查询词典 boundary point

Aimed at the problem of choosing the initial value when the Newton method is used to compute the controlling unstable equilibrium point, a practical and rigorous solving scheme was presented: by identifying the controlling load bus of the given fault, and using the Thevenin equivalent circuit to represent the rest of the system at the state of the post disturbance stable equilibrium point, using the steady equivalent circuit to represent the induction motor in composite load, and then using the torque characteristics of induction motor, a point near the CUEP is gained to be the initial value. The second order normal forms was used to approximate the stable manifold of CUEP, and the local approximating boundary of the region of attraction of the post disturbance stable equilibrium point was gained. Then just by simulating the state of the system at the fault clearing time, the transient voltage stability of the system could be determined.

针对采用牛顿法求取故障后系统主导不稳定平衡点(controlling unstable equilibrium point，CUEP)存在的初值选取难题，提出一种实用但不失严谨的解决方案：通过识别给定故障的主导负荷母线，对主导负荷母线以外系统由故障后稳定平衡点处的状态进行戴维南等值，对负荷中感应电动机部分采用其稳态等值电路，再由感应电动机的转矩特性求得CUEP附近的一个点作为近似的CUEP，以此为迭代初值可靠求得CUEP；采用二阶正规型来近似CUEP的稳定流形的方法求得近似的局部吸引域边界；由仿真得到故障清除时刻系统的状态并根据该状态是否位于吸引域内判断系统的暂态电压稳定性。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

For a continuous map of trees or graphs to itself, we show the properties that every isolated chain recurrent point is an eventually periodic point, and an isolated chain recurrent point which is not in the orbit of a critical point and has no critical point in its orbit is a periodic point.

第三章主要讨论一些特殊连续统上连续自映射的孤立链回归点与最终周期点之间的关系，证明了对树或图上连续自映射，孤立链回归点是最终周期的，且如孤立链回归点不在临界点的轨道中，也无临界点在其轨道中，则此点必为周期的。

Resistance to Earth magic by an amount equal to your skill in Earth and lasts one hour per point of skill. 1 point resistance per point of skill 2 points resistance per point of skill 3 points resistance per point of skill 4 points resistance per point of skill P

每提高一个土魔法等级可以增加1点防御值每提高一个土魔法等级可以增加2点防御值每提高一个土魔法等级可以增加3点防御值每提高一个土魔法等级可以增加4点防御值 P

Results show that floes' VC and D at the surface water were closely related to current velocity; and the peaks of VC lag those of the current velocity. The lag variation during ebb and flood tides is 10-30min and 30-50 min, respectively. Current velocity at 50 cm/s is a turning point of D vs. vertical average current velocity, before the point, Dm increases with current velocity, and decreases after the point. Similarly, VC at 75μl/L becomes a critical point in the surface water, below the point, D increases with VC, and above the point, D stabilizes.Δp is D dependent, larger floes have much lower Δp than smaller floes. Both D and Δp of floes affect ω. In the surface water during spring tide and neap tide, a power exponent relationship exists between Δp and D, and ω and D.

研究表明：①长江口徐六泾表层絮凝体体积浓度主要受水流流速影响，再悬浮现象明显，体积浓度过程线滞后流速过程线，落潮期间滞后10-30min，涨潮则滞后30-50min；②小于一定流速时絮凝体平均粒径随流速增大而增大，大于一定流速时絮凝体平均粒径则随流速增大而减小，徐六泾夫、小潮表层絮凝体在50cm/s的垂线平均流速时出现平均粒径与垂线平均流速关系的转折；③徐六注大、小潮表层絮凝体平均粒径在体积浓度75μl/L时出现平均粒径与体积浓度关系的转折，体积浓度小于75μl/L时粒径随体积浓度增加而增大，超过75μl/L时粒径随体积浓度的增加变化不明显；④絮凝体有效密度由粒径大小控制，粒径大，有效密度小，反之亦然，粒径和有效密度共同决定絮凝体静水沉速，有效密度和沉速与平均粒径之间均存在良好的幂指数关系。

The critical point means such a state that all the differences between gas and liquid disappear completely,being a most important parameter of dividing the types of fluid and being widely verified in both theory and practice.Currently,four methods of determining critical point are summarized as follows:①laboratory measurement through examining critical opalescence or recording the bubble point and dew point curves;②empiric relation;③calculation of the bubble point and dew point curves by PVT software;and ④ direct calculation according to thermodynamic theories.

随后对临界点进行确定，临界点是气液一切性质差异均消失的状态，是区分流体类型最重要的参数，并得到了理论和工程应用的广泛验证，目前确定临界点大致有四种方法：①实验测定，通过观察临界乳光现象或记录流体的泡点和露点线；②经验关系式；③通过PVT软件计算流体的泡点和露点线；④利用热力学理论直接计算。

Distance from the origin point to O point was (1.84±0.69)cm,unharmful separation point to O point was (0.05±0.12)cm,muscle entry point to O point was (4.35±0.12)cm.

结果 桡神经旋后肌支数为2.6±0.52，其自然分支处距O点(1.84±0.69)cm，干支分离后分支距O点(0.05±0.12)cm，入肌点距O点(4.35±0.12)cm。

On the base of Lord Kelvin point-source solution, the integral of Bessel function, Poisson superimpose formula and boundary element method, we resolve it and obtain the boundary element basic solution.

受求解方法局限性的限制，目前经典渗流力学理论还无法精确求解复杂外边界油藏中生产井层部分射孔问题。

The existence of solutions for multi-point boundary value problem with p-Laplacian operator is investigated by using monotone iterative method, h is proved that boundary value problem has at least one positive solution under suitable conditions.

研究带p-Laplace算子的非线性微分方程的多点边值问题解的存在性，应用单调迭代，给出了这类边值问题存在解的充分条件，还给出了向正解靠近的单调集。

The distance between a boundary point and its neighboring boundary points is used to detect the transitional points.

面对如此大量的数据如何提高数据的利用率是后序产品造型工作面临的严峻问题之一。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。