查询词典 calculation

Everything that is beautiful and noble is the product of reason and calculation ---Charles Baudelaire,French poet, critic, and translator.

所有美丽和高贵的事物都是理性和思考的成果---查尔斯。波德莱尔，法国诗人，评论家和翻译家。

Then we use the diagram of Venn to analyse and predigest the theorem proof. And it is also used in probability addition and multiply、conditional probability、total probability formula、 Bayes formula to simplify the calculation of probability. So it is easy to understand and master.

进而利用Venn图分析、简化概率性质的证明以及Venn图在概率的加法与乘法、条件概率、全概率公式和贝叶斯公式中的应用，简化概率的计算，便于学习者理解和掌握。

When a new message is encountered, the filter strips this message down to tokens, compares it to the database, and applies a formula based on the British scientist Alan Bayes' formula for probability calculation.

当遇到一个新的讯息是，这个信息过滤片降至纪念品，比喻为数据库一、适用的英国科学家艾伦根据公式贝叶斯公式计算概率。

Finishing calculation of mean value, standard deviation, skewness, kurtosis of Beta distribution.(2) Fitting parameters of many kinds of typical distribution and using residual deviation to evaluate fitting precision.(3) Using Beta distribution as an agreed indication distribution applied to many kinds of practical photoelectric measurement distributions.(4) Deriving theory formula of Bayes point estimation about Beta distribution parameters and mean value and standard deviation on the condition of mean square error loss function and supposed the prior distribution is uniform distribution.(5) Generating MCMC sample from post distribution by the method of Gibbs sample algorithm. Calculating bayes point estimation from sample on the condition of mean square error loss function. Calculating confidence interval by an approximate method to complete interval estimation.

本文的主要工作有：(1)解决了Beta分布参数a和b的精确计算以及均值、标准差、偏度、峰度的计算问题；(2)拟合出10余种典型分布的Beta分布的两个参数，并且采用剩余标准差评价该Beta分布的拟合精度；(3)对多种典型的光学与光电测量系统的测量分布进行了Beta分布统示表示；(4)在假设先验分布为均匀分布前提下，得到参数a和b以及均值μ和标准差σ在均方误差损失函数下的贝叶斯点估计理论计算公式；(5)利用直接抽样的Gibbs抽样算法，从后验分布中产生MCMC样本，从样本直接计算均方误差损失函数下的贝叶斯点估计，并使用一种近似方法计算其置信区间，完成区间估计。

The Zn-Ti distances are 0.369 nm and 0.335 nm for the single-corner adsorption mode and double-corner adsorption mode, respectively. Therefore, the EXAFS fitting data, R1=0.371 nm, R2=0.332 nm, can be well distinguished for SC and DC mode respectively. The calculation results also showed that the optimized Zn-O average distance of Zn-O tetrahedron is about 0.200 nm, which agree with the EXAFS results.

用DFT方法对四配位水合Zn离子在簇Ti2O11H14上进行优化后发现，四配位的Zn-O平均距离为0.200nm；外层Zn-Ti结合存在两种稳定的吸附模式：单角吸附模式和更加稳定的双角吸附模式，其Zn-Ti距离分别为0.369和0.335nm。

Sediment from river is not the main source of the Rushan Bay now any more ,which leads to the change of balance of sedimentation power. Sediment will transport because of the drive of hydrodynamic elements in macroscopic view .Direction of suspended load is basicly the same as tidal current .Flood tide makes suspended load transport to tip of the inner Bay and to the Mouth in exterior Bay .The direction of longside sediment transport in two sides of the Mouth mainly focus in the Mouth .Because the coastline along the exterior Bay is very meandering and it belongs to the type of bedrock ,besides some sediment going into the inner Bay ,so actual net sediment discharge rate is less than calculation .It develops an ebb delta out of the Mouth and forms tidal sand ridge ,tidal washing canal ,barrier bar and marine physiognomy ;The result of model simulation disclosures that differences of sediment erosion and siltation between single tidal action and wave-current action are very big .From the analysis of sediment composition、sediment sources and stability of beach and ridge ,this article gets the conclusion that the channel has the possibility to silt ,though the course maybe very slow.

通过分析研究文章得出如下结论：沉积物平面分布与水动力的时空变化存在很好的相关性；口门外发育落潮流三角洲，形成潮流沙脊、潮流冲刷槽、浅滩、拦门沙等水下动力地貌；乳山湾河流来沙已不是湾内泥沙主要来源导致沉积水动力平衡发生改变，宏观上表现在泥沙受水动力驱动发生不断运移；悬沙运移方向与涨潮流方向基本一致，湾内涨潮流带来的悬移质泥沙向湾顶运移，湾外悬移质泥沙主要向口门方向运移；湾口两侧岸段沿岸输沙方向均指向口门方向，由于乳山湾外海岸线曲折，两侧岸段以基岩为主，加之部分泥沙进入湾内，实际净输沙量小于计算值；数值模拟发现潮流单独作用与波流共同作用下泥沙蚀淤模拟差别较大；从沉积物组成、泥沙来源及滩槽稳定性三个方面分析，文章认为研究区存在航道淤积的可能性，但过程相对较慢。

618 Method calculation on absolute maximum deflection on primary beam within bridge system composed of longitudinal and transverse beams

纵横梁桥面系统中主梁的跨度较长，纵梁上直接承受的车队荷载数量多且数值大，主梁设计中绝对最大挠度的确定是关键内容。

Fiber reinforced plastics bars; concrete beam ; deflection ; calculation ; control

纤维塑料筋；混凝土梁；挠度；计算；控制

Took Chongqing Gong-he tunnel as an engineering example and studied the failure mechanism of surrounding rock and the correlation with bolt support system by using the methods of theoretical analysis, modeling test, numerical simulation and in situ test, some helpful conclusions were arrived as follows.Firstly, a new failure criterion for transversely isotropic rock mass was proposed with consideration of bedding plane orientation and major principal stress, and the corresponding algorithm, arrived through VC++6.0, can be easily embedded into the software FLAC3D for the geotechnical calculation.

论文在国家自然科学基金专项基金创新群体基金项目(No.50621403)以及国家自然科学基金重点项目"隧道与地下空间工程结构物的稳定性与可靠性(No.50334060)"的资助下，以共和隧道为示范工程，运用理论分析、物理模型实验、数值模拟和现场测试等手段，对共和隧道大埋深段层状岩体的围岩变形破坏机理、锚杆支护力学效应及围岩-支护结构的变形特征等内容进行了研究，其主要研究成果有：①在总结和探讨国内外学者提出的层状岩体经验型连续介质破坏准则基础上，结合层状岩体力学特性，考虑层面方向和最大主应力方向两个影响因素，提出了共和隧道层状岩体横观各向同性破坏准则；采用汇编语言VC++6.0实现了横观各向同性弹塑性本构关系的算法，并嵌入FLAC3D有限差分数值分析软件接口中实现数值运算。

The rigid and elastic wheels of tire-soil contact models are proposed based on the Bekker pressure model and the Jonasi shear soil model, and they are described in the form of S-function to enhance the calculation efficiency and simulation accuracy.

根据多体动力学在Adams环境中建立了某款工程车辆的模型，以汽车地面力学中Bekker承压模型和Jo-nasi剪切模型为基础建立了刚性轮和弹性轮模型以模拟轮胎地面接触，并将轮胎地面接触模型用S函数描述，以提高仿真运行速度和计算精度。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。