查询词典 bridge circuit

In other words, the bridge is used to connect multiple segments of a single logical circuit.

换而言之，网桥的作用是连接单个逻辑电路中的多个网段。

Direct effect on the pressure distribution in the diaphragm, sensitive resistors sensitive patch on the bridge, using the huygens stearns piezoresistive effect achieved pressure strength to signal conversion, through the subsequent circuit will sensitive components of millivolt signal disposal for industrial standard signal amplifier.

传感器膜片及壳体材料具有不同的介质兼容性，用户应考虑被测介质的种类、杂质含量、浓度、温度等条件对压力测量产生的影响，选择合适的防护材料和测量结构。外壳接地端必须接地良好，接地电阻符合相关电气规范

In the design of the power supply, the main circuit topology frame uses half-bridge series resonant switching and parallel load connection, in which, an IGBT is adopted as the power switches, and features high operation frequency, high output power and fast response. In addition, the IGBT in the switch mode power supply has no hard turn-on or turn –off situation in transition, thus the disturbance to the power system is avoided.

相应的激光电源采用半桥软开关技术，串联谐振并联输出，IGBT 为主控制元件，实现了高频工作、高功率多路输出，响应快速；脉冲模式工作时避免了开关管的硬开关，减小了高次谐波对电网的干扰；无需镇流电阻也可实现气体稳定放电等特性。

In the design of the power supply, the main circuit topology frame uses full-bridge series resonant switching and parallel load connection, in which, four MOSFETs are adopted as the power switches, and by four pulses which UC3879 produces, high frequency operation and fast response are realized. In addition, the MOSFET in the switching power supply has no hard turn-on or turn-off situation in transition, thus the disturbance to the power system is avoided. Especially,by the use of high frequency transformer, PQ50/50, the switching power system can provide the steady discharge current without any amperite.

此开关电源采用全桥软开关技术、串联谐振并联输出，四个MOSFET管为主控制开关元件，通过脉冲产生电路UC3879产生的四路相关脉冲实现了高频交替开关，同时能快速响应输出的各种变化；避免了开关管的硬开关，提高了转换效率，另外通过采用高频变压器PQ50/50隔离了原副边，减小了高次谐波对电网干扰；无需镇流电阻也可实现气体稳定放电。

Focusing on the normal inverter's dynamic characteristics which can not satisfy the requirement of reducing current quickly before the time of rupturing of the bridge, a new current wave controlling method for short circuit transfer CO 2 welding using satiable inductor is put forward in this paper.

本文针对普通CO2焊逆变电源的动态性能不能满足短路过渡CO2焊波控方法的要求，焊接电源难以实现在液桥爆断前迅速减小电流的问题，提出了一种在波控方法中采用可饱和电感作为CO2逆变焊机续流电感的方案。

The PV system only consists of a single phase full-bridge pulse width modulation inverter with an auxiliary LC series resonance circuit. DC power generated by the solar cells can be converted into AC power and fed to the utility line.

本系统利用四组全桥式直到交流转换器，配合一组LC串连滤波电路，即可将太阳电池所产生之直流电能转换成交流电送入电力系统中。

ABSTRACT :This paper presents a novel passive snubber circuit suitable for inverter bridge leg modules.

提出一种适用于逆变桥臂模块的吸收电路。

The novel UHV-FTRTPS is composed of uncontrolled rectifier, H bridge inverter, step-up transformer and series resonant circuit.

整个装置由不可控整流电路、H桥逆变电路、升压变压器及串联谐振电路组成。

The theoretical analysis and simulation results of 1kW 40~60VDC/380VDC full-bridge Boost mode two-input DC-DC converter have shown that the converter has the advantages such as double isolation among multiple input sources and between output and input of the converter, simple topology, strong voltage matching ability, multiple input sources can supply the power simultaneously or individually, small input current ripple, high power density, high conversion efficiency, high reliability at short circuit, magnetic flux of high-frequency transformer easy to add up etc.

1kW 40～60VDC/380VDC全桥Boost型双输入直流变换器的理论分析和仿真结果表明，这种变换器具有多路输入源之间以及输出与输入源之间双隔离、电路拓扑简洁、电压匹配能力强、多路输入源可同时或分时供电、输入电流纹波小、功率密度高、变换效率高、负载短路时可靠性高、高频变压器磁通易于叠加等优点。

The structural of mechanism adopted double pipes feed-in with mixing machine, special weighbridge for reducing bond; The hardware circuit make use of the programmable amplifier AD8555 which amplify the weak sensor signal and bridge imbalance compensation and gain error, at the same time,32-bit microprocessor LPC2134 was used as the core of the hardware to deal with the messages and send order to the implement machine. Software design transmits materiel by stages and FIR filter was adopted to remove big errors and enhance precision.

机械结构使用双管螺旋喂料机加搅拌机构，特殊的称斗结构；硬件电路采用数字可编程放大器AD8555作为称重传感器微弱电信号的放大器，以便于补偿桥式传感器的失调和增益误差，同时采用32位单片微处理器LPC2134作为整个电路的处理核心，及时处理称重信息，并向执行机构发送命令；软件根据称重值采取分阶段喂料，并加入了FIR软件滤波，滤除了粗大误差信号，提高了称重精度。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。