查询词典 brazed

In this paper, Si_3N_4 ceramics were brazed with different thickness Ag-Cu-Ti alloy, and effects of weld thickness on the joint strength were investigated.

采用不同厚度的Ag-Cu-Ti钎料连接 Si3N4陶瓷材料，研究了钎缝厚度对连接强度的影响规律，利用扫描电镜观察了接头微观结构。

The main structures in the brazed seam are Cu and Ag solid solutions.

钎缝组织主要为Cu的固溶体与Ag的固溶体。

The analysis function of MSC-MARC programs on the contact problems is introduced, and the simulation method of forming processes of quadruple-layer brazed steel tubes is also discussed in the article.

在四层卷焊管成形过程的模拟中，最关键的是接触问题的处理。

Immediately after fluxing, the parts to be brazed should be assembled.

焊剂涂敷后，应该立即进行铜焊组装。

After laser order scan research, some new assume are advanced on order distributing of grit in brazed monolayer diamond wheel.

在激光有序扫描钎焊的基础上，提出了有关钎焊金刚石砂轮磨粒有序的一些新设想。

A core drill bit consists of a steel tube with diamond segments brazed or laser welded on the drilling end.

核心钻头由一钢管或激光焊接金刚石钎环节就完钻。

All S. E. Shires trumpets feature a one piece, hand hammered bell with a traditionally brazed seam, hand-lapped Monel pistons, and of course the careful assembly and handcrafted methods that the S.

所有的S.E.Shires小号使用一片铜手工打造的传统黄铜焊接Bell，铜镍合金活塞，秉承S.E。

Properties of vacuum brazed Si3N4/steel Joint using active brazing filler metal.

活性钎料真空钎焊Si3/N4钢接头性能的研究。

The remelting temperature of 1Cr18Ni9Ti stainless steel joint brazed with the nickelbase filler metals is investigated by the use of both the microstructure analysis and the differential thermal analysis.

在钎焊过程中，熔化的钎料与不锈钢相互作用，使得焊后钎缝的成分不同于所用钎料的成分，钎缝的重熔温度也不同于钎料的熔点。

Stress concentration zones and the maximum value of thermal stress of the TiC cermet/iron joint brazed with Ag-Cu-Zn filler metal during cooling were studied in this paper.

本文研究了采用Ag-Cu-Zn钎料在1173K温度下钎焊TiC金属陶瓷与铸铁挺柱实际件时，在冷却过程中接头处的应力集中区和热应力最大值。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。