查询词典 bridge circuit

This control system includes main control model, current detection, position sensing, fault detection and protection, serial interface. Anisomerous bridge topology structure is adopted to design the power converters and driver circuit. Double closed loop based on velocity and current is adopted to control AC-motor.

其控制电路主要包括主控模块、电流检测模块、位置传感器模块、串口电路、故障检测和保护电路等；采用不对称桥式扑结构设计了功率变换器及其驱动电路模块；采用速度和电流双闭环的形式，完成对交流电机的控制。

The results can be expressed as follows:(1) With the increase of water phase content, the amine salt aggregated orderly in different forms such as W/O micro-emulsion, nodus-knot catenulate aggregates, layer liquid crystal and O/W micro-emulsion.(2) In layer liquid crystal, SO〓 mainly combined with amine salt cation by two oxygen atoms in bridge.(3) In UV-VIS spectrum of layer L. C., there is an absorption about 500 nm and "light short circuit"appeared about 430 nm. These phenomena may be very important for measuring the distance between the layers of the L.

研究发现该体系随水相含量的增加，胺盐发生不同形式的有序缔合，分别形成了W/O型微乳液、&节-结&型链状缔合体、层状液晶和O/W型微乳液：在层状液晶中，SO〓主要以桥式双齿配位形式存在，中性胺分子有利于体系中液晶的形成；层状液晶于500nm波长处有一吸收峰，在430nm附近发生&光短路&现象，该现象可能对测定层状液晶的层间距有重要意义。

For electric power pulsive shipping, the voltage is not always normal, especially when the main motor is starting, and three-phase bridge commutated circuit is used widely, so, a new method to compute harmonic is developed, which is more accurate and practical, is more adapt to the ship condictions.

因此，本文在上述文献的基础上，对接入电压波形畸变的电网中的三相桥式整流电路进行了分析，采用了一种实用的新方法来计算三相桥式整流器所产生的谐波电流。本方法考虑了交流侧电抗及电网中存在的谐波电压，导出了交直流两侧谐波电流的计算公式。

The reasons of the measuring errorness from the resistance of couducting wire in full and half bridge measuring system are analyzed,and according to the results ,a compensation circuit for sensors suppling voltage is presented.

分析了全桥和半桥式应变测量电路中导线电阻引起测量误差的原因，并根据分析结果提出了一种传感器供桥电压自动补偿电路，以消除导线电阻引起的测量误差。

The commutating circuit is composed of diode commutating bridge.

整流电路由二极管整流桥组成。

For bridge network system, some methods, such as the binomial expanding method, the network system decompounding method and the minimum circuit method, are used to analyze the system reliability in this paper. The excellences and disadvantages of the above methods are also discussed.

本论文首先就桥式网络系统，分别采用了二项式展开法、网络系统分解法、最小路集法对其系统可靠性进行了分析，并给出了各种方法的优缺点。

A half-bridge bi-directional current mode high frequency inverter was proposed, and the problem of unequal voltage of capacitance in this circuit can be resolved by adding a balance coil.

提出了半桥双向电流源高频链逆变器的拓扑结构，并对电路固有的电容电压不平衡问题提出了解决方法，采用平衡绕组可以彻底解决电容电压不平衡。

The method of design high frequency transformer in half bridge inverter circuit is introduced exampled in detail,besides temperature rise and power loss are discussed.

依据一个半桥逆变电路的实例详细介绍了高频变压器设计的一般方法和步骤，并讨论变压器损耗和温升问题。

There are requirements for connection orders of the inlet wires of three-phase full bridge SCR welding power source when its main circuit adopts Y/△ connection and synchronous transformer adopts Y/Y connection.

主电路为Y/△接法，同步变压器为Y/Y接法的三相全桥晶闸管焊接电源对电源三相进线接入顺序有要求。

A new three-phase AC voltage-regulating AC circuit which use thyristor three-phase bridge controlled rectifier as three-phase symmetrical Y connection is presented.

提出了一种用晶闸管三相全控整流电路用作三相Y接对称性电阻性负载进行的三相交流调压电路，此调压电路由晶闸管三相全控整流电路改造而成，并分析了工作原理，给出了实验结果。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。