查询词典 burble angle

The Go moved backward with 1.35mm and upward with 1.90mm in group I, the gonial angle increased for 3.69°, and angle between palatal plane and mandibular plane was increased for 5.00°; In group II, the Go moved backward with 1.85mm and upward with 3.32mm , the gonial angle increased for 4.06°, and angle between palatal plane and mandibular plane was increased for 5.22°. Both in group I and II, there was a tread for clockwise rotation of mandibular corpus. The length of pterygomasseteric sling was mild increased due to the backward movement of Go.

在Go点的变动方面，在Me点向前位移的族群里，术后Go点平均向后1.35mm，向上1.90mm， gonial angle 平均增大3.69度，腭平面与下颚平面的夹角则是增加5.00度；在Me点向后位移的族群里，术后Go点平均向后1.85mm，向上3.32mm， gonial angle 平均增大4.06度，腭平面与下颚平面的夹角则是增加5.22度，不论是向前或是向后的族群，结果皆显示翼咀嚼肌悬吊带有轻微被拉长的迹象。

Result: All the patients were treated percutaneous reduction and obtained good resuld except one patient who needs another small incision to help reduction and bone graft. The preoperative X ray film showed that the B hler angle was 12.6°, Gissane angle was 75°. The postoperative X ray film demonstrated that B hler angle was 38.5°, Gissane angle was 114.5°.

结果： 14侧手术顺利，达到或接近解剖复位，1侧由于中间骨折块未能达到复位要求，辅助小切口复位骨折块。14侧B hler角由术前12.6°增加到38.5°，Gissane角由术前的75°增加到术后的114.5°，手术前、后差异有统计学意义（P.01）。

RESULTS:①There was higher tensile stress at the ingual side of symphysis, inside of molar and outside of condyle under the impact of chin.②There was higher tensile stress at the lingual side of symphysis, inside of contralateral molar, outside of contralateral angle, outside of homolateral angle and inside of homolateral body under the impact of body.③There was higher tensile stress at the inside of angle, inside of homolateral condyle, lingual side of symphysis, outside of contralateral condyle and inside of homolateral molar under the impact of angle.

结果：①撞击颏部，其舌侧区，磨牙后区内侧面、髁状突颈外表面以及下颌角外表面具有较高的张应力；②撞击下颌体部，颏部舌侧区，对侧磨牙后区内侧面、对侧下颌角外表面、撞击侧下颌角外侧面、撞击侧体部内侧面具有较高的张应力；③撞击下颌角，其内侧面、撞击侧髁状突颈内侧面、颏部舌侧面、对侧髁状突颈外表面以及撞击侧磨牙后区内侧面具有较高的张应力。

The maximum of the L/D appear at about 30-degree angle of attack. The bugle of the reentry module drops the trim angle. Pyrochemistry reaction largen Ca, Cn, diminish L/D and the trim angle. The variational tendency of aerodynamic characters with angle of attack in high altitude (higher than 105km) is different from that of in low altitude (lower than 105km).

返回舱凸出物使配平攻角减小；高温热、化学非平衡效应使轴向力和法向力系数有所增大，升阻比在数值上有所减小，配平攻角略有降低；返回舱0°～180°攻角范围内的气动力特性高空(105km以上)随攻角的变化趋势与低空(105km以下)的变化趋势不同。

Lateral roentgenograms of the lumbar spine and the hip joint were obtained in the upright position to determine pelvic inclination, sacral slope angle, lumbar lordotic angle (L1-L5), disc angle of L5/S1, and pelvic angle (by Jackson's method).

所有病例都拍摄了竖立位腰椎和髋关节侧位片，从而确定他们的骨盆倾斜度、骶骨倾斜角、腰椎前凸角（L1－L5）、L5/S1椎间盘成角和盆腔角。

In the soft tissue measurements, the value of soft tissue facial angle and B'-Pos-FH in the first extraction group was less than those in the second extraction group significantly. After treatment all the patients had an increase in S-Ns-Pos angle, soft tissue facial angle, B'-Pos-FH and depth of mentolabial groove. At the same time, soft tissue convexity angle was diminished obviously. But the change was not significant between the two premolar extraction groups.

2在对软组织项目的测量中，治疗前第一前磨牙拔除组的软组织面角、颏沟倾角均小于第二前磨牙拔除组，治疗后2组均出现软组织面凸角减少，颏凸角、软组织面角、颏沟倾角、颏唇沟深度增加；但2组在各项测量项目的变化上无显著组间差别。

The strew length of prefixed point was 41.84 mm, the screw angle with panes lateralis was 69.41°, the screw angle with inferior verticular plane of panes lateralis was 22.67°; the length of postfixed point was 42.28 mm, the angle with panes lateralis was 68.45°, the angle with inferior verticular plane of panes lateralis was 20.79°. Of the 60 nails drilled, two were drilled out of the post facies articularis of calcaneous, the accuracy rate was 97.67%.

其前点螺钉平均长度为41.84 mm，与跟骨外侧面平均呈69.41°、与跟骨外侧面的底垂面平均呈22.67°；后点螺钉平均长度为42.28 mm，与跟骨外侧面平均呈68.45°、与跟骨外侧面的底垂面平均呈20.79°；30足60枚钢针有2枚钻出跟骨后关节面，钻人安全率为97.67%。

3In the normal space tensile,after controling the influence of density, the variation ofmicrofibril angle had a decisive effect on L MOE and longitudinal tensile strength of D333A wood microtome section; the Correlation coefficient between microfibril angle and L MOE became significant at 0.05 level for D1123A wood microtome section; the Correlation coefficients were all unsignificant between microfibril angle and L MOE and between microfibril angle and longitu- dinal tensile strength to D1223A wood microtome section.

正常间距拉伸中，控制密度的影响后，微纤丝角的变化对D333A组微切片纵向MOE和抗拉强度的变化起着决定性作用；对D1123A组微切片纵向MOE的相关系数达到0.05水平上显著；对D1223A组微切片纵向MOE和抗拉强度都成负相关关系，但都达不到显著水平。

As the forward velocity increasing, the windrowing angle would be decreased, but the effect of forward velocity on windrowing distance was not obvious. The windrowing angle and distance of multiple sugarcane stalks would be smaller than those of single sugarcane stalk, but the maximum range of windrowing angle and distance of multiple sugarcane stalks would be greater than those of single sugarcane stalk. In order to sugarcane stalks outward windrowing, holding height must be within ±100mm of height of sugarcane mass center. As holding height increasing, the windrowing distance would be decreased, but the effect of holding height on windrowing angle was not obvious.

随着夹持输送装置输送速度的增大，甘蔗铺放角和甘蔗铺放距离也随着增大，随着机车前进速度的增大，甘蔗铺放角是减小的，而前进速度对甘蔗的铺放距离影响不大；多根甘蔗的铺放角和铺放距离要比单根甘蔗小，铺放角和铺放距离最大极差要比单根甘蔗大；入口夹持点高度应在甘蔗质心高度±100mm范围内为宜，以保证甘蔗能向机车外侧铺放，随夹持高度的增加，甘蔗质心位于夹持点下方的距离增大，甘蔗铺放距离减小，而夹持高度对甘蔗铺放角影响不大。

Because of this, it is usual to specify the lead angle on the worm, which is the complement of the worm helix angle, and the helix angle on the gear; the two angles are equal for a 90-deg. Shaft angle.

正因为如此，它通常指定牵头角度对蠕虫，它是相辅相成的蠕虫螺旋角，螺旋角对齿轮；两个角度来看都是平等的，为90摄氏度。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。