查询词典 by force of

The study shows that the longitudinal component of the pressure force is mainly balanced by the vertical eddy frictional term and the lateral component of the pressure force is mainly balanced by the Coriolis force.

研究表明：在磨刀门河口动力平衡中，纵向的主要平衡项为压力项和垂向涡动摩擦项，侧向的主要平衡项为侧向正压力项和科氏力项。

Finally it analyzes the feasibility that using hydromechanics to analyze traffic flow by contrasting various characters between traffic flow and fluid flow. It analyzes influence of road alignment to basic expressway segment capacity by hydromechanics, and obtains viscous resistance and viscous movement differential equation when the vehicle drives on circular curve segment of expressway. And it infers that viscous resistance is correlated with sideway force coefficient, slope of crown and radius of circular curve. Radius of circular curve, sideway force coefficient and slope of crown are bigger, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on nearside lane of circular curve; but radius of circular curve and sideway force coefficient are bigger, slope of crown is smaller, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on fast lane of circular curve.

最后通过对比交通流与流体流的相似性，运用流体力学分析了道路线形对快速路基本路段通行能力的影响，求出了车辆在曲线路段的粘性阻力，建立了车辆在曲线路段的粘性运动微分方程，并由此推知，粘性阻力与横向力系数、路拱横坡度和圆曲线半径都有关系，当车辆在圆曲线外侧车道上行驶时，圆曲线半径、横向力系数和路拱横坡度越大，粘性阻力就越小，对道路的通行能力影响就越小；而当车辆在圆曲线内侧车道上行驶时，圆曲线半径和横向力系数越大，路拱横坡度越小，粘性阻力就越小，对道路的通行能力影响就越小。

The rheological character of a polymer often appears as shear-thinning. Most polymers behaviour in a solution can be explained by the polymer chain or hard sphere theory. Other than that, shear-thickening polymer solution also exists. Its behavior can be explained by dilatant theory, which suggests that the shear-thickening of the solution is due to the swelling of the polymer particles. This phenomenon often occurs in suspension or emulsion. Solution exhibits a mixed behavior can also be found whose behavior is such that shear-thinning occurs under low shear force and shear-thickening occurs under high shear force. Under this circumstance, the viscosity versus shear force graph exhibits a spoon shaped curve. The rheological study can be applied to the dispersion of paint which can predict the dispersion effect of various polymer materials in solution.

中文摘要一般高分子聚合物溶液的流变行为多半呈现剪稀(shear-thinning)的现象，而大部分的高分子在溶液中的行为是以分子链或是硬球观点来解释，另外也有剪稠(shear-thickening)现象的高分子溶液，其流变行为则是以膨胀体观点来解释，即在高剪切力下，由於高分子团体积变大而使溶液黏度升高，这在悬伏液、乳液等常见；但也有在低剪切力下，溶液具有剪稀的行为，而在高剪切力下却成现剪稠的行为，在黏度对剪切力作图时，会呈现出一个勾形曲线的图形；流变行为的探讨可应用在涂布材料的分散技术上，以推测不同的高分子溶液对分散效果的影响。

In this paper the conflicting discussion of scholastic view-point on seepage force which has lasted many years is stated. Then the physical concept of seepage force and its related forces including the resolved two components (a seepage force and a buoyant force) from seepage resultant force, the transformation between the seepage force and boundary pore water pressures, schematic diagram of forces acting on unit soil mass and the mathematic proof by Green theorem are described.

追述了多年来对渗透力学术观点的争论，并再就此问题论述了渗透力的物理概念及其与之相关的各力（包括渗流作用合力及其分解成的两个分力，渗透力与周边孔隙水压力的转换关系及各力作用在单位土体的图示；从数学上引用格林公式，证明土体表面水压力与土体本身渗透力之间的转换关系。

The control principle of electrostatic shaping was introduced according to the balance between electrostatic force and resulting force formed by membrane deformation and the complex shaping process of SMEC. Then, taking the trisection circularity electrode for an example, the distribution characteristic of electric potential in the electrostatic field was analyzed, namely, the expression of potential function in the electrostatic field was deduced by Laplacian equation. And then, by combining the difference equation with electric potential expression, the numerical solutions of electrostatic force in single electrode mode and trisection circularity electrode mode were disposed.

根据静电力与薄膜变形载荷作用力之间的平衡关系和静电拉伸薄膜反射镜成形的复杂过程，介绍了薄膜反射镜静电成形的控制原理；以三等分环状电极为例，分析了静电场中空间电势分布特性，即从拉普拉斯方程推导出静态场势函数的表达式；然后，利用差分与电势方程结合的方法，对单电极电场力和三等分环状电极电场力进行了数值求解；最后，将计算面形与理想抛物面进行了比较，结果显示，单电极情况下得到的薄膜反射镜面形不是理想抛物面，若采用多电极控制可获得更高的控制精度。

The recovery and displacement efficiency of the matrix block dominated by capillary force is compared with that domonated by the couple of capillary and viscous force, and by viscous force.

