查询词典 by force of

Legal force is by no means ex parte liberty of the user. Rather, it is deemed a relationship that is concerned with both the obligor and obligation opposite to the force and the protection and remedy of the state.

法权不是权利主体单方面的行为自由，而是一种关系，这种关系既涉及与权利对应的义务人及义务，也涉及国家保护及救济的责任。

The fusion of trend part of force and current is used as a standard curve in the total process control in ECM.by using a BP Neural Network to mapping the fusion of force and current and the feed position.

用神经网络建立数显进给位置与力和电流融合信号之间的非线性映射，使它作为标准曲线用于对间隙进行自动的全程控制。

The objective of this thesis mainly focuses on the discussion of deviation in topographic height measurement measured by the frequency-modulated atomic force microscopy as the electrostatic force is applied or not applied.

本论文主要是探讨静电力对频率调制原子力显微镜表面高度量测时所造成的误差。

The purpose of this study was to examine the maximum value of pulling-force, momentum, ground reaction force, net muscle joint moment, the changes of muscle power on raising movement after sitting by different sitting distance patterns, which was measured from feet to a supposed vertical point on hip joint (25cm.35cm.45cm) during Tug-of-War.

中文摘要本研究针对拔河坐地起身动作，以足跟至髋关节点垂直地面位置的不同坐地距离（25公分、35公分、45公分）探讨起身动作之最大拉力值、冲量值、地面反作用力、净肌肉力矩、肌肉功率的变化，藉以了解坐地距离之变化对起身动作之生物力学影响。

The outstanding feature of the new cutting dynamometer contrary to other type of dynamometer sensor is that it is more similar to general lathe tool. It can be installed on knife rest, so it is same wit practice state of cutting. Sensitivity of dynamometer is more high, especially main cutting force can attain 7.4pC/N. The calibration results show that it has high static linearity, and its natural frequency is greater than 5 kilohertz, so the cutting dynamometer has fully reached the dynamometer standard stipulated by CIRP-STCC.Finally, in order to measure the cutting force, the orthogonal experiment method in which the three factors are the diameter of cutting, feed and spindle speed is performed.

该新型车削测力仪与原有车削测力仪相比的突出优点是：它的外形接近一把普通的外圆车刀，可直接装夹在刀架上，与实际切削状态相同；传感器的灵敏度更高，尤其是主切削力方向可达到7.4pC/N；标定结果表明该传感器具有良好的线性静态特性，固有频率高于5kHz。

The specific decomposition of the terms depends on the force field, but a general form for the total energy in an additive force field can be written as where the components of the covalent and noncovalent contributions are given by the following summations

特别的分解项依赖于力场，但是总能力的一般的形式在增加力场可以写为，这里共价键和非共价键贡献可以写为

Based on the electromagnetic theory, analyze the character of electromagnetic force using two linear electromagnetic stirrers which were designed by our department. Investigate the rule of electromagnetic force and how the different parameter of casting and stirring influnce the solidification structure.

本文采用理论分析与实验研究相结合的方法，在实验室条件下，采用本系最新自行研制的行波磁场搅拌器对在行波磁场电磁搅拌作用下钢液内的电磁力特性、各种不同浇铸工艺参数以及搅拌参数对铸坯凝固组织的作用规律，进行了深入的研究。

During the pipe pushing construction of the parallel steel water pipeline of Beidu-Yanger pipeline project in Ningbo, the pushing force in main pushing power station appeared unusual increasing and the construction had to be interrupted. Through the analytical comparison between theoretical and practical pushing curves as well as the analytical comparison between the tool pipe track and the form map of pipeline resting in soil, it was found that the excessive pushing force in main pushing power station was caused by excessive deviation adjustment angle which enabled the pipeline to over bend in a short distance.

在宁波市北渡－雅戈尔原水D1800mm钢管复线工程顶管施工中，出现主顶动力站顶力异常增大的现象，影响继续顶进施工，文章针对这一情况进行分析研究，通过理论顶力曲线与实际顶力曲线以及工具管所经轨迹与管道在土层中静止时的形态图的分析比较，得出主顶动力站顶力过大是因为在纠偏过程中纠偏角度过大，使管道在短距离内过度弯曲引起的。

EXCLUSIONS 4 In no case shall this insurance cover 4.1 loss damage or expense attributable to wilful misconduct of the Assured 4.2 ordinary leakage, ordinary loss in weight or volume, or ordinary wear and tear of the subject-matter insured 4.3 loss damage or expense caused by insufficiency or unsuitability of packing or preparation of the subject-matter insured (for the purpose of this clause 4.3 "packing" shall be deemed to include stowage in a container or liftvan but only when such stowage is carried out prior to attachment of this insurance or by the Assured or their servants) 4.4 loss damage or expense caused by inherent vice or nature of the subject-matter insured 4.5 loss damage or expense proximately caused by delay, even though the delay be caused by a risk insured against (except expenses payable under Clause 2 above) 4.6 loss damage or expense arising from insolvency or financial default of the owners managers charterers or operators of the vessel 4.7 deliberate damage to or deliberate destruction of the subject-matter insured or any part thereof by the wrongful act of any person or persons 4.8 loss damage or expense arising from the use of any weapon of war employing atomic or nuclear fission and/or fusion or other like reaction or radioactive force or matter.

EXCLUSIONS 4在任何情况下都不得这个保险 4.1损失损害或费用的原因故意的不当行为的保证 4.2普通渗漏，普通的损失重量或体积，或普通磨损的标的物投保 4.3损坏或丢失所造成的费用不足或不适合的包装或准备受保标的物（目的是这一条款4.3 &包装&应视为包括存放在容器或liftvan但只有当这些堆放进行之前扣押保险或担保或其雇员） 4.4损坏或丢失所造成的牺牲固有的副总裁或性质的标的物投保 4.5损坏或损失近牺牲所造成的延误，即使是延迟所造成的风险保险（除费用缴付根据第2段） 4.6损失损害或费用所产生的破产或财务预设的业主管理人员承租人或经营者的船只 4.7故意损坏或蓄意破坏受保标的物或其任何部分的不法行为，任何人 4.8损失损害或费用的使用中出现的任何战争武器的使用原子或核裂变和/或融合或其他类似反应或放射性武力或事项。

Gold nucleic acid drinks poured force one listed on the good taste, easy to absorb, the effect of the exact characteristics of the broad masses of customers, especially by middle-aged and elderly of all ages. In 2004, the Company also launched the "throwing power gold nucleic acid drinks," the replacement Product --- throwing force oral liquid gold.

泼力金核酸饮品一上市，就以口感好、易吸收、效果确切等特点，受到广大顾客尤其是中老年人的青睐。2004年，本公司又推出了&泼力金核酸饮品&的换代产品---泼力金口服液。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