查询词典 breaking stress

The results showed that the hardness and breaking stress of gels were not influenced by increasing pressurization time.

结果表明，延长加压时间未对凝胶的硬度和破断应力造成影响。

It was found that the breaking stress decreased with decrease of molecular weight and degree of macromolecular orientation.

研究结果表明，本文工艺条件下研制的PDS缝线在体外降解过程中随着分子量和大分子取向程度下降，力学性能明显下降，4星期时强度基本消失。

On the basis of the experiments, the breaking stress near the hole is obtained by interpolation.

规范所指的边缘强度指的也是板边，对孔边是否也适用还有待商榷。

The ratio of the breaking stress of a structure to the estimated maximum stress in ordinary use.

间断压力同最大压力的比率。

The two process parameters slightly influence the shear breaking stress.

两种工艺参数均对接头的剪切破断应力影响不大。

And the results indicated that the breaking stress parameters of the Arundo donax L.

结果表明，芦竹破坏应力参数接近毛竹，远大于玉米、小麦等茎秆的破坏应力参数，芦竹的机械化收割不宜采用传统的切割器。

The results show that bovine serum albuminrejection ratio and breaking stress of the composite membrane are 86.67％ and 4.70 MPa,which are improved greatly compared to those 3.27％ and 3.35 MPa of the pure PVDF membranes.

结果表明复合膜的性能与纯PVDF膜的相比有显著的改善，其中对牛血清白蛋白的截留率从 3.27%提高到86.67%，单根纤维的断裂应力从3.35MPa提高到4.70MPa ，提高了40.3%。

The true resistivity of formations computed precisely by using of the inversion technique, the interactive processing technique can be applied to structural explanation of formations, analysis for stability of wellbore, prediction of the breaking stress of formations and the deliverability, and the judgment of stress direction of formations.

利用反演技术求准地层真电阻率，利用人机交互处理技术进行地层构造解释，井眼稳定性分析及地层破裂压力预测、产能预测，进行了地层应力方向的判断。

The electropinning parameters (voltage, concentration and C-SD) influenced the mechanical properties of electrospun nylon 6 fiber mats. With increase of the solution concentration, the breaking stress and strain of the mat became large. The effect of C-SD was contrary. The nylon 6 fiber mat electrospun on the high voltage had low elongation but high strength.

静电纺尼龙6纤维毡的断裂强度和断裂伸长率随着浓度的增加都有增加的趋势；随着电压的增加，其断裂强度先减小后增大，断裂伸长率随电压增加而降低；断裂强度、断裂伸长率和断裂比功随着C-SD的增加都有减小的趋势。

RESULTS: SEM results showed that the fiber morphology of P(50/50) 6% nanofibers membrance was better and more uniform diameter distribution. Mechanic test indicated nanofibers membrance of P(50/50) had longer breaking elongation but smaller breaking stress than nanofibers membrance of P(75/25). Hydrophilicity of P(75/25) fibers was better. MTT results proved that 6% and 8% P(50/50) nanofibers could enhance the adhesion and proliferation of endothelial cells on the surface of materials, and the cells had the best spreading and attachment on the nanofibers.

结果：通过扫描电镜观察发现由质量分数为6%聚(50/50)制备的纤维膜具有更好的纤维形态，且直径分布均匀；拉伸力学测试显示由聚(50/50)制备的纤维膜比聚(75/25)具有更高的断裂伸长率，但断裂应力较低；细胞生物相容性实验表明猪髋动脉内皮细胞在质量分数为6%和8%聚(50/50)的纳米纤维膜上更能有效的黏附与增殖。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。