查询词典 boundary layer

For the 3D human body and garment modeling and surface fitting, a human body database and a three-layer feature model are set up based on the human body measurement data. The class inheritance relations of human body are established according to three-layer feature model: object layer, feature layer and geometry layer.

对于三维人体和服装的建模与曲面拟合，设计了基于人体采集数据的人体数据库，建立了人体的对象层、特征层与几何层三层特征模型，并结合三层特征模型建立了人体类的继承关系。

RESULTS: In the retinal region without light, the structure of every layer was clear, cells in neuroepithelial layer arrayed in rule, some bubble presented in external granular layer and internal granular layer, RPE cells were compact, and the color of pigment article was coincident. In the region with direct blue light and that with 30J/cm2+Acrysof one-piece/ pMMlA, cells on photoreceptor and external granular layer were lost partially, bubble increased, RPE cells were with different sizes, and cell edema, cell lost and pigment article cluster could be seen.. In region with 30J/cm2+Natural, a little disorganization could be seen comparing to that without light, but more normal than those with Acrysof and direct eradia tion.

结果：未照射部位：视网膜各层次结构清晰，神经上皮层内各细胞排列规则，整齐，RPE细胞排列紧密均匀，色素颜色一致；单独光照和透过Acrysof一片式I0L：光感受器层部分细胞丢失，外核层可见固缩核，浓密，内颗粒层细胞大量丢失，内丛状层内空泡明显增多，RPE表面，细胞大小不均，可见肿胀、缺失，细胞内色素浓密、聚集成块；透过Nat-ural一片：与未照射处相比，视网膜各层次结构仍有部分破坏，但程度明显减轻。

The thin film transistor may include: a gate insulting layer; a gate electrode formed on the gate insulating layer; a channel layer formed on the gate insulating layer; and source and drain electrodes that contact the channel layer.

具体而言，薄膜晶体管可以包括：栅绝缘层；形成在栅绝缘层上的栅电极；形成在栅绝缘层上的沟道层；以及接触沟道层的源和漏电极。

Removable copper shielding layer and semiconductive layer: measure 55mm copper shielding layer with gloved finger end, and peel it off; and then measure 20mm semiconductive layer from the end of copper shielding layer and peel it off.

4剥铜屏蔽层和半导电层：由手套指端量取55mm 铜屏蔽层，其余剥支；从铜屏蔽层端量取20mm 半导电层，其余剥去。

The effects of electroplated Ni layer and electroless plated Ni-P layer on the diffusion behavior in Sn-Ag/Cu solder joint were studied. The results by EPMA analysis showed that the electroless plated Ni-P layer acted as a good diffusion barrier between Sn-Ag solder and Cu substrate. However, the electroplated Ni layer can not hinder the inter-diffusion and reaction between molten Sn-Ag solder and Cu substrate when reflowing, and there was a layer of IMC (Cu6Sn5) at interface of Sn-Ag/C u solder joint.

摘 要：研究了电镀Ni层和化学镀Ni-P合金层对Sn-Ag/Cu焊点扩散行为的影响，电子探针分析表明：化学镀Ni-P合金层能很好地阻止Sn-Ag/Cu焊点在焊接过程中的Cu，Sn互扩散和相互反应；而电镀Ni层则不能阻止Sn-Ag/Cu焊点在焊接过程中的Cu，Sn互扩散和相互反应，界面反应产物仍以Cu6Sn5为主。

Initial boundary value problem of two dimensional unsteady diffusion equations is solved in this paper. By using time-dependent fundamental solution of two dimensional diffusion equations and the extension of double layer potential, we establish virtual boundary integral expression of diffusion equations. Then virtual boundary element method is used to implement the numerical computation.

本文在求解二维非定常扩散方程的初边值问题时，利用二维扩散方程与时间有关的基本解，基于双层位势的延拓，建立二维扩散方程的虚边界积分表达式，然后利用虚边界元法进行数值计算。

The mean velocity distributions in turbulent boundary layers of smooth surface and two different riblet surfaces are measured with IFA300 constant-temperature anemometer in low-speed wind tunnel to validate the full development of turbulent boundary laye. Friction velocity and wall friction stress of turbulent boundary layer are obtained with the least-squares fitted curve of the sublayer velocity distribution based on Spalding formula, and virtual origin position of riblet surface can be acquired accurately.

在低速风洞中来流速度一定的情况下使用IFA300恒温热线风速仪测量了光滑表面和两种不同尺寸的脊状表面湍流边界层平均速度分布剖面，并验证了试验段湍流发展的充分性；通过应用Spalding壁面公式使用最小二乘法精准拟合了实验测量的边界层内层速度分布曲线，得到了湍流边界层壁面摩擦速度并进一步求得湍流壁面摩擦应力，较准确地计算出脊状表面的虚拟原点位置，并通过与对数律公式拟合结果比较分析，证实了该方法更加准确有效。

This method allows for a more accurate processing of boundary condition on the semiconductor layer in XLPE cable of stator winding than the standard finite element, so that the interlaminated issue of boundary condition on interface can be avoided. A general algorithm is applied to deal with both the Dirichlet and the periodic boundary condition in 2D or 3D magnetic field problem.

提出了用有限元法计算磁场问题时周期性边界条件和第一类边界条件的统一处理方法，利用该方法在不改变代数方程组阶数、保持系数矩阵性质不变和带宽基本不变的条件下，使两种强加边界条件能同时处理，简化了程序编制，并与寻址方法相结合，提高了计算速度。

The concentration of D-phenylalanine in the external phase and the separation factorαcan be expressed as: The diffusion of boundary layer in outer aqueous phase is the controlled process while the concentration of D-phenylalanine in the external phase far less than the concentration of chiral carrier in the emulsion liquid membrane phase, then the diffusion coefficient k_e of boundary layer in outer aqueous phase can be achieved by data fitting.

外水相苯丙氨酸对映体的浓度以及分离因子α表示为：当外相对映体浓度远小于液膜相手性载体浓度时，该手性传质过程中外相边界层的扩散为控制步骤，利用数据拟合得到了外水相与液膜相界面边界层扩散的传质系数k_e。

In this paper the defect of the traditionary boundary layer methods (including the method of matched asymptotic expansions and the method of Visik-Lyusternik) is noted, from those methods we cannot construct the asymptotic expansion of boundary layer term really.

本文指出传统的边界层方法包括匹配法和Vi(？ik—Lyusternik方法的不足：不能作出边界层项的渐近展开式。提出多重尺度构造边界层项的方法，得到符合实情的结果。

Objective:To explore the feasibility of laparoscopy in diagnosing and treating of abdominal diseases.

目的：探讨腹腔镜用以诊断腹部外科疾病及选择治疗方案的可行性。

The lifetime of nylon 1010 and nylon 1010/POSS composites decreased with increasing temperature.

热重-红外联用分析表明尼龙1010在氮气气氛下的降解产物主要为小分子的低聚物，POSS并不改变尼龙1010降解产物的组成。