在驱动压力和毛管压力的不同平衡(驱动压力和毛管压力的相对大小)关系下的水驱油采收率和水驱油效率的变化规律

The shredding of agro-residues, such as corn stalk, straw, wood sawdust and other herbaceous biomass, were investigated in this dissertation. According to the machinery mechanics of shredding, the components, shearing strength and pressive strength of the biomass were analysed in theory, which played a critical role during the shredding process. And the powder was examined by Scanning Electron Microscopy. It was founded that shearing,splitting and grinding force were appropriate for shredding biomass. The results also showed that primary shredding was the bulk shredding model, which was mainly affected by shearing and splitting force, therefore the curly knife and the straight knife were useful; while the fine shredding was the surface shredding model, affected by splitting and grinding force, and the straight knife useful.

本文以农林废弃生物质为研究对象，结合机械力破碎基础理论，从影响其破碎的化学组分和剪切强度、抗压强度等力学角度进行了理论研究，并运用扫描显微镜对破碎产物的微观结构进行了实际分析，结合二者得出如下结论：最适合生物质的施力方式为剪切力、劈碎力和磨削力；生物质粗破碎为体积破碎，主要受剪切力和劈碎力作用，刀片宜设计成弯口刀和单面直刃刀；细破碎为表面破碎，主要受剪切力和磨削力作用，刀片宜设计成双面直刃刀。

The earth is a complicated system, and it has been continuously moving differentiating and evolving since it had been formed. Not only has the earth layering structure, but it has vertical movement of materials. The movement is prompted by the mechanism of force and heat of the centrifugal force to be formed by the rotation and revolution of the earth, and difference of temperature, pressure, density, viscosity and velocity in the between core and mantle, and radioactive heat, et al. The expressive means of the mechanism of force and heat are the precesses of mantle plume and mantle fluid. Not only are ore-materials of core and mantle carried directly into crust, but ore-materials of crust are activated and accumulated into proper location by the mantle fluid having the supercritical nature.

地球是一个复杂的系统，自形成以来，一直处于不停地运动、分异和演化过程；它不仅存在着圈层结构，而且伴随其自转和公转的离心力，以及核幔间的温度差、压力差、密度差、粘度差、速度差和放射性蜕变热等动热机制，同时存在着以地幔柱和地幔流体作用方式的物质垂向运动；这一过程，不仅直接向地壳带入核幔成矿物质，而且通过流体自身的超临界性质，将沿途活化已有初步富集的成矿物质转移至地壳适宜部位集中成矿。

In this thesis, the influence of column force, joint hoop reinforcement, and repeat load on the stress and sheer bearing capability of inclined pressure bar is analyzed utilizing finite element software. In the case study, the column axial force's influence on the inclined pressure bar's equivalent width, stress and sheer bearing capability of RCFEN is obtained by changing the column force when modeling the RCFEN with ANSYS. In the former model, the joint hoop reinforcement influence on the equivalent width inclined pressure bar and the strength of RCFEN is achieved by changing the quantity of joint hoop reinforcement; the inclined pressure bar's equivalent width and the strength variation of RCFEN under cyclic load are gained by applying low frequency cyclic load on the inflection point of column and the middle of beam.

针对上述算例中的框架外节点采用ANSYS进行建模，运用有限元软件分析了柱轴力、节点箍筋、反复荷载对外节点斜压杆承载力、抗剪承载力的影响：改变柱轴力，研究了柱轴力对斜压杆的等效宽度、框架外节点斜压杆承载力、框架外节点斜压杆抗剪承载力的影响；在上述模型中，改变节点箍筋的数量，分析了节点箍筋对斜压杆的等效宽度、框架外节点强度的影响；在上述模型中，在柱反弯点和梁中点均进行低周反复加载，讨论了在反复荷载作用下，框架外节点的斜压杆的等效宽度、框架外节点强度的变化情况。

The method divides block along the intersection edge of joint faces and neglects the vertical shear force between dividing-blocks i.e. takes horizontal normal force and shear force into account; as to an assumed sliding direction, by satisfying vertical force equilibrium of every dividing-block and whole force equilibrium in the sliding direction, the factor of stability can be solved.

基于此，提出分块极限平衡分析法，该方法沿非临空面交棱将块体进行分块，在忽略分块间的垂向剪力（即可考虑分块间的水平法向力和剪切力）前提下，通过满足各分块的垂向力平衡和滑动方向上的总体力平衡，求解特定滑动方向的稳定系数。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。