resolving the join problem between platforms, pile that support it and surrounding soil.Considering significant property difference between pile material and its surrounding soil, there may be much shear stress on their contact interface produced under vertical load, thus causing displacement or fission. Therefore it is necessary to adopt one special constitutive law of this kind of contact interface, which can reflect its feature of loading and deformation thoroughly. On the basis of the deformation feature and constitutive laws of some contact interface obtained by Zhang Dongji and people concerned through some single-shear experiments on contact interface between structure and soil, this paper employ one pile-soil three-dimensional constant thickness contact interface model to simulate the " slide" taken place on the interface between pile and its surrounding soil. With this kind model, this paper has also created one finite element model, which can be applied to perform finite element calculation and analyze the pile-loading feature, and deduced its element stiffness matrix.

在承台-桩-土共同作用中，考虑桩与承台的几何特性，采用有限元方法，用实体单元模拟桩土，用板单元模拟承台，更具体地分析桩和承台的受力特性和变形，而且还采用罚单元—既实体单元与板单元之间连接必须满足变形协调条件，来有效地解决了承台与桩土的连接问题，且在桩土共同作用中，由于桩体结构的材料性能与周围土层性质相差较大，在竖向荷载下有可能在其接触面上产生较大的剪应力从而导致错动或开裂，因此，为了充分反映桩土接触面上的受力及变形特征，应采用一种桩土接触面特有的本构关系，即利用张冬霁等人关于结构与土体接触面单剪试验所得到的接触面变形特征及其本构关系，引入桩-土三维等厚度接触单元来模拟桩与桩侧土之间的&滑移&，在此基础上建立可用于桩基承载性状分析的有限元计算单元模型，并推导出了各单元的刚度矩阵。

This paper reviews and summarizes the progress in this field as follows: the mathematical model and the difficulty of the analytical solutions is introduced; discusses the latest progress of the numerical solutions is discussed; the finite difference method, the Godunov method, the Boltzmann method, and the KFVS method of one-dimensional dam-break problem are introduced; the TVD method, the discontinuous finite element method, the finite volume method and characteristic method of two-dimensional dam-break problem are discussed; the applicability, the advantage and the disadvantage of each method are analyzed; and the progress in the numerical calculations of flow of fluid with free surface are presented.

回顾和总结了国内外对溃坝水流演进问题的研究进展：介绍了溃坝水流的数学模型及解析解法存在的困难，进而讨论了数值解法的最新进展；论述了求解溃坝水流一维问题的有限差分法、近似黎曼解的Godunov格式法、Boltzmann法、KFVS法和二维问题的TVD格式法、间断有限元法、有限体积法、特征线法，并分析了各种方法的适用范围和优缺点，及讨论了限制函数的使用；介绍了利用自由水面追踪方法计算溃坝水流的研究进展，并根据目前存在的不足和实际工程的需要，提出了进一步研究的方向和发展趋势。

It is different from the finite element method which uses the calculus of variation to construct the element-based approximate equilibrium equation. It does consider the equilibriums of forces on the inter-element boundary, which are neglected in the finite element method through the weak formulation.

这种方法跟有限元素法不同，因为有限元素法是采用变分法建立各个元素的近似平衡方程式，这种方法也考虑元素与元素相连接的边界上的力平衡条件，而在有限元素法的推导过程中我们忽略了这种条件。

Results It is significant that the difference between the data of display difference of tumor and surrounding tissue in different voltage conditions. It is significant that the difference between the data of tumor size difference in different voltage conditions. It is significant that the difference between the data of the CT value of tumor and other side masseter.

实验结果不同电压下肿物与周围组织关系显示情况的差异有统计学意义，不同电压下测量肿物大小的数据间差异有统计学意义，不同电压下肿物与正常组织CT值变化的差异有统计学意义。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48