查询词典 boundary surface

In fact, it may work so well in black-box mode that users don't concern themselves about the internals; that is, until it starts returning NaNs, or the interpolated surface looks bad close to the boundary, or maybe it looks bad overall.

在返回NANS或得到非常不好的插值曲面前，它会以黑匣子方式工作得很好，而不需要用户去了解其内涵。

Experimental study and numerical simulation about turbulent boundary layer drag reduction of riblets surface were carried out for increasing voyage and speed of vehicle.

针对航行器提高航程和航速的需要，开展脊状表面湍流边界层减阻的实验和数值仿真研究。

Based upon the new explanation of the structure of turbulent boundary layer and the fact that specially designed non-smooth surface can reduce fluid drag,the authors have designed and fabricated the Riblets Drag Reduction Film.

作者根据湍流附面层结构新的解释及非光滑特殊造型表面可以减小流体阻力的事实，作者研制了微肋条减阻薄膜，贴在赛船上参加比赛，获得好成绩[1、2 ] 。

At three Reynolds numbers, a thermal anemometry IFA3oo is used to measure the average-velocity and time-sequence pulse velocity at different y+ points in the wtulent boundary layer on smooth as well as riblets plate surface respectively.

在三个雷诺数下，分别对二维流场的光滑壁面和沟槽壁面湍流边界层，用热线风速议作了试验。

Assuming fluid is and viscid and slightly compressible, bubble collapse near rigid boundary and free surface is simulated, displaying characteristics such as formation, penetration and impact of reentrant jet as well as vortex ring and bubble rebound.

采用粘性、微可压流体模型，数值模拟了空泡在刚性边界和自由面附近溃灭及空泡溃灭后流动的发展，显示了空泡溃灭过程中的凹陷射流形成、空泡贯穿、射流冲击、涡环的形成和空泡回弹等流动特征，提出空泡回弹的另一种机制是凹陷射流冲击形成的旋涡。

Based on the characteristics of phasing switch, the dielectric recovery characteristics for short gap vacuum arc were discussed, a vapor density model was applied under the special boundary conditions to get some relations between arcing time and the surface temperature, vapor density.

讨论了真空短间隙及其对应的短燃弧时间对相控真空开关介质恢复特性的影响，应用金属蒸汽密度模型和不同的间隙边界条件，得到燃弧时间与电极表面温度、金属蒸汽密度的关系。

The boundary condition that the surface of the crust is kept at a constant temperature of 25℃, leads to relatively less obvious variation of temperature in the underground no deeper than 2 kilometers, so that the calculated strain rate is less than 10〓(normal geological strain rate is 10〓～10〓).

由于地表的边界效应，在深度小于2km的地壳里，温度变化相对不急剧，一般不出现大于10〓应变速率(典型的地质应变速率为10〓～10〓)。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

The top part of the table has a synthetic surface, which is framed by Rules (a side boundary of metal with a height of approximately 20 cm).

台面的顶部有合成材料的表面，由尺板（高大约为20 cm的金属边界）围成框体。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。