查询词典 by error

The computer simulated sampling points with different grid cell sizes were generated and then interpolated into 10000 points with inverse distance weighted. Finally, the original value was compared with the interpolated value for the same grid cell to find the sampling error, and optimal sampling points were determined according to the allowable sampling error.

利用计算机按照不同的网格单元尺寸(如3×3，5×5，7×7等)进行采样，之后利用采样值进行IDW插值处理，将数据点恢复到原始的10000个，并把插值结果与原始值进行比较即可得到采样误差。

Examinations of steady status and analysis of dynamic experiments have been conducted on Band-Tube evaporator and Parallel-Flow condenser using R134a refrigerant. The steady examination show that the model error was under the allowable error, The inlet mass and enthalpy disturb experiments indicate that the subsection model ,be good at reflecting the change of parameters of the heat exchanger, accord with the basic principle of thermodynamics theory and the actual work status.

在进行仿真试验时，以使用R134a作制冷剂的管带式蒸发器和平行流式冷凝器为对象，完成了稳态仿真计算、试验和动态仿真分析，稳态计算结果和试验数据对比表明，其误差在允许范围内；进口质量和焓值的扰动试验结果表明：本文所建的区段式换热器仿真模型，能很好的反映换热器性能参数的动态变化，与系统热动力学理论和冷凝器、蒸发器的实际工作过程基本一致。

To reduce the large numerical dispersion error for the alternating direction implicit finite-difference time-domain method, an isotropic ADI-FDTD method with low numerical dispersion error was presented.

针对交替方向隐式时域有限差分方法数值色散严重的缺点，提出了一种低数值色散的各向同性ADI-FDTD方法。

On the base of Elastic Mechanics, theory of offset error is founded through analyzing the main origin of error and its amenability in the course of experiment.

通过分析模拟试验过程中的主要误差来源及其可控性，以弹性力学为基础，建立了相似材料模拟试验的误差补偿理论。

Comprehensively making use of the basic theory, such as Space Analytic Geometry, Gear Meshing Engagement Theory, Method of Mathematical Calculation, Theory for Error Analyzing and Data Processing, the author has established the mathematical models of the new method, which has included the analytic mathematical model for precision orientation, the mathematical model for the ball's diameter and the measuring diameter, the mathematical model about the ball's centre, the calculation model for tooth alignment diviations and the model for tooth alignment error evaluation.

本文综合应用空间解析几何学、啮合原理、计算方法、误差理论与数据处理等有关基础理论，推导建立了新方法的数学模型，包括：确定定位关系的解析法数学模型，测球直径与测量半径的数学模型，测球球心的数学模型，齿向偏差的计算模型以及齿向误差的评定数学模型等。

According to the theory of electromagnetic field and the theory of error a nalysis,the far field condition for antenna test is discussed,the influence of limited test distance on antenna far field measurement in a microwave anechoic chamber is analysed, and the error model is established.

利用电磁场和误差分析理论，在阐述天线远场测量条件的基础上，分析了微波暗室有限测试距离对天线远场测量的影响，建立了误差模型，并结合实例说明了微波暗室有限测试距离对天线场强测量、增益测量的影响。

Based on Rice fading channel, and taking the effect of bit error rate of the angle of elevation of satellite coverage into account, A bit error rate formula and computer simulation figures are given.

以莱斯衰落信道为基础，考虑卫星覆盖仰角对误码率的影响，推导了误码率的解析表达式。

It is given that the connection between interception probability and orbit intersection angle as well as time error under the instance that the main body of objective satellite is destroyed. The choice of orbit intersection angle is expatiated when time error exists by simulation calculation.

研究了对目标卫星主体毁伤情况下，轨道交角和交会时间偏差与拦截卫星拦截概率之间的关系；阐述了有一定交会时间偏差时，轨道交角的选择情况，并对其进行了仿真计算。

As one of Form-Position Errors, Positional Error does not only control single item but also Form Errors such as perpendicularity, parallelism, angularity, straightness. This paper studies the theory and technique of Error Separation.

在形位误差中位置度误差在控制单个要素或成组要素位置精度的同时，还综合控制了垂直度、平行度、倾斜度、直线度等误差项目，因此本论文重点研究讨论误差分离理论和分离技术在位置度误差评定中的应用。

And based on the deformation method, an error model of the virtual human anthropometry was proposed, and a new method of the skin deformation was proposed, based on the anthropometry error model constraints.

利用Barr以及NFFD算法实现虚拟人的四肢皮肤变形，提出了人体测量学数据的误差分析模型，并在此基础上提出了一种满足误差精度要求的人体皮肤变形方法。

Liapunov—Schmidt method is one of the most important method in the bifurcation theory.

Liapunov—Schmidt方法是分叉理论的最重要方法之一。

Be courteous -- even when people are most discourteous to you .

要有礼貌──即使当別人对你最不礼貌的时候。